Question about 2002 Ford Escape

Open Question

Where is the blower motor relay on a 2002 ford escape

Posted by on


6 Suggested Answers

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

A 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
The service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Good luck!

Posted on Jan 02, 2017

  • 404 Answers

SOURCE: removal of rear brake drum 2002 ford escape

make sure handbrake is off take wheel off hit the drum with a mallet not steel,as it will brake,hit on outter diametter face of drum, try and rotate as you twist off

Posted on Jan 05, 2009

  • 7 Answers

SOURCE: Blower motor stopped working.

ok to the left of the steering wheel by brake pedal remove fuse panel and look for no. 3 location blower relay after that your going to look for no. 8 blower fuse 40amps after that look for no. 28 its a 10amp fuse this is blower coil relay but if you have puddle lights that fuse is good also runs them !! Hope this helps you out !! Rick from nwi auto acdelco & ford parts dealer !

Posted on Mar 04, 2009

  • 783 Answers

SOURCE: ford escape 2002 firing order

V6 1-4-2-5-3-6 back bank pasenger side right to left cylinders 1 2 3
front bank passenger side right to left 4-5-6
4 cly 1-3-4-2

Posted on Jun 23, 2009

  • 373 Answers

SOURCE: 2002 ford escape tie rod squeaks

My outer tie rod did the same thing when just out of warranty. I could tell it was "bad" by putting my hand on the tie rod while someone else turned the steering a little and I could easily feel the vibration.
Check the other side to feel the difference. Tie rods don't cost that much, if you can replace it yourself, and take a chance on foregoing the wheel alignment. Maybe a $150? job at the shop.
In my case, a tie rod was not readily available. I verified that it was a good joint; no shake or rattle. Then I squirted a little WD40 inside the boot, and put it back together. 70,000 miles later, the new tie rod is still on my shelf waiting for the squeak to return.

Posted on Mar 17, 2010

  • 373 Answers

SOURCE: How do you replace the EGR on a 2002 ford escape?

To replace the the spark plugs on the V6, you'll need to remove the intake manifold. There is a coil on top of each plug (COP). Check this website for info:
The same link will also show the R&R of the EGR valve.

Posted on Mar 17, 2010

Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

Where is the Blower motor relay on a 2002 Ford Econoline E150, and how do you change it so both the front and rear blower motors work on all 3 speeds?

There would be two relay's , one for front an one for the back . And the relay would be for high speed only . And it just so happens there are two AUX blower motor relay's .
Auxiliary Blower Motor Relay C403
Left rear corner of vehicle, above wheelwell
Auxiliary High Blower Motor Relay C404
Left rear corner of vehicle, above wheelwell

Front blower motor relay - K73 top left , Six relay's at top left .

check it out here

Feb 17, 2017 | Ford Econoline Cars & Trucks

1 Answer

Why would my fan not be blowing hot or cold air?

You could have a relay that is bad , Blower motor relay in the under hood fuse/relay box. Or the blower motor itself could be bad . This is where you need to get a wiring diagram an a component location chart an a DVOM digital volt ohm meter an do some testing . The blower motor resistor , is this the part you changed ? If you haven't high blower operation either it couldn't be the blower motor resistor .

Oct 23, 2015 | 2002 Mercury Mountaineer

3 Answers

Finding the relay for heat and a/c blower motor

It's called a resistor. Under the dash, on the passenger side. Close to the blower. Usually behind the blower motor. Has five to seven wires going to it.

Jun 16, 2015 | 2005 Ford Escape

1 Answer

Hola buenas tardes tengo un problema con mi ford escape 2009 motor 3.0 que las ventiladoras de enfriamiento se me an quedado directac y no hacen sus ciclos de parar cuando el motor esta frio si no que...

Necesitas un sensor de enfriamiento del ventilador. Est? ubicado en el radiador.

You need a Fan Cooling Sensor. It is located in the radiator.

2005 Ford Escape radiator cooling fan repair. - YouTube

? 3:19
Sep 24, 2014 - Uploaded by hufhuffy
2005 Ford Escape cooling fan problems ,cooling temp sensor auxiliary fan control unit ,radiator fan switch ...

2009 Ford Escape Hybrid radiator cooling fan - YouTube

? 1:42
Mar 8, 2017 - Uploaded by stevenofpa
00243 2009 Ford Escape Hybrid radiator cooling fan - This video shows the engine cooling fan radiator fan ...

2008 Ford Escape Cooling Fans: Both Aux and Main Cooling Fans ... Jun 17, 2014 - I have replaced the Main cooling fan relay but didn't help. Not sure if there is ... 2002 Ford Escape Coolant Overflow Bottle Replacement.

2009 Ford Escape Cooling Sensors, Switches & Relays - > ... > Ford > Escape Results 1 - 21 of 21 - Ford Escape Replacement Engine Cooling Parts - 2009 ... Ford Escape 2009, Coolant Temperature Sensor Connector by Standard®. 2009 ford escape replace cooling fan sensor Google Search

Oct 28, 2017 | 2003 Ford Escape

1 Answer

How to fix a 2001 ford escape blower motor

  • Disconnect the negative battery cable.
  • Disconnect the blower motor lead connector from the wiring harness connector.
  • Remove the blower motor cooling tube from the blower motor.
  • Remove the four retaining screws.
  • Turn the motor and the wheel assembly slightly to the right so that the bottom edge of the mounting plate follows the contour of the wheel well splash panel.
  • Lift up on the blower and remove it from the blower housing.
  • Installation the new blower motor by reversing the removal steps.
  • Connect the negative battery cable.
  • Dec 16, 2010 | 2001 Ford Escape

    1 Answer

    The heater fan motor quit on my 2002 Ford F-150 Super Cab and I can't find a fuse for it. How do I repair it?

    Owners manual lists the fuses as :
    Engine compartment fuse # 105, 40A
    - This is the power to the blower motor relay to drive the blower.

    Cab Fuse Panel, Fuse #22, 10A. This is the power to the switch in the HVAC panel.
    - This fuse through the switch to operate the relay coil on the blower motor relay.

    The other thing to check is the blower motor resistor, to see if there is any damage to it ( usually this is the blower only works on high )
    This is behind the glove box


    Nov 02, 2010 | 2000 Ford F150 Flareside SuperCab

    1 Answer

    My Ford escape 2002 A/C stop working on high speed or when revolutions going up to 3500.

    You may have a problem with your compressor clutch..When you say
    the A/C stops working on high speed, do you mean the blower motor
    fan speed, or the car's speed?

    Mar 29, 2010 | 2002 Ford Escape

    1 Answer

    2002 F-150 blower motor stopped working.

    There are 4 things to check out to pin point the problem: the switch it's self, the blower relay switch, resistor block, and the blower motor it's self. good luck

    Jan 20, 2009 | 2002 Ford F150 Regular Cab

    3 Answers

    Blower Motor will not Start


    Jul 14, 2008 | 2002 Ford Crown Victoria

    Not finding what you are looking for?
    2002 Ford Escape Logo

    Related Topics:

    101 people viewed this question

    Ask a Question

    Usually answered in minutes!

    Top Ford Experts


    Level 3 Expert

    77947 Answers

    Colin Stickland
    Colin Stickland

    Level 3 Expert

    22306 Answers


    Level 3 Expert

    5651 Answers

    Are you a Ford Expert? Answer questions, earn points and help others

    Answer questions

    Manuals & User Guides