How to change out the coil on 2003 tacoma v6 3400

Water went in relays,computer mane it thats a desaster try drying as mush part as you can saw that hapen too many time everybody ask me clean my engine its dirty i always tell them so what its dirty and after i tell the story about the with a town car

On a 4 cylinder it's located on the side of the block, driver's side on a V-6 engine there are two and are located under the intake manifold, it has to be removed to get to them.

Vac leak including the intake manifold or faulty injector ?

pull dqash panel

you should always change the filter when changing the transmission fluid, and a gasket is a good idea too.

There is a gasket supplied when you buy the transmission filter for all transmissions that your vehicle would have came with. You don't want to be using that stuff on a transmission pan, as a replacement for a gasket. I would wonder if the filter was changed?

give these websites a try www.alldatadiy.com and www.autozone.com if all fails stop by your local library and get your hands on a Haynes auto repair manual for you truck wish you the best of luck Michigan Man.

you have to unbolt the coil on top of the valve cover.

OK, I just fixed mine. The unit pulls out. You have to get a screwdiriver, wrap it with a cloth so it doesn't scratch the paint, then gently wedge the entire unit out. When it pops out, you'll see the clips that keep it in place. You might think its breaking when you pull it out, but trust me this is how you do. Just be gentle with it. After you get the unit out, simply take the socket out and replace the bulb. I did it in five minutes.

I have same problem on 2003 toyota tacoma 2.7L EXACT SAME CODES