Check your selector on transmission. Could just be in a bind
SOURCE: 2006 Dodge Charger stuck in Park.
In the event of an electrical failure, the vehicle can be shifted out of PARK by using the following procedure.
1.
Turn the key to the ACC or ON position.
2.
Remove the liner to the cubby bin to the right side of the shifter.
3.
Depress the BTSI override (2) on the side of the shifter assembly (1).
4.
While the override is depressed, move the shifter out of the PARK position.
5.
Return the cubby bin liner to its original location.
SOURCE: SPARK PLUG INSTALLATION ON 2006 DODGE CHARGER 2.7L
In my experience with the 2.7L engine, the spark plugs are located on the top of the engine below the individual ignition coils. The coils are placed between the intake manifold and the valve covers, 3 per side. The coils are held in with "torx" screws. Simply remove the screws, and disconnect the connectors to remove the coils. The spark plugs will be underneath. Be sure to properly gap the spark plugs for maximum life and emissions compliance. Also, an improperly gapped plug can shorten the life of the coil packs.
Hope this helps!
SOURCE: 2006 dodge charger is stuck in park?
Brake lights working, then the Shifter interlock soleniod is stuck or burt out, also the release for the interlock is on right side of console, remove plug, and depress the pin, the cable can off the release to, or bamaged interlock. The interlock recieves 12 volts from brake circuit, can be tested at the soleniod. GOOD LUCK. RDJRP
SOURCE: my 2006 Colorado will not go back to 2 wheel
If you are in 4 low to go back to 2 wheel drive you have to be in neutral if you aren't already
In the event of an electrical failure, the vehicle can be shifted out of PARK by using the following procedure.39 views
Usually answered in minutes!
×