Question about Cars & Trucks

Open Question

Where can i find a nexus 3 speed trouble shooting manual

Posted by on

Ad

2 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
  • 72 Answers

SOURCE: Trouble shooting climate control intermitting

GMC has an ongiong problem with the blower motor resistor, look under the dash on the passenger side and you will see the blower housing, unplug the wireing harness that feeds it and look at the plug carefully you will see that the third pin from the left has been over heated and is melted a little. the repair is quick and easy go to your local parts store and purchase a new resistor and a replacement wireing plug, you will have to cut the old plug off and splice the new one in, replace the resistor and your done. I would recomend that the wires be and spliced cut one at a time so as to insure that they are put in the right location.

Posted on Sep 10, 2010

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Ignition trouble shoot


Hey Ron,
AN internal combustion engine requires three (3) things to run...assuming the internals are good.
1. Adequate compression >120PSI
2. A properly timed spark
3. A proper fuel/air ratio

Start with one, and eliminate one at a time(make sure it works) - ..(this is the way a professional would trouble shoot an engine).

Sep 17, 2017 | Cars & Trucks

2 Answers

Im trying to find out where the resistor to the control blower fan speed is located in a 2016 Peterbilt truck so i can replace it, the part # p93caa3100-01s


Have you tried the user manual, have you contacted where you bought the truck from. What about googling your iPad or iPhone. For trouble shooting advice

Oct 29, 2016 | Cars & Trucks

2 Answers

Blower motor for 1994 chevrolet suburban does not work


Is there B+ voltage at the blower motor, ORANGE wire . Is the HTR/A/C Fuse good ? 25 amp .

Bad blower motor or the switch is or there is a wiring problem ! Go to youtube an check out a few videos on testing blower motor circuits , and basic electrical trouble shooting !
Also go to www.bbbind.com for a wiring diagram of the heater blower motor circuit .

Nov 18, 2015 | Chevrolet Cars & Trucks

2 Answers

Can you tow a caravan at low speed in neutral?


yes you can tow the van in neutral nothing will happen why were you towing the van

Mar 09, 2015 | 1997 Dodge Grand Caravan

1 Answer

Trouble shooting manual for hzj75 toyota landcruiser


you will find a trouble shooting section in the workshop manual

Feb 07, 2015 | Toyota Cars & Trucks

1 Answer

Trouble shooting guide for 1998 buick park avenue


it is probably your computer chip that is gone, had the same problem.

Aug 16, 2014 | 1998 Buick Park Avenue

1 Answer

Toyota voxy speed sensor


two things:

1. dont drive the car when engine light signaling....must be a error in engine
2. speed sensor is probably placed in wheeldrum or in gearbox.

Mar 27, 2012 | Cars & Trucks

1 Answer

Car pulses at any speed and all lights pulse


your going to need to dig into your electrical system, i recomend saving yourself some headache and purchasing a service manual (chilton or haynes) and following the trouble shoot procedures in the book. it could be a bad ground or loose connection but there is now easy fix your going to have to chase this one down the hard way

Mar 19, 2012 | 1996 Pontiac Grand Am

1 Answer

Idle speed is varying from very low to very high--- check engine light has also come on.


Have it scanned at a local auto parts store for free to determine what the trouble code is turning on your check engine light. Once that is determined it will need to be followed up with the tech manual for the trouble shooting flow charts and more precise explantion of the code.

Apr 20, 2010 | 2000 Oldsmobile Intrigue

1 Answer

How to trouble shoot air condition compresuer


You really want to troubleshoot your AC. Here are some items to follow:
1- Make sure your Compressor clutch work first. You can jump the wire to test it when the engine is off.
When you know the clutch work then you can look for the other things not makeing it activated.
2- It it doesn't work then you know the problem right there.
3- If it works then check the Low and high pressure according to compressor spec.
3- Check your engine temperature sensor. Don't think that your temp reading gauge is coorect then your engine temperature for your AC is working.
4- Check your compressor sensor speed. It has to be in sych with your crankshaft sensor before it allows the clutch engaged to prevent burning your compressor when it is locked up is in freezing mode ( ex.in case some clever people jumping wire to control the clutch bypassing all other rerquirement).
5- If you think these items need to be addressed by professional better then do-it yourself then I have no objection. Good luck on trying.

Jul 09, 2009 | 2001 Chevrolet Blazer

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

14 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts

yadayada
yadayada

Level 3 Expert

76846 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22246 Answers

Randy Ohler

Level 3 Expert

14585 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...