Question about Eagle Cars & Trucks

Open Question

Can i move engine back on 2010 dixie chopper iron eagle to make belts tighter?

Posted by on


3 Suggested Answers

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.

Posted on Jan 02, 2017

  • 1381 Answers

SOURCE: Reverse on my Dixie chopper zee1 won't go in reverse

it could be jammed, which could prevent it from shifting your vehicle into reverse. Look for any dirt, debris or sticky residue near the "reverse" setting, and carefully clean it out.
A vehicle that won't go in reverse is often an indication of a transmission problem, and transmission repair can be rather expensive. If you would like to try a more affordable possibility before assuming that there is something seriously wrong with your car, then you should check your vehicle's transmission fluid levels. This should be done while your vehicle is running and in park or neutral, and you should simply remove the dipstick, clean it with a clean rag, reinsert it and check the fill line on the dipstick. If you find that your transmission fluid is low, try topping it off - you might just find that your vehicle will reverse perfectly if you do.
Or you could have major transmission have serious transmission problems that will need to be repaired by a professional transmission repair shop.

Posted on Jun 02, 2016

  • 46460 Answers

SOURCE: My Dixie chopper classic 2750 won't crank it turns on but it won't turn over it just makes the beeping noise. What's the problem?

start by looking at the starter or solenoid .then safety circuit could be you forgot the PTO button

Posted on Aug 20, 2016

Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

I ran my dixie chopper out of gas , now it won't start. Any suggestions?

Take the air cleaner off an pour a very little bit of gas into the carb and it will help prime the system and get the gas pumping again.

May 21, 2017 | Cars & Trucks

1 Answer

I need to know the socket size to fit the lug nuts on a Dixie chopper magnum225023 x 10150-12

We don't know what size. So how about try all socket that you have. Or measure the nut and go buy it.

Good luck


May 16, 2017 | Cars & Trucks

1 Answer

Dixie Chopper zero turn mower will not start.

check or by pass the parking brake sw. it is on the same circuit.

May 13, 2017 | Seat Cars & Trucks

1 Answer

How do I change hour tracker on a Dixie Chopper 2250 Magnum?

You dont. That would be the same as resetting the odometer on a car.

Nov 01, 2016 | Cars & Trucks

1 Answer

Car does not start with serpentine belt on, but starts when serpentine belt is off.

Make sure that your tensioner is able to swing freely and not get stuck. With the belt on you should be able to pull on the belt and see that the tensioner moves and returns. Make sure that as the engine cranks the belt isn't getting tighter due to bad tensioner preventing engine from starting.

Feb 25, 2013 | 1995 Chevrolet Corsica

1 Answer

The tension on the timing belt won't loosen to be put back on and i dont know the timing mark.

These belt are a little difficult to do. They remain tight and you end up rolling the belt on to install. Once it is on and in place, then adjust a little tighter with the tensioner.

May 28, 2010 | 1995 Eagle Talon

1 Answer

Seat belt locked wont pull out

Check if the roll is in the right position,untight the bolt and move it back and forvard a little and pull the belt gently at the same time,if you are lucky it might come loose.

Jul 25, 2009 | 2005 Jeep Grand Cherokee

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

13 people viewed this question

Ask a Question

Usually answered in minutes!

Top Eagle Experts


Level 3 Expert

76848 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22246 Answers

Stewart Dibbs

Level 2 Expert

322 Answers

Are you an Eagle Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides