Question about Cars & Trucks

Open Question

I replaced batteries in remote sensor and temp does not come up.

Posted by on

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

My ptcruiser just cutoff.ignition comes on but starter not responding. Says nofuse .also what's that switch / sensor under battery


could be a simple problem or a expensive one .Might just be a fuse or a relay but it could also be the ignition contact switch ,might even be the wire has come off the starter solonoid ,best advice i can give is to ask a local mechanic .

Jun 22, 2017 | Cars & Trucks

1 Answer

Outside temp suddenly shows -40randomly when it is 80+F out.A/C stops working when guage shows erroneous temp. Replaced ambient sensor, cleaned wires near battery.any other thoughts?


Check or just replace the coolant temp sensor. This sensor will also tell the computer -40 and stop the a/c if bad connection or faulty part.

Jul 15, 2015 | Saturn L-Series Cars & Trucks

1 Answer

On a cold start i have no high idle for warm up


coolant temp sensor and intake air temp sensor would be the next to check.intake air temp sensor is in the air intake tunnel between TB air air box. when running is there a DTC? by disconnecting the coolant temp sensor you put the ecm values at default try that if it corrects your issue replace it.(it will turn your check engine light on but you can clear later by disconnecting battery)

Dec 10, 2013 | 2005 Ford Focus

1 Answer

93 grand cherokee code Battery temp sensor


You need the voltage output tested with a special tool by the dealer or a trusted repair shop.

May 18, 2017 | Dodge Caravan Cars & Trucks

1 Answer

Hello. My 97 Plymouth Grand Voyager's radiator fans are not running when the temperature is up. The fans do work, and I replaced the relay. Could my sensor not be working even if my gauge is reading in the...


could be bad temp sensor or bad wire connection to fan motor. to check fan; get 2 wires long enough to reach from connector plug of fan to battery., put one on hot and the other on ground and check fan motor. if good, then its either a relay or temp sensor or cut wire somewhere between temp sensor and fan motor. check to see if your getting power from battery to sensor/fan

Apr 02, 2011 | 1997 Plymouth Grand Voyager

1 Answer

My garage opener remote on my 2003 santa fe just stopped working. How can I fix it?


There is a battery in the remote.If the battery gets old the remote will stop working.Replace the battery and check.Also if your battery is new but still the problem is there then,try to open the garage door by keeping less distance between remote as well as the garage door.Also there is a sensor in the garage door.If that sensor is not functioning then this can be one issue.In some cases the internal remote circuit gets short,in that case the remote needs replacement.But does the garage door sensor light shows any sign of getting connection from remote when you press the remote button.Open the door and try to close the door with remote and check.As per the problem,in most cases its weak battery related problem,and replacing the battery solves the problem.You can try all the possibilities and see which one helps.Thanks.Helpmech.

Nov 12, 2010 | 2003 Hyundai Santa Fe

2 Answers

Cooling fans on 1994 Caprice classic with 4.3 v8 not coming on. I have replaced the temp sensor on the water pump, temp sensor on the block, all relays, fuses are good, replaced the ecm (engine control...


On a vehicle this age, it is likely that the fans themselves have worn out. Test the fans by running battery power directly to the positive contact. If they start, they are OK. On 4.3 motors, there is also a seperate temp sensor to signal the fans, usually called a fan switch. I believe it operates independent of the ECM. Another possible culprit is a bad ground at the fans or even a loose or corroded negative battery cable.

Jan 26, 2010 | 1994 Chevrolet Caprice Classic

2 Answers

2006 HHR, check engine light came on, the engine coolant temperature gauge stays at 0 and the coolant link on my panel just shows ----F. Also my remote start won't work


Your coolant temp sensor is not registering. It probably set a trouble code, that's why your remote vehicle start is not working. The temp sensor is located at the rear corner of the engine block on the back side of the engine. This will be the corner of the engine closest to the driver. The temp sensor may be faulty, unlugged or there could be problem in the circuit. Even if you find the sensor unplugged and you plug it in, the code will have to be cleared before the remote vehicle start works again.

Oct 03, 2009 | 2006 Chevrolet HHR

2 Answers

I have a 96 eclipse and the check engine and battery light are on, the code it throws is p1493 and p0117 what is wrong with it?


P1493 Battery Temp. Sensor, Low Voltage
P0117 ECT Sensor, Low voltage

Make sure the engine is reaching operating temperature, U may have a problem w/the thermostat, this is code P0117

Have the battery and the Alternator tested for possiable charging system issue, this is code P1493

Oct 14, 2008 | Mitsubishi Eclipse Cars & Trucks

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

15 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts

yadayada
yadayada

Level 3 Expert

76070 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Randy Ohler

Level 3 Expert

14585 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...