Question about Cars & Trucks
REPLACING THE LIGHT LICENSE PLATE BULB ON A 2009 MISIBISHI OUTLANDER
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Posted on Jan 02, 2017
SOURCE: License plate bulb replacement
you have to carefully pry the bulb holder out and remove the bulb by turning it counterclockwise while pushing in. Replace the new lightbulb the reverse mode.
Posted on Nov 30, 2008
SOURCE: Light Bulb Replaement
I just replaced the license plate lamps on my 2004 Deville DTS.
Lamp is PC195. Lamp PC168 will also work, (it was in my car for the last two years), but it is a brighter bulb than needed.
You pop out the lamp holders by pushing (sliding)the right side towards the left. That little push will unhook plastic tabs from the sheet metal and the right side of the lamp holder will release from the trunk. See the attached photo.
To push the lamp holder, I used a narrow putty knife covered with masking tape. A screwdriver will work as well. The masking tape protects the paint from scratches.
Posted on Jan 08, 2009
OK>>> it is very cold here, but nonetheless..I went outside to check on my Oldsmobile for your benefit....On mine (I can't guarantee it is the same for all of the vehicles listed above). If you are looking at the license plate, LOOK UP and you should see the bulb and whatever encasing is there. Mine is in a tube and it is attached with (2) mini bolts that will need to come out first, then it just looks like a simple matter of disconnecting the electrical plug, taking out the old bulb and putting the new one in. I hope this helps someone....
Posted on Feb 23, 2009
LICENSE PLATE LAMP BULB
Posted on Oct 08, 2009
1. Open the hatch and stand under it.
2. Remove pull handle from the inside of the hatch (2 screws under pop panels).
3. Starting in the lower corners, gently pry the entire interior panel from the hatch,
and leave it hanging from the wiper area near the glass.
4. Grasp the bulb housing and twist to the left while pressing inward.
5. Replace with a 1156 bulb.
Posted on Nov 01, 2009
Tips for a great answer:
Jan 24, 2016 | Cars & Trucks
Dec 10, 2015 | Ford Cars & Trucks
Aug 30, 2015 | 2001 Toyota Tacoma
Sep 30, 2014 | 2009 Nissan Maxima SV
Aug 09, 2011 | Honda Accord Cars & Trucks
Jan 15, 2011 | 2003 Lincoln Town Car
Dec 06, 2010 | 2002 Jeep Grand Cherokee
Feb 06, 2010 | 2003 Chevrolet Impala
Jan 13, 2010 | 1992 Honda Accord
Sep 09, 2009 | 2002 Hyundai Accent
12 people viewed this question
Usually answered in minutes!