Question about Cars & Trucks

Open Question

Where can I buy replacement globe for myFriedland D722 pushlite push 5-8 volts. my post code is 5041

Posted by on


Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

Replace park bulb.vt commodore

To replace the front parklight globe on a vt commodore can be a little tricky.

1.turn the lights on to see which 1 is inoperative once you know turn lights off. bonnet
3.go to side that is inoperative and on the back of the headlight you will see a round large plastic cover turn this to release it.
4.under the headlight globe there will be 2 wires flow these to the park globe socket gently twist and pull it out.
5.once the sockets out and you can see the globe ,pull the globe out of socket.
6.push new globe into socket
7.refit the socket in headlight
8.refit all trims
9.turn lights on make sure new globe is work..

Jan 22, 2014 | Cars & Trucks

1 Answer

1999 dodge durango no bus mil. replaced pcm twice and crank position sensor

make sure ground is good and there is no corrosion at the battery posts or post clamps.

Nov 21, 2013 | 1999 Dodge Durango

1 Answer

Suzuki Swift 2008 continually blows globes

ok globes = lamps?
my ex called them blubbbbs. (funny she was )
the Alternator , has a bad regulator, get a new alternator.
it will fail, in the store, test, ASK THEM to test it.
its putting out 18 to 20 volts and will blow up the ECU/PCM and radio
of you dont stop and fix that now.
make sure the old one is not a clone ALT, and then buy a non clone.
buy a top rebuilt brand.
Napa is always my first stop. (no clone junk, C4 we call it)
sorry im late , i hope i saved you....

Feb 20, 2013 | Suzuki Swift Cars & Trucks

1 Answer

Replace tail light globe holden astra 2005

remove inside black plastic triangle pieces under carpet or service flap light assembly then comes out and you now can get globes out
or some have plastic clips on side of globe holder assembly that you push out while pulling on globe holder assembly depends on what assembly you have

Jan 30, 2013 | 2004 Holden Astra

1 Answer

Code p0700

take a volt meter to the TPS with the ignition on and car off. do a voltage sweep by reading the voltage at idle on the gas pedal and slowly push the gas pedal to the floor. if the sensor is good you should see a steady increase in voltage from around .6 volts to 5 volts.

Jun 04, 2012 | 2000 Dodge Caravan

1 Answer

I cleared codes and replaced map sensor now car idles rough and throws p0068 code

This issue from the start was most likely caused by the throttle position sensor. There is a variable resistor inside the sensor that sends a signal from 1 volt to 5 volts, and is constantly monitored by the PCM. There may be an open signal between th 1 and 5 volt signal when the accelerator pedal is pushed up and down. Check the connection before replacing the sensor.

Jan 16, 2011 | 2004 Dodge Intrepid

1 Answer

The light on the auto shift inside my suzuki sidekick is out, at night you cant see where the reverse or any gear is do i fix this

Sounds like the light globe has failed. To replace globe you will have o remove the cover over the shift lever to gain access to the globe socket. Once you have removed globe, replace it with the same type and wattage (usually 3 to 5 W) and then replace cover.

Jan 07, 2011 | 1997 Suzuki Sidekick

1 Answer

How to replace heahlight bulb in a 1994 Audi What bulb do i purchase? How do i release the clip that holds the light unit in place?

I replaced my globes not so long back.
The metal clip you simply push down. Replacing the left light is challenging as the air intake is in the way but its not impossible. After removing the clip there is a plastic cap. Remove it.
Then remove the cable that feeds power. You should be able to see the rear of the 'globe'. There is another spring loaded metal clip holding the 'globe' in place. Push the two ends of the clip together to remove this clip. The globe should be free now. Remeber the globe go in a specific way, so take note. I bought to Halogen globes for my Audi as these immitted a stronger beam. Please, whatever you do DO NOT TOUCH THE NEW GLOBES GLASS. The natural oil from your fingers will impact the lifespan of these and you'll have to replace these again. Remember to also reallign the beams.

May 26, 2010 | 1994 Audi Cabriolet

1 Answer

How to replace the headlight bulb or fuse .how do you take out the bulb or f;ilament when headlight stops working

1.Find The Cover Of The Lamp In The Engine Bay.
2.Remove The Round Cover Turning It Left To Unscrew
3.Remove Base Holding Light
4.Take Out Light From Base Usually By Turning It Or Pushing It Out Of Its Clip
5.Replace Globe (Be Sure Not To Touch Globe With Dirty Hand's)
6. Reassemble Light

Mar 14, 2010 | 2004 Pontiac Grand Am

1 Answer

I want to check the rear light globes for faulty wiring as my battery is draining constantly. How do i get to the globes, please.

How do you know its the globes? If you really feel thats its them remove the electrical connectors from them and watch the ammeter if it returns to normal replace the globe holders.
To conduct this type of testing,Remove the negative battery cable from its post and connect an ammeter red probe to the negative battery post and the black probe to the negative battery cable. Now start pulling fuses until the voltage on the meter returns to normal. (anything above a half of a volt is too high) The fuse you pulled to get this result is the affected circuit. Now you have to probe it from its B+ source to the load
to find the short. Check all connectors for rust and the line for opens or shorting to ground. Repair accordingly.

Feb 20, 2010 | 1993 Toyota Camry V6

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

12 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts


Level 3 Expert

78238 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22326 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

14405 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides