Question about Cars & Trucks

Open Question

How do i adjust clutch on a 2003 1.4 16v vw polo

Posted by on

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

emissionwiz
  • 75807 Answers

SOURCE: VW Clutch Adjustment polo 2001 Hydrolic or Cable?

This is a hydraulic clutch you can't adjust is.

Posted on Oct 04, 2008

  • 1071 Answers

SOURCE: can you adjust polo rear brakes at the wheels or

hand brake is the only way to adjust them properly you can adjust them at the wheels but you will need to remove the drums then if adjusted too far drums may not go back on

Posted on Aug 19, 2009

  • 1 Answer

SOURCE: clutch pedal box has snapped off its mounting on

1-disconnect battery. 2- remove all lower dash plastic panels. 3- disconnect all plugs on steering coloumn. 4- remove shear bolts on steering coloumn, easy with a long 8" sharp chisel (get 2 x new shear bolts £0.50p each). 5-loosen & remove bolt at steering rack in drivers footwell, mark position of spline before removing this makes it east to refit (tipex). 6- pull steering coloumn out towards you & it will slide off the bush quite easy. 7- loosen clutch cable adjustment & remove cable nipple at pedal. 8-remove clutch pedal. 9- pull brake pedal out of plastic insert, this will break there is no way to remove this without breaking the plastic clip. get a new brake pedal clip insert for a Mk 3 golf £4 its the same (dont let VW sell you a new pedal) 10- remove 5 x nuts holding pedal box to bulkhead/brake servo. 11- cut 2 x cable ties holding throttle wiring & disconnetc plug above heater on drivers side. 12- push/pull brake servo slightly out of bulk head. 13- remove pedal box.
Cause of the problem- The clutch bracket is only held to the pedal box with 2 x spot welds & a 10mm tack on the top corner.
Repair- Fully Weld the clutch bracket to the pedal box. Great repair.
refitting reverse of above.
Duration around 6/8 hours Less if you get the spare parts before you start.
I wasted time trying to remove the brake pedal without breaking the clip impossible to do even with theVW tool. £4 on a new clip is well worth it.

Posted on Feb 22, 2010

smhb1
  • 146 Answers

SOURCE: crankshaft sensor for vw polo where is the

Crankshaft sensor is located on the right side of the cylinder block behind or under the starter. It is fitted into the rear crankshaft oil seal hausing

Posted on Sep 12, 2010

  • 4793 Answers

SOURCE: VW POLO 13 CLUTCH TO HIGH DOES IT MEAN CLUTCH IS

as the clutch is a cable you could try to adjust it(1"play on the pedal)if then it starts to slip you know for sure it gone.....

Posted on Oct 14, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Gear box removal 1998 VW polo


George, Not a lot out there to show removal of Polo tranny. May want to find a manual. Check the attached links,instruction and guides, Good luck
"I hope this helped you out, if so let me know by pressing the helpful button. Check out some of my other posts if you need more tips and info."
VOLKSWAGEN POLO CLUTCH REPLACMENT part1
VW A2 Golf 1 8L Clutch Transmission 020 Removal
Front Wheel Drive car clutch replacement
http://www.repairservicemanuals.com/Volkswagen


Jul 09, 2016 | Cars & Trucks

1 Answer

My Clutch on my V reg VW Polo feel like its lower to the floor than normal, it seems to be stuggling to enter each gear and when it netural growls like its in gear what would you reccomend?


That sounds like an adjustment on your clutch. You have a master cylinder and a slave cylinder. You may need to bleed the system. Not hard to do. Check to see if the master is full and it and the slave aren't leaking first.

Apr 18, 2016 | Cars & Trucks

1 Answer

The clutch peddle on my vw polo is very loose and is hard to get into forward gears and grinds into reverse what could it be ?


Pedal

Your clutch needs adjusting. The information is here. You can also Google
VW Polo clutch adjustment
And click on Videos and you will see tutorials on YouTube.

http://www.vw-resource.com/clutch_adjust.html

Dec 23, 2015 | Cars & Trucks

1 Answer

My vw polo classic 1.6 1998 jerkes when taking of in 1st gear but once in second it runs smoothlly


If you have a 4 or 5 speed transmission, and have to use a clutch, try letting the clutch pedal up more slowly. If it's an automatic, only a mechanic can adjust the problem for you. Sometimes a mechanical non-automatic clutch gets oily or dirty, which can also cause that kind of jerkiness and chatter. See if you can take it to a car wash where they have a lift which can take the car into the air and blow very hot soapy water into the clutch area, to try and clean it of oil, etc.

Sep 19, 2012 | Cars & Trucks

2 Answers

Can i adjust my clutch on a vw polo 1.4 manual


What year is your vw? Some are cable adjusted and others are fixed state depending on year

May 25, 2011 | Volkswagen Polo Cars & Trucks

1 Answer

VW POLO 13 CLUTCH TO HIGH DOES IT MEAN CLUTCH IS ON ITS WAY OUT CHEERS PAT


as the clutch is a cable you could try to adjust it(1"play on the pedal)if then it starts to slip you know for sure it gone.....

Oct 14, 2010 | Volkswagen Polo Cars & Trucks

1 Answer

MY VW POLO SHOWS FAULT CODE ; P0106 ABSOLUTE MANIFOLD PRESSURE SE


this a map sensor, probably just need the sensor replaced, it measurese intake vaccum and adjusts air/fuel mixture accordingly

Oct 07, 2009 | Volkswagen Fox Cars & Trucks

1 Answer

96 vw polo keeps cutting out at low revs


i had same prob. Sorry but im a noob when it comes to car stuff. I think its called the airflow, it just needs cleaning cost me £25 for him to clean it, piece of ****. Hope this helps.

Jun 05, 2009 | 1996 Volkswagen Jetta

1 Answer

VW Clutch Adjustment polo 2001 Hydrolic or Cable?


This is a hydraulic clutch you can't adjust is.

Oct 04, 2008 | 2001 Volkswagen Golf

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

14 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts

yadayada
yadayada

Level 3 Expert

75807 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22133 Answers

Randy Ohler

Level 3 Expert

14585 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...