Question about Cars & Trucks

Open Question

93 gas club car will not go slow - it's full throttle only - when you back off throttle to go slow motor shuts down about half way on pedal

Posted by on


6 Suggested Answers

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

A 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
The service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Good luck!

Posted on Jan 02, 2017

  • 261 Answers

SOURCE: motor bogs down at stoplight when pushin gas pedal

sounds like a typical throttle position sensor problem, ye before you get there check the air filter and make sure that youf fuel is not contaminated it is either your TPS or the air flow meter is going bad both are expensive sorry

Posted on Nov 14, 2008

  • 128 Answers

SOURCE: motor bogs down at stoplight when pushin gas pedal

The fuel pump relay will cause a stalling or no start condition. You are likely having mass airflow sensor, fuel pump, or fuel pressure regulator issues.


Posted on Nov 30, 2008

  • 8 Answers

SOURCE: loud whinning noise when i use gas pedal and slow down !

Replace the IAC valve.

Posted on Feb 03, 2009

  • 188 Answers

SOURCE: car starts hard chugs going down the road

sounds like timing and tuning. or the carb is sticking

Posted on Mar 26, 2009

  • 1 Answer

SOURCE: car bogs with full throttle

Its the Fuel Filter...mine did the same thing :)

Posted on Apr 26, 2009

Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

I have a 2001 club car when you step on the gas pedal the car doesn't always go you have to put the pedal up and down to find the right spot for it to go.

Most likely the throttle positioning sensor has gone bad. Look on the throttle body for an object that has the throttle shaft (or something linked to the throttle mechanism) and has at least three wires attached.

Aug 27, 2017 | Cars & Trucks

2 Answers

Our 2002 Dodge Durango 4.7 when started goes to full throttle 6000 rpm and has to be immediately shut off.

John, first make sure it is not floor mat or carpet holding gas peddle down causing throttle issue. If all looks good there, would suggest you check throttle cable for being seized, throttle body seized or return spring faulty/broke. You may want to contact a good Tech, have them diagnose and estimate repair. Check the attached links,instruction and guides, Good luck
"I hope this helped you out, if so let me know by pressing the helpful button. Check out some of my other posts if you need more tips and info."
Throttle body stuck wide open DodgeForum com
How to Repair Stuck Accelerator Pedal DoItYourself com
Sticking gas pedal fix Saturn Series cars and others sticky gas pedal

Aug 08, 2016 | Dodge Cars & Trucks

1 Answer

Accelerates at full throttle by itself after kick down

gas pedal sensor could be faulty or the ecu is telling to to speed up.

Jul 17, 2014 | 2008 Audi A8

1 Answer

Gas pedal sticks on isuzu trooper

On the next "above freezing" day, force lubricant through the throttle cable and lube all linkage at the engine end and interior.AND BEFORE STARTING for the next while try depressing the gas pedal and make sure it is releasing fully.
If it ever gets stuck again SHUT IT OFF before you damage the engine with high RPM on a cold engine.

May 21, 2017 | 1998 Isuzu Trooper

1 Answer


Engine stalling and rough run issue at low speeds

This problem is commonly caused by a dirty automatic idle speed control valve and throttle valve. Buy a can of throttle valve cleaner (do not use carburetor spray cleaner!) from NAPA or Carquest (made by CRC chemicals) and spray it into the air intake while the engine is running, use up about 1/2 the can, engine will try to stall hold the speed up, shut it down and let it soak for 30 minutes, restart and blow out the remaining fluid, shut it down and disconnect the negative battery cable for 5 Min's to reset the base idle control

Aug 30, 2012 | Cars & Trucks

1 Answer

1993 paseo slows down when gas pedal is at a certain spot

It could possibly be a throttle position sensor that is going bad in one spot. When it gets on one bad spot the ECU will get a signal saying that the throttle is completely closed and cut off fuel.

Jun 20, 2012 | 1993 Toyota Paseo

1 Answer

Car shut down when foot not on the accelerator

For this types of problem,there are few help links.I suggest you to click the link below and go through the troubleshooting procedure :-----Car only starts when gas pedal is pressed? won't start without hitting the gas pedal?
----------Complete loss of brake pedal then all gets normal?
----------Car dies when gas pedal is pressed?
--------------Pushing on the gas pedal, but the car slows down? Gas pedal to the floor and the car slows down?
-------------Idles rough and quits when gas pedal is pressed less? will help.Thanks.

Feb 02, 2012 | 2002 Toyota Camry

2 Answers

How do you adjust the idle on a 93 voyager

There is no idle adjustment, it is controlled electronically by a computer and that in turn controls a part that is called the ISC short for "Idle Speed Control" motor. If the idle is low or you have stalling problems then the system may be full of sludge from the years of service. Clean the ISC and the engines Throttle valve as outlined below, it should correct the problem.

To correct this problem get a can of throttle valve cleaner (it is made by CRC Chemicals) from the local auto parts store, spray it into the air intake of the engine until you have used about half the can, you will need to hold the idle up while you do this, it will try to stall, after this shut the engine down and disconnect the Negative (-) battery cable for 5 minutes. The intake is now clean, if you continue to have the idle speed control problems you may need to seek the help of a professional.

May 03, 2011 | 1993 Plymouth Voyager

1 Answer

My gas pedel gets stuck half way down some times

The throttle position sensor is most likely bad or it just may be the throttle cable but I think it is the Throttle position sensor it is located near the throttle valve follow the throttle cable to the end this is where the throttle valve is and the Throttle position sensor is located near the throttle valve on the opposite side it will have a plug going to it and it is held on with two torx head screws purchase the tools and replace.

Nov 03, 2009 | 1998 Buick Century

1 Answer

Motor bogs down at stoplight when pushin gas pedal

sounds like a typical throttle position sensor problem, ye before you get there check the air filter and make sure that youf fuel is not contaminated it is either your TPS or the air flow meter is going bad both are expensive sorry

Nov 08, 2008 | 1990 Volvo 740

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

34 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts


Level 3 Expert

77932 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22306 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

14403 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides