Question about Cars & Trucks

1 Answer

What is the root cause of code 8pn 3251 after treatment 1 particulate trap differential psi

Posted by on

Ad

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Sergeant:

    An expert that has over 500 points.

  • Expert
  • 213 Answers

On what?

Posted on May 02, 2017

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Fault code p00200 particulate trap efficiency below threshold what is wrong


sounds like the particulate filter is blocked it needs replacing or cleaning

Dec 15, 2017 | Cars & Trucks

1 Answer

Diesel 2013 kuga shows a miss fire on 1 cylinder when hooked on diagnostic machine show a fault code. When they swap electrical leads to different cylinders same fault code. Any ideas


Check compression on all cylinders. Get injectors checked.

If you also hear a knocking noise at idle, than the injector was defective and damaged the piston. If you discovered this early enough, maybe just fixing the injectors will solve the problem.

If your car has a particulate filter, get it removed along with the EGR valve, as many times this bogus emission control systems can be the root of all problems, but the diagnostic fault codes mislead you.

Dec 11, 2017 | Cars & Trucks

1 Answer

Need to fix my 2007 Dodge Ram 3500 dually,6.7 Cummings diesel, check engine light code P2002


P2002 - Diesel Particulate Filter Efficiency Below Threshold (Bank 1)
Description: The powertrain control module(PCM) monitors the efficiency of the diesel particulate filter for a concern. The efficiency of the filter is determined by the amount of restriction in the filter for a certain exhaust flow rate. The diesel particulate filter is preconditioned for 5,000 km (3,107 miles) before the PCM begins to monitor the level of restriction. The test fails when the measured level of restriction is less than the expected level calculated by the PCM. Possible Causes:
  • Dirty air cleaner element
  • Recent manual or thorough diesel particulate filter regeneration
  • Aftermarket accessories and performance modifications
  • Modified tailpipe
  • Exhaust leaks before or near the diesel particulate filter pressure sensor
  • Leaks in the diesel particulate filter pressure sensor connecting hose
  • Damaged diesel particulate filter
Diagnostic Aids: Check for leaks in the exhaust system. Check for aftermarket exhaust accessories and performance modifications that decrease the exhaust restriction. If a new diesel particulate filter was recently installed, verify the diesel particulate filter parameter reset procedure was carried out.

Feb 18, 2015 | Dodge Cars & Trucks

1 Answer

Mazda bongo engine light it's on did diagnosis got p2002


code p2002 refers to the particulate trap, bank 1--efficiency below threshold===causes --particulate trap
replace the unit.

May 10, 2014 | Mazda 110 Cars & Trucks

1 Answer

P2002 how to solve indicator ligth on dash board


Error Code:P2002
Description:
DTC P2002 Particulate Trap Efficiency Below Threshold (Bank1)
Possible solutions:
- Perform regeneration process. This process does not always solve the problem or the problem is solved for short term only.
- Remove/ Replace the Dust Particulate filter.
- Exhaust fuel addition INJECTOR ASSEMBLY. (Replace).
- Inspect turbo charger, in any.
- Mass Air Flow sensor.-
- Exhaust manifold convertor sub assembly

Mar 14, 2014 | 2007 Toyota Hi-Ace 220

1 Answer

P2082 particulate mter differential pressure sensor


on some diesels there is what they call a particulate filter in front of the catalytic converter which has a sensor on it to measure when there is too much pressure. that tells them that it is time to do a clean out or replacement of the filter. if a cleanout is an option with yours, you will have to do it at the dealer. it's a process initiated with the factory diagnostic tool where the mixture is leaned out and the idle raised to about 3k for close to a half hour in order to raise the exhaust temperature and clean out the filter

Mar 06, 2013 | Cars & Trucks

1 Answer

Check engine light on


I need the make model and year, and the code number.

Feb 07, 2013 | Cars & Trucks

1 Answer

What does code p2459 mean?


Causes
- Exhaust leak
- Improperly installed or loose Exhaust Gas Temperature (EGT)
- Low engine compression
- Corroed fuel injector
- Water in the fuel system
_ fuel filter or water seperator fouled.
When is the code detected?
The P2459 will set if the Engine Control Module (ECM) detects that the average time between completed regenerations is less than a calibrated threshold.
Symptoms- Engine Light ON (or Service Engine Soon Warning Light)
P2459 Description The particulates in the exhaust gases are collected by the Diesel Particulate Filter (DPF). When the filter becomes saturated with particulates, they are incinerated by a regeneration process. The regeneration process increases the exhaust gas temperature, warning the Diesel Oxidation Catalyst (DOC) first, the warning the DPF. The Engine Control Module (ECM) monitors the system with inputs from two Exhaust Gas Temperature (EGT) sensors 1 and 2 and the exhaust differential pressure sensor.

Read more: http://engine-codes.com/p2459.html#ixzz1xGkI9BsX

Read more: http://engine-codes.com/p2459_gmc.html#ixzz1xGjSKrIa

Jun 09, 2012 | Chevrolet Silverado 2500HD Cars & Trucks

1 Answer

P2002 particulate trap below threshold bank 1 what is the solution


Look in the owners manual on who to do a "forced" or "manual" regeneration, if this does not work, you will need to remove the particulate trap, also called a DPF, and have it cleaned. Contact the nearest Navistar heavy truck dealer to find who can clean the filter.

Aug 15, 2011 | 2008 Ford F-350

2 Answers

The check exhaust filter light came on in my 2007 GMC Sierra truck 2500 duramax. I do not have the owners manual but I know the dealer will just reset the computer in the truck. How can I reset it myself?


There is a procedure for your exhaust system. Its called Diesel Particulate Filter (DPF) Regeneration. Your dealer will have to do this for you. The particulate filter is in the exhaust system. It traps large carbon particulates so they don't get out into the air. The system is designed to take care of itself but does need to be done by someone with a tech2 scanner.

Apr 08, 2010 | 2007 GMC Sierra 2500HD

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

13 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts

yadayada
yadayada

Level 3 Expert

80339 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22326 Answers

john h

Level 3 Expert

15148 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...