Question about 1992 Cadillac Eldorado

2 Answers

No power wont turn over need wiring diagram for ignition

Posted by on

Ad

2 Answers

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Genius:

    An expert who has answered 1,000 questions.

  • Master
  • 1,071 Answers

Check fusible link in battery cable and the larger fuses in fuse box

Posted on Jul 25, 2009

Ad
  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Cadillac Master
  • 2,019 Answers

A diagram would not probably help very much.
What matters the most is where it ends up, which is the starter. And it is easy to jump the battery cable at the starter, to the small solenoid slide on contact. Make sure the car is in park first.
If that works, it could then be the neutral safety switch on the transmission. Backtracking, it then would likely be the ignition switch.

Posted on Jul 25, 2009

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
New users get 2 Free calls (no credit card required) and instant help on almost anything you can think of (from cars to computers, appliances, handyman, and even pets).
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

I require simple wiring diagrams for a 1976 F150 pickup.


Use a test lite on negative side of coil, engine cranking, the lite should pulse?
It appears the vehicle has electronic ignition, There is a separate ignition module. In the wiring diagram, I can't guarantee the wire colors. The older my wirings diagrams are, it seems, the less accurate they are. I hope it is readable, If no spark, I'd check the ignition system, Check fuses--fusible links--battery connections.
26298806-sfpzqccw001mk5jkucj51ii1-5-0.jpg

26298806-sfpzqccw001mk5jkucj51ii1-5-2.jpg

Oct 02, 2016 | Ford F-250 Cars & Trucks

2 Answers

Blazer wont start. when i turn the key to the on position there is nothing. no dash lights, nothing. i tried using a code scanner to see if that would help but appears that no power is being sent to that...


How's the battery ? Cables an connections ? Sounds like main power supply problem , do the headlamps light when you turn them on ? Dome lights light when you open a door ? Do you know how to test automotive electrical circuits ? Do you know what a wiring diagram is ? an how to read one ?
Electric Testing Techniques You Need to Know
Find a wiring diagram an test main B+ voltage supply to the ignition switch ,in an out at run an start positions !
If the key won't turn off with out pushing that hidden button you have a problem with power to the shift inter lock system . GM did have ignition switch problems on some year vehicle's !

Apr 18, 2017 | 1997 Chevrolet Blazer

1 Answer

Starter wiring


According to my wiring diagram, you should only have one small wire which is purple. That wire goes on the R or S terminal. The I terminal was used for cars with point system ignition before electronic ignition.
The purple wire should be hot when the key switch is in the start position.

Apr 30, 2013 | Cars & Trucks

3 Answers

2010 MB Sprinter starter fuse blows every time ignition is turned on. Help...


mercedes service letter:
http://www.aev.com/uploads/file/SPRINTER%20NO%20CRANK%20NO%20START%20.pdf
Replace with 25 amp fuse.

Oct 04, 2012 | 2010 Mercedes-Benz Sprinter

1 Answer

No power to ignition or dashboard?


I don't have a wiring diagram for a 96 model, but 99 and newer models have a 40amp and 80amp maxi-fuse that powers the charging and ignition systems including the switch.
You need to make sure those fuses are good by checking both sides with a test light.

Sep 21, 2012 | 1996 Kia Sportage

5 Answers

The clutch has to be in for my 85-s10 blazer to start and it wont start unless i use a screwdriver on the starter. any answers?


Your diagram is below. Since the starter jumps at the solenoid, the problem would be the ignition switch, the clutch interlock, or the wiring. Check for power at the yellow wire that goes to the switch under the clutch pedal when the key is turned to start. If you have power on the red wires to the ignition switch but no power coming out when the key is turned to start, replace the switch. If you DO have power on the yellow wire, try bypassing the interlock by pulling the connector off and connecting the terminals inside the connector with a large paperclip. If that doesn't work, the purple wire from the interlock to the starter solenoid may be broken. Please let me know if you have more questions.

jturcotte_2404.gif

Oct 16, 2011 | 1985 Chevrolet S-10 Blazer

1 Answer

1984 ford f-150 4x4 ignition wiring diagram i need to see a break down wire for wire from starter to soloid to voltage regulator new starter new ignition module new started soloid and vechicle will not...


when looking at it from the front the most left is from the battery, now going right from there the little pin is from ignition, basically to flip this giant switch on. next little pin goes to your fuel shut off relay, it will turn on that relay to send power to your pump while cranking, next is the large out. far right. that goes to your starter.

May 16, 2010 | Cars & Trucks

1 Answer

Hey, I have a rail buggy that I need to wire a horn to. I do not have a fuse box and want to wire the horn up after the ignition so you will have to have the key on to use the horn. I bought a generic...


you have a rail that has no fuse box..??? i would first install one.. simple though the ignition switch has to turn on the ignition tomake the vehicle rune... find the wire the is used to power the coil... tap into it i suppose using a relay with its own power wire to compensate for the amperage draw of the horn. when the ignition is on the horn work wen it is off the horn wont

Jul 05, 2009 | Volkswagen Beetle Cars & Trucks

2 Answers

Wiring diagram for 92 chevy blazer


My 1992 Chevy blazer s-10 starts and then the door locks automatically starts locking and unlocking...It wont stay running either...

Jun 11, 2009 | 1992 Chevrolet S-10 Blazer

2 Answers

Car wont do anything when key is turned on.


magnetic pellet ,doesn't have one . Besides it's not a magnetic pellet . It would be a resistor pellet for the anti- theft system , which your vehicle does have . And it wouldn't be the ignition lock cylinder either if you can turn the key to the start position . Possibly the electrical part of the ignition switch . Viewing a wiring diagram for power flow and checking with a DVOM - digital volt ohm meter would be the proper way to diagnose .Free wiring diagrams here http://www.bbbind.com/free_tsb.html Enter vehicle info. year , make , model and engine size . Under system click electrical distribution ,then under subsystem click on power distribution . Click the search button then the blue links . The light's work because they have seperate power supply ,looking at first diagram you will see this . Thrid diagram down is ignition switch power feed . Top right of the page you will see the letter A , that gets B+ voltage from fusible link B . Finding the ignition switch under the dash on the bottom of the steering column an testing for B+ voltage on the red wire . If B+ voltage is there fusible link is good . Fusible link B is attached at the starter solenoid .B+ stud . If there is B+ power to the ignition switch check for power from the switch .Can you figure that out ? You should also check out some videos on youtube for basic automotive electrical testing .
Electric Testing Techniques You Need to Know

Oct 12, 2017 | Chevrolet Camaro Cars & Trucks

Not finding what you are looking for?
1992 Cadillac Eldorado Logo

199 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cadillac Experts

yadayada
yadayada

Level 3 Expert

76649 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22219 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8518 Answers

Are you a Cadillac Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...