Question about Dodge Ram 1500
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Posted on Jan 02, 2017
That works fine on a relatively new vehicle but one that has run in salt etc you'll save a lot of time if you remove the steering knuckle completey by separating lower ball joint and outer tie rod end ball joint and bring the whole steering knuckle to a bench to separate the hub/bearing. Soak everything with penetrant, loosen the bolts a few turns and try hitting right on the bolt heads. I also made a very sharp wedge from a chisel and rammed it hard on the other side to seoarate the hub. It will finally come apart then you'll see all the **** that was binding it due to an alumininum knuckle re-acting with a steel hub. Clean the hole and grease everything and fit new bearings
Posted on Feb 15, 2009
SOURCE: check engine light on code
This trouble code is Evap Purge System Performance fault. 1) Check for a loose or missing fuel cap. 2) Check for a damaged or missing fuel cap seal. Recheck for other trouble codes. This fault wont cause the stumblering problem. It turns on the MIL lamp to say there leak in the EVAP system.
Posted on May 10, 2009
On the upper grill side of the headlight assy. there
should be 1 or 2 push pins that hold the seal on the
headlight assy to the front of the fender. Also check
for a guide/push pin on the inner top of the assy on
the outer fender side. That should be all there is to
hold the headlight in place. Hope this helps.
Posted on Apr 10, 2010
I just had the same problem, new cap, deleted the codes with a obd... took it to the dealership...
its the EGR valve that was bad on my truck 2007 dodge ram 45000 miles...
i get it back on friday, its a simple part 1 wire harness and 2 bolts and gasket.
Posted on Mar 10, 2011
Tips for a great answer:
Feb 03, 2016 | Dodge Cars & Trucks
Dec 04, 2012 | 2004 Dodge Ram 1500
Sep 02, 2012 | 2007 Dodge Ram 1500 Quad Cab Sport
Jul 08, 2011 | 2007 Dodge Ram 2500 Mega Cab Laramie
Jan 28, 2011 | 2007 Dodge Ram 1500 Quad Cab Sport
Jul 04, 2009 | 2004 Dodge Ram 1500
Apr 23, 2009 | 2001 Dodge Ram 1500 Truck 2WD
Oct 24, 2008 | 2007 Dodge Ram Truck
32 people viewed this question
Usually answered in minutes!
Step 2: Please assign your manual to a product: