Question about 2004 Pontiac Grand Prix

Open Question

How to replace traction control switch, mounted in consloe?2004 pontiac grand prix gt

Posted by on

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

wyatt1582
  • 453 Answers

SOURCE: abs and traction control light faults after a brake job. 2005 Pontiac grand prix

You have a bad sensor at one of the tires that need replacing that operates ABS and traction control. If you take it in to a shop it will run $130 but they can find which sensor is causing the problem. But if you do it you might have to replace all 4 sensors to make sure you got the right one. Every hard to diagnoses. Its better for the shop cause they can get electrical read outs for each sensor.

Posted on May 21, 2009

  • 1 Answer

SOURCE: LOOKING FOR A FUSE BOX DIAGRAM FOR 2004 PONTIAC GRAND PRIX GT

It's under the hood, on the driver's side, under a square, black box with a lightning symbol on it. Loosen the flower-shaped screw that holds the lid of the box down, remove the lid, flip it upside down and when you look at the inside of the lid, you'll see a map of all your car's fuses. There's also a fuse diagram on the very end of the dash, but it's accessible only when you open the driver's side door. When you're driving, that end of the dash is blocked by the closed door.

Posted on Jul 01, 2009

  • 10 Answers

SOURCE: abs and traction control lights coming on

Its the abs sensor, if you encounter an ice patch or snow you won't even be able to stop because the pedal will will push back and make the rip grind noise. If you pull the ABS fuse out, you won't have ABS but you can stop and you won't have the grind noise and back pressure for now. Its safer to not have ABS when the sensor is faulty.

Simon Atari
simonkhpa@yahoo.com

Posted on Aug 06, 2009

motor1258
  • 6674 Answers

SOURCE: spark plug gap for 2005 pontiac grand prix gt 3.8

.060 thousandths of an inch.

Posted on Nov 19, 2009

mlapres
  • 757 Answers

SOURCE: 2005 Pontiac Grand Prix Traction Control Problem

Also not coming to a complete stop before changing gears will cause that as well.

Posted on Dec 20, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Where are the sensors on the 2004 pontiac grand prix rotors


the abs sensor is in the frnt wheel bearing hub,and the traction control sensor is in the transmission

Jan 01, 2013 | 2004 Pontiac Grand Prix

1 Answer

Traction light on


Traction light is part of the ABS brake system. I had to the same problem 2 years ago and my auto repair guy said it was my front hub bearing. I replaced both sides with new hub bearing (right & left wheel) and now I have to replace the left one again. The thing about 04 grand prix gt they have a wheel/hub bearing problems. GM never recalled for this problem

Jun 19, 2012 | 2004 Pontiac Grand Prix

1 Answer

My ABS, traction control, and steering assist lights are on in my 2004 pontiac grand prix gt. The rear wheel bearing assembly was just replaced. what would cause this?


Hi, the wheel speed sensor and tone ring are built into the bearing/hub assembly. Make sure the new hub contains an ABS wheel sensor and the cable was properly connected. If it is properly connected, the new hub may be defective.

Apr 19, 2011 | 2004 Pontiac Grand Prix

1 Answer

My traction control botton wont work on my 2004 grand prix is this a diy problem?


one question is your abs or brake light on. you might have a wheel abs hub going out and not reading that will prevent traction control to work

Jul 13, 2010 | 2005 Pontiac Grand Prix

2 Answers

2004 grand prix no go with traction control light on.


I had the same problem with my car. I cleaned the throttle body and when i installed everything back, the car would throw 2 OBD codes: P0120 at start up and P0507 when it stalled at a red light. Took it to the dealership and they had to install a new throttle body because the throttle position sensor is internal. Cost = $718.00 out the door. Part is about $480 and labor is 1.8 hours at $99.00/hr (bunch of ****). There is only a 12 month/12,000 mile warranty for work from the dealer so I would recommend doing the work yourself if possible. There is only 2 bolts on top, 2 nuts on bottom, 1 electrical connection, and 1 hose clamp.

Feb 12, 2010 | 2004 Pontiac Grand Prix

1 Answer

Service variable effort steering warning is coming on.what do i do to service it? 2004 gtp


i have an ABS, Traction Control, and Variable Steering warning lights come on right after i put the car in drive and move forward.
2005 Pontiac Grand Prix

Aug 15, 2009 | 2004 Pontiac Grand Prix

1 Answer

2004 Pontiac Grand Prix all warnings when starting the car


check all fuses and wires make sure everything tight.

May 26, 2009 | 2004 Pontiac Grand Prix

Not finding what you are looking for?
2004 Pontiac Grand Prix Logo

Related Topics:

20 people viewed this question

Ask a Question

Usually answered in minutes!

Top Pontiac Experts

yadayada
yadayada

Level 3 Expert

75077 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

7768 Answers

Are you a Pontiac Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...