Question about Isuzu Trooper
A 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
The service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Posted on Jan 02, 2017
they are very easy to replace .
all you need to do is go to autozone and get the right parts.
then you will find the old parts on the exhaust system.
unplug the first one you find and unscrew it from the exhaust and refit the proper replacment part.plug wire back in.thats all you will need to do on the second one also.after that your done.ask auto zone after that to reset your codes for free with the code checker.then get a can of carb cleaner and spray out the throttle body of all the black carbon around the throttle plate.use a clean rag only.make sure its clean around the plate.
thewn fill your gas tank with supperunlead dont get the crappy gas any more cause it causes the carbon to build up.plus you will get better gas mileage.now your ready for an inspection sticker.
hope this helps
keep me posted
Posted on Jul 20, 2009
bank one sensor 1 is the bank of cylinders that number 1 spark plug is located in, bank 2 the other side, this assumes u have a V8, the sensor one location is the sensors that are BEFORE THE CATALYTIC CONVERTER, the sensors referred to as sensor 2 are after the ones AFTER THE CATALYTIC CONVERTER IN THE EXHAUST SYSTEM.
Posted on Apr 28, 2010
Grand Cherokee oxygen sensor locations for 4.0
and 4.7 engines
Four wires (circuits) are used on each O2 sensor:
O2S Sensor removal Never apply any type of grease to the oxygen sensor electrical connector, or attempt any soldering of the sensor wiring harness.
WARNING: THE EXHAUST MANIFOLD, EXHAUST PIPES AND CATALYTIC CONVERTER(S) BECOME VERY HOT DURING ENGINE OPERATION. ALLOW ENGINE TO COOL BEFORE REMOVING OXYGEN SENSOR.
1. Raise and support vehicle.
2. Disconnect O2S pigtail harness from main wiring harness.
3. If equipped, disconnect sensor wire harness mounting clips from engine or body.
CAUTION: When disconnecting sensor electrical connector, do not pull directly on wire going into sensor.
4. Remove O2S sensor with an oxygen sensor removal and installation tool.
02S Sensor installation
Threads of new oxygen sensors are factory coated with anti-seize compound to aid in removal. DO NOT add any additional anti-seize compound to threads of a new oxygen sensor.
1. Install O2S sensor. Tighten to 22 ft. lbs. (30 N·m) torque.
2. Connect O2S sensor wire connector to main wiring harness.
3. If equipped, connect sensor wire harness mounting clips to engine or body. When Equipped: The O2S pigtail harness must be clipped and/or bolted back to their original positions on engine or body to prevent mechanical damage to wiring.
Hope thats help (remember comment and rated this).
Posted on Apr 29, 2010
Tips for a great answer:
Jul 25, 2016 | Isuzu Cars & Trucks
Jun 17, 2015 | Cars & Trucks
Jul 15, 2011 | 1996 Nissan Maxima
Feb 16, 2011 | 2004 Ford Taurus
Nov 15, 2010 | 2001 Isuzu Trooper
Jul 14, 2010 | Isuzu Trooper Cars & Trucks
Mar 22, 2010 | 2002 Kia Sedona
17 people viewed this question
Usually answered in minutes!
Step 2: Please assign your manual to a product: