Question about Cars & Trucks

Open Question

Why would my 2008 F350 have no electrical power after being stored. Dual batteries charger and installed

Posted by on

Ad

2 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
  • 2841 Answers

SOURCE: how to charge dual batteries

There should be a bridge mounted close to the main battery. Make sure that bridge is on. Now connect your charger to the main battery. This will charge both batteries evenly.

Posted on Nov 09, 2009

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

2 Answers

My 2008 f350 super duty lost power while I was drivng it. What is wrong with it?


How long since a tune-up? Any applicable trouble codes?
Are you saying it went into limp home mode, not much power, or you lost all electricals and it died?
If it is the latter, make sure battery has a full charge and battery connections all good. Check your charging system. Follow one of the positive battery cables, see if it goes to junction block, if so, check fusible links.
Any electrical component that doesn't work, if fuse protected, check that fuse circuit for voltage. Some fuses are hot all the time, some go hot with the key on. Use a test lite.

Jun 11, 2016 | 2008 Ford F-350 Super Duty

1 Answer

Why don't I have juice to dash on 2008 BMW 535 I? I installed an electric water pump and when I try the bleeding procedure their was 0 juice to dash and interior except the start button, which when p


Fairly obvious that you made an error in wiring the electric water pump, and have blown one or more fuses (or may have damaged some wiring).
Disconnect the water pump entirely (for now), and recover your electrical system (check all fuses, breakers, and fusible links).

NOTE THAT THE ELECTRIC WATER PUMP IS A HIGH ELECTRICAL CONSUMPTION MOTOR, AND MUST RECEIVE ITS POWER DIRECTLY FROM THE BATTERY THROUGH A CONTROL RELAY, preferably from the STARTER primary power wire. You will need to use an inline breaker (properly rated for the electrical current rating in AMPS for the electric water pump), and you will need to use a fairly robust relay to turn the water pump on and off with ignition switch power.

If you are unfamiliar with electrical principles related to high-amperage applications in a vehicle, I'd recommend that you refer the installation of your after-market water pump to someone with the necessary experience, so that you do not further damage your vehicle.

Best of luck to you!!

Jul 25, 2014 | 2008 BMW 535i Sedan

1 Answer

The check engine light just came on on my 2008 F350 Super Duty but the system check says everything is ok. How do I reset the light?


you can disconnect the negative battery clamp for 5 minutes to clear the CEL, but if there is something wrong it will eventually come back-the best thing to do is have the OBDII connector scanned (free at most commercial auto parts stores) and report back with the actual code for more thorough help.

Sep 01, 2011 | 2001 Ford F350 Super Duty SuperCab

2 Answers

How to charge dual batteries


connect charger to one battery they are hooked up in series. however you should load test each battery first to locate any faults.

Nov 09, 2009 | 2007 GMC Sierra 3500

1 Answer

Wiring diagram for 2008 f350


You can typically buy a Haynes or Chilton manual from your local parts store for around $20

May 19, 2009 | 2008 Ford F-350

2 Answers

Trailer towing fuses


Battery junction box (BJB) fuse(s):
  • 5 (30A) (trailer electric brake controller)
  • 34 (25A) (trailer tow turn relays)
  • 42 (30A) (trailer tow parking lamps)
  • 44 (30A) (trailer tow battery charge relay switch side)
  • 63 (15A) (trailer tow reversing lamps

Mar 20, 2009 | 2008 Ford F 250 Super Duty 4WD

2 Answers

Battery charger on 2008 Chevrolet Equinox


most chargers have a few different settings you want to put it ona slow charge for about 4-6 hrs bye slow charge I mean it should have a 2amp or a3amp trickle charge unless you are attempting to start the car immeditly the you will you the setting labled starting

Mar 01, 2009 | 2008 Chevrolet Equinox

3 Answers

2001 F350 Charging problems


actually the only thing i can recomend is to have the alternator replace again for warranty and before starting the truck charge the batteries very well with a baterie charger make sure to charge them individually because with a low batterie the alternator has to put a lot of load and might burnt again
specially with dual batterie.

Jun 03, 2008 | 2001 Ford F350 Super Duty SuperCab

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

26 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts

yadayada
yadayada

Level 3 Expert

76682 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22219 Answers

Randy Ohler

Level 3 Expert

14585 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...