Question about Cars & Trucks

Open Question

Iam looking for n new spray unit ? - Cars & Trucks

Posted by on

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

How to install the spring clip on 2000 Galant gas door


not sure but dont quote me as i could be wrong here but i think its a complete unit .Sorry but i repair so many makes of vehicle i just cannot remember them all ,have a good look first as yes it may be possible to fit a new spring or a sprung loaded clip but ?¿? just iam getting old and the old memory isnt what it was

Feb 28, 2015 | 2000 Mitsubishi Galant

1 Answer

Lumina misfiring when hot.


Folks what iam about to say can be taken to the bank read this about a mass air flow sensor

any garage will in/out with old no matter what!

this is what to do get a can of electrical cleaner from any auto parts joint and (nothing but electrical cleaner) make sure it says good for auto ele now take the parts off on the luminas you have to take a few things off on these but worth it as a new one can set you back here in canada 352.00 not cheap but i have done at least 100 of these in 10 years.

anyway once apart have a look insode (keep your paws off anything inside it) you WILL BLOW IT IF YOU DO) THIS SAID TAKE YOUR CLEANER AND FROM A BIT OF A DISTANCE SPRAY THE FLUID INTO THIS HAVE A GOOD LOOK BEFORE YOU SPRAY IT YOU WILL SEE SMALL PARTS OF DUST AND STUFF.

now after you have done this take your time and let it evaporate it will (takes a few mins) now if after you look and it looks like there is more dust which these cars are known for because of none looking after then spray it again until all is clean replace everything and i will say for a fact your vehicle will run better then it did before you did this these things will when not working, smother the car out and give a i have no gas feel in it. but try this and take it to the bank your savings and dont forget i dont drink but a hugh five is in order this goes for any vehicle out there sealed unit or not the sealed ones do come apart and can be placed back together the thing with so called techs today is they are told just take out what you think, and put a new one in there this is why your back at the garage 2 days later with the same problem!! think aboout this they forgot to troubleshoot they guessed at what the scanner told them (IT MIGHT BE) AND NOT WHAT IT IS A SCANNER CAN ONLY POINT YOU NOT GIVE YOU ANY CURES PERIOD.

BEEN THERE DONE THAT.

but i was the type who has never just in with the new and out with the old (never) maybe this is why i never made dealerships much $$$$$$ lol and always remember lefty loosy righty tighty

~Dave

Jan 23, 2014 | 1997 Chevrolet Lumina

1 Answer

New Rover engine ignition unit.


this is a old one ,remember the old V8 well ,as when the vacumn unit failed it wouldnt start from cold ,advance timing by twisting distributor and it would start then reset timing and it would run all day but when cold the following day? now iam not sure here but look in the new wire and iam wrong here no doubt but it has two wires and a shroud around them and i think this shroud has a pin connection to earth hence your 3 pins but without my head under the bonnet to confirm i cannot be sure as the old gray matter declines in old age and i havent seen one of these cars in many a year so if iam right just leave shroud connection disconnected .My neighbour has one of these cars laying in the garden at last count its all their but the sun has destroyed the paintwork and the interior but no rot anywhere as this is spain and here their is no rain or very little

Jan 23, 2013 | Land Rover Range Rover Cars & Trucks

1 Answer

My 2001 Hyundai Accent after a really bad snow week here in the Seattle area when it rains it is getting in somewhere from the back and I literally have puddles of water in the back seat feet rest and the...


The rear window is bonded and i suspect this bonding has been damaged by water ingress then freezing and opening the gap even more ,use a hose pipe to have a good look and in the meantime drill a 3/8 hole either side in the rear floorwell to let the water out and to stop the floor fro corroding away ,yes iam expecting a remark from other experts about my methods but you cannot beat a good drain hole in the floor or the spare wheel well .Yes iam a fleet fitter who repairs things and not a dealer lackey unit changer who only fits all new parts to keep their bonus pay up and the boss happy

Mar 21, 2012 | 2001 Hyundai Accent

1 Answer

My 2004 excursion dies when I disconnect the battery. I changed the battery and the alternator, they are both new but stills die. According to me all the fuses and relay are good. What could be wrong?


Most vehicles will run with the battery disconnected with the exception of the renaults so check the voltage across the battery and with engine running it should show 14.7 volts but i do feel that in this case youre alternator isnt any good and i would advise you to return it and let the spares shop have it checked out for you ,I always fit a bosch recon unit from the bosch place as i have found that a lot of so called recon units are not a lot of good ,yes i know i pay more for a bosch unit from the bosch agents but at least i never get come backs.Now i know that iam capable of repairing some units myself and i often do but the problem is a lot of the newer units need a special jig to get them apart and back together again like the AC delco units and often when i do take the brush pack out i find the commutator is worn out and this is no chance of repairing with the tools at my disposal so its a new unit iam afraid to say .

Feb 11, 2012 | Cars & Trucks

1 Answer

Wont start unless spraying gas in intake. will turn over til battery dead. getting spark at coil and pressure in fuel rail. sensors? injectors? computer?


Neither

You may have pressure but do you have 40 or more lbs
cycling the ignition key?

Listen for the fuel pump,Iam guessing it has an issue

Why -- it starts when you spray anything into the throttle
body

Jun 15, 2011 | 2001 Chevrolet Malibu

1 Answer

My car turns off when iam at a stop do u know what the problem is


maybe a dirty intake. get some throttle body cleaner, remove the intake and spray it down good. use a lint free towel to wipe down the intake. open the throttle and spray the butterfly with cleaner also.

Jan 12, 2010 | 1995 Nissan Maxima

1 Answer

Dome light


Spray contact cleaner or similar on button at door for light. Should be on the post probably where door shuts on.May help.

Dec 13, 2008 | 2004 Dodge Neon

1 Answer

Front axle4x4


yes but take valve out and clean most likely there is debri in the valve take of and spray with either se if it works

Sep 28, 2008 | 1987 Jeep Wrangler

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

16 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts

yadayada
yadayada

Level 3 Expert

76673 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22219 Answers

Randy Ohler

Level 3 Expert

14585 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...