Question about Cars & Trucks

Open Question

I mean the engine is overalled ,using clutch I mean when I press the clutch pedal time and again the temperature gauge is going up.

Posted by on

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 1596 Answers

SOURCE: when i put into gear and press on the gas and the clutch out the engin revs but the car goes no where.

WITH ENGINE ON & RUNNING and you are able to shift to any & or all Gears and with this theres,
No Clutch Engagement Upon Releasing Clutch
With Info Provided seems that you have 1 or all 3
of the Fallowing and they all Should be Replaced as A Set even if on lt 1 of them has Failed

  1. Clutch Pressure Plate has Failed
  2. Clutch Disc Is Worn Down
  3. Clutch Release Bearing Has Failed
All Require Removal Of Transmission this is the reasoning for Replacing all as SET with the Labor cost if your replace only 1 Item, and 3 Months later another of the 3 components Fail, you have the same Labor cost to PAY.

This Solution is Answering the SOLE Question ask, Barring No other Problems have or did Happen such as Noises Ran out Of Trans Lube. if it is the Clutch that has Failed and you are unable to Perform the Repair yyourself, DO SHOP AROUND get 5 or more Estimates as the Fee Will Vary Sometimes very wide gaps in fee's
and also Try and Purchase the Parts yourself Due to the Tremendous Markup of parts at Shops

I Hope I have Answered you Question to your satisfaction and if you have any more questions Feel free to Ask Me

Posted on Jan 13, 2009

  • 297 Answers

SOURCE: Temperature gauge

Hmm, check your thermostat on correct behaviour, seen this before

Posted on Apr 14, 2009

  • 314 Answers

SOURCE: temperature gauge goes to 3/4,but when i turn the

it could be either one.

Posted on Jun 27, 2009

  • 1146 Answers

SOURCE: 2004 Honda Element...the clutch pedal engaging at 50%

Hi:
You could have a problem with your pressure plate, but you need to check out your clutch master cylinder and slave cylinder too. Check the clutch master cylinder fluid reservoir, and make sure it is full. It is located on the back wall of the engine compartment, approx right in front of your clutch pedal. If it is low, or you notice any fluid leakage, you need to address what caused that. You can bleed the system too, but that won't repair the problem.

Posted on Dec 10, 2009

  • 6 Answers

SOURCE: 2006 4cyl manual 5 speed transmission 30K

Well, there is only one thing I can think of in your situation. Your pressure plates just simply are not creating enough pressure to allow the gears to engage. Either you have a defective clutch and it needs to be replaced, or possibly just needs a ton of adjustment. When you put it in 1st gear while engine is off, then start it and take off that works b/c there is enough pressure to keep the gears from starting to move when not already moving. However when they are already moving, there is just not enough pressure to stop them from turning, not even long enough to shift. Have you tried forcing it into 2,3, or 4 while driving without the clutch? As long as you achieve the correct RPM's your transmission should be able to do so.

Posted on Mar 08, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Hi,my car is a Daewoo lanos,engine overcalled but now problem is when I apply clutch most of the time temperature gauge is going up but when I m not using clutch is not heating.What is the cause?


engine 'overhaul", I take it...you might need to --carefully-- explain exactly what you mean with 'using clutch' and 'not using clutch"..

Apr 21, 2017 | Daewoo Cars & Trucks

1 Answer

Why does my clutch pedal go down whenever the car gets hot


The temperature may have nothing to do with it .. it's probably more a question of time/distance.

Are you losing any clutch fluid? You may have a leak from the clutch master cylinder.

Is there a leak from the clutch slave cylinder?

It may be that the rubber seals in either the master cylinder or the slave cylinder have perished/worn. Usually, it is the clutch slave cylinder that is at fault

Apr 19, 2016 | Cars & Trucks

1 Answer

Trail Blazer 2008 Ls AC Compressor and Engine Temperature gauge goes off. AC and Temperature stop Working


I suggest you take it to a ASE certified repair shop an have it diagnosed .

Feb 21, 2016 | AC Cars & Trucks

2 Answers

My truck keeps over heating after a new radiator and new water pump and new fan clutch and new thermostat and there isn't any water in the oil


Air lock find out where the bleed nipple is and undo carefully if engine hot and wait for the water to stop spitting and hissing ( like a kettle) Top up with water/antifreeze careful to pour slowly to avoid air bubbles accumulating.

Feb 15, 2015 | Cars & Trucks

1 Answer

I tried pedal 3x and now my temp gauge turns on and in the overheat red warning. what should i do?


First you will need to retreive the trouble codes stored in the computer and go from there.

Feb 13, 2013 | 2004 Buick Rendezvous

1 Answer

I drive a 2006 dts which i've had for 1 year. A week after I had the car the temperature gauge went to red when I was in traffic. I took it to cadillac, they replaced the engine,radiator and hoses


Temp is going up, well that doesn't mean anything unless it actually overheats, in traffic it can reach 240 F and present no danger of engine damage. If this is not the case DO NOT DRIVE THIS UNTIL THE PROBLEM IS FOUND AND REPAIRED UNLESS YOU WANT TO BUY ANOTHER ENGINE JOB.

Aug 23, 2012 | 2006 Cadillac DTS

1 Answer

I put a water hose up to the heater core and no water came out the other side does that mean that my heater core is clogged or could it still be a thermostat


Did you put the heater control lever to maximum first as there is usually a tap operated by the control to regulate the flow through the heater radiator core. Try again with the control set to max. If there is still no flow it could mean the wire/cable to the tap is disconnected /broken.Check for correct operation of the tap and if found to be working, the core is probably clogged.
The thermostat controls overall engine temperature and if temperature guage is indicating normally then it can be assumed to be operating correctly. If Temp gauge stays down on the Cold end it could mean that the thermostat is stuck open and not allowing engine to reach full operating temperature which will reduce performance of the heater considerably..

Sep 20, 2010 | Mitsubishi Galant Cars & Trucks

1 Answer

RPM is over 400 rpm higher than it should be with no gas pedal.


Could be several things.. I would suggest replace the neutral safety switch, all O2 sensors and fuel and air filters, PVC valve and if needed plugs n wires..
The issue could also be a bad throttle body.. Should be a good idea to get it hooked up to a diagnostic machine - get the codes and then you will know more of what you are dealing with..

Have a great day !!

Apr 09, 2010 | 2000 Saturn SL

2 Answers

Clutch pedel stuck on floor


The clutch master has blown out

Jan 19, 2010 | 1990 Ford F250

4 Answers

Would like to talk with a car repair guru, not a computer guru


i think you have a combonation of problems here. most of it lead to needing a tune up .
just to get an understanding what is going on in your engine . i would bet to say that your enagine light is on . and probily an engine misfire code.
when the engine misfires somtimes it wil activate your knock sensor and ****** the timing thus raising your engine temp. if you havent flushed your coolant system yet you should. new plugs and wires and clean your throttle body.
good luck

Nov 02, 2008 | 2002 Chevrolet TrailBlazer

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

19 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts

yadayada
yadayada

Level 3 Expert

74945 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Randy Ohler

Level 3 Expert

14585 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...