Question about Cars & Trucks

Open Question

The weights do not lock in - Cars & Trucks

Posted by on

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Chevrolet captive lt back seats locked in place can not move


check to see if something is jammed against the seat. put your body weight against the seat while pulling the release lever

Jan 02, 2015 | Chevrolet Cars & Trucks

1 Answer

How do i unlock a vw engine


Dependens upon what is lockeds.
It is is locked due to setting do the following.

Remove spark plugs fill cylinders with light weight oil and let set for several days.Turn crank with a long lever. to turn engine over until loose.

Jul 02, 2014 | 1974 Volkswagen Beetle 1.6

1 Answer

4wd will not engage in 4HI, 4LO or Auto 4WD


most of the engine power is designed to go to, the back wheels UNLESS the transfer case is in LOCK position in 4 hi or 4 low..also was the front hubs locked in...some models still use lockouts in front..remember this also.. if most of the weight is up front as it is on pickups, the rear wheels are the least resistance for the power so they will move first unless thers enough weight on top of them say sandbags or firewood or just dead weight...(if the truck is used look under the vehicle to see if the front driveshaft was taken out..some folks do this for fuel economy purposes) good luck repost findings please...thnx

Jan 19, 2013 | 1999 GMC Sierra

1 Answer

How do i lock out the advance weights on a hei distributor


lock them out? No way I know of. I suppose you could remove the weights, but why would you want to? If timed correctly, the weights do not advance timing at idle, only at higher rpm's.

Oct 14, 2012 | Pontiac Firebird Cars & Trucks

1 Answer

Sometime gear stuck in parking mood only.thanks, Frank


if you are on a slope or hard into a gutter and put the vehicle into park there is locking mechanism in the trans called a parking pawl if you have weight against the parking pawl lever such as a slope or into a gutter ,it will be very hard to get out of park because you have all the weight of your vehicle against the lever what you need to do is pull the hand brake on first so the weight of the vehicle is held by the hand brake ,then put it into park problem solved. regards agwbk

Feb 05, 2011 | Suzuki Vitara Cars & Trucks

1 Answer

Key won't release steering wheel and can't turn it on. Tried graphfite to no avail.


The key lock cylinder is probably worn out from years of too many heavy keys on the keychain. The extra weight wears on the tumblers in the lock. The ignition lock cylinder probably needs to be replaced.

Dec 28, 2010 | 1988 Ford Ranger

1 Answer

I have a 2001 pontiac sunfire, and the passengers seat belt is in a locked position and will not let me buckle up. There is NO slack what so ever. I took the seat belt out and went and got another one from...


there is a weight in the base of the seat belt lock that may be stuck. take the cover loose and see if you can push the weight toward the rear of the car. if this works see if there is a chance that the belt lock is leaning forward when tight. when you hit your brakes these weights slide forward and lock the belt they should be tilted the the rear ever so slightly so they return when the car "leans back" hope this helps.

Dec 21, 2010 | Pontiac Sunfire Cars & Trucks

1 Answer

All seat belt retractors now fail to catch when spooled out rapidly in my 1990 Toyota Camry


there is a weight inside those that has to "swing" to lock ,as if you were stopping. Just pulling on them they won't lock up.
Bet they are ok

Aug 21, 2009 | 1990 Toyota Camry

1 Answer

Power back door works with remote, but won't stay open


how are3 the gas cylinders...are they supporting the weight of the hatch?
if there is a leak the cylinder cannot support the weight of the hatch itself causing it to sit back down and lock the hatch again.

Mar 03, 2009 | 2005 Lexus RX330

1 Answer

Rear ends locks when in reverse


Yes, it definitly sounds like a fluid problem. However, did you know that there are different weights of rear end lube for different rear ends? I would advice going to the dealership and asking what weight they show for your rear end. You need to first copy the tag # off the rear end so that they can be sure which one you have.
Bill

Nov 23, 2008 | 1995 Chevrolet Tahoe

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

12 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts

yadayada
yadayada

Level 3 Expert

75822 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Randy Ohler

Level 3 Expert

14585 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...