Question about Cars & Trucks

Open Question

Have a 05 mag with a hemi .it is misfire on 8.can this be camsencer.it idle great but put in gear goes to help tack up and down

Posted by on

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
  • 2418 Answers

SOURCE: misfiring in 3rd and 4th gear

This sound like a timing issue, Check the points for proper gap, ck for proper timing, also ck the distributor shaft for looseness, or wabble, remove the cap and button and grab the shaft with your fingers and see if it moves back and forth, not in/out thats ok, but in a side to side type of movement. This can cause a missfire at hi rpm. 

Posted on Nov 21, 2009

Ad
  • 1 Answer

SOURCE: 2001 hyundai elantra idling high

weeeeiiirrdddd. i have a 2001 hyundia elentra gls, and my third cylinder is misfiring as well. my car also revs constantly on idle and in between shifting. it will flutter between 2-3000 or it will just stay at 5000. i replaced my plugs and wires to no fix with my cylinder. autozone also told me that it sounds like my throttle position sensor needs replaced, but every part they try to sell me will not fit and they swear up and down this is the right part...

Posted on Nov 30, 2009

wracefans24
  • 1985 Answers

SOURCE: hemi trouble

have you tried reversing the headlight job,and see if it will start,it sounds like a wire was disconnected or cut,or was spliced into by mistake

Posted on Dec 11, 2009

  • 14036 Answers

SOURCE: Thanks Burkerobin & PC302001-- on 2000 Tundra

DO A LITTLE TUNE UP.CHANGE SPARK PLUGS.CHANGE FUEL FILTER.CLEAN FUEL INJECTORS.FILL FUEL TANK UP.AND ADD A BOTTLE OF FUEL INJECTOR CLEANER IN FUEL TANK.WHEN YOU DRIVE CAR AROUND.THE INJECTOR CLEANER WILL CLEAN OUT FUEL INJECTORS.IF CAR STILL RUN ROUGH IN DRIVE.YOU COULD HAVE INTAKE LEAK.

Posted on Jan 30, 2010

  • 2428 Answers

SOURCE: I have a 05 VW

Try the crank pisition sensor that is vary likely to be the couse of your misfires its working but its intermintly shorting out telling the pcm that you have a misfire and setting the codes

Posted on Nov 22, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

04 DODGE Ram hemi cylinder 3 misfire


Check engine compression and compare. then test running engine compression most engines have about 130-170 cranking compression and about 90-110 running compression. OR bring that cylinder to its Top Dead Center compression stroke apply air to the cylinder and check to see where the air is going open throttle plate bad intake valve, from exhaust pipe bad exhaust valve, from oil cap piston rings.

Mar 23, 2014 | 2004 Dodge Ram 1500

1 Answer

05 grand cherokee limited 5.7 hemi quadra drive 2. will not go into any gear


Frozen ice around shift mechanism. Oil in trans is too thick. Try adding a heat lamp or blanket around the transmission area.

Dec 06, 2013 | 2005 Jeep Grand Cherokee

1 Answer

Low oil pressure at freeway speed, normal when idling


Drop oil pan and check pump tube o-ring to see if seated properly. Also check for blockage at tube screen. Had same problem on my 05 ram 1500 5.7ltr Hemi.

Nov 11, 2012 | 1995 Jaguar XJ6

3 Answers

I have a 05 VW Pessat with a 1.8L 65K miles on it. I have a random misfire and surge at idle. Code's set: P0300, P0301, P0302 and I seen P0303. This misfire comes and goes. Does not have a dead miss. I...


Try the crank pisition sensor that is vary likely to be the couse of your misfires its working but its intermintly shorting out telling the pcm that you have a misfire and setting the codes

Nov 22, 2010 | 2004 Volkswagen Passat

1 Answer

What is a p0307 code on a dodge truck 1500 5.7 hemi 2004 the truck is missing on one cyl.


P0301-P0308....2T catalyst........2004-05 Ram...Cylinder 1-8 Misfire Detected Conditions: Any time engine is running and the adaptive numerator has been successfully updated. When more than 1.5% (300M, Magnum), 2% (Durango, Ram), 2.5% (Durango LEV, Ram LEV), misfire rate is measured during 2 trips, or with 10-30% misfire during 1 trip. 3 good trips required to turn off MIL. Possible Causes: ASD relay output 2 circuit fault Injector control 1 circuit fault Coil control 1 circuit fault Ignition wiring, spark plug, or ignition coil fault Fuel pump inlet strainer plugged Restricted fuel supply line Fuel pump module fault Fuel pressure leakdown fault Fuel injector is damaged or has failed Engine mechanical problems exist PCM has failed. Hope this helps you. Thank You for using fixya.If you like this solution please rate it....Thank You, iluv2fish....Ray

Jun 24, 2010 | 2004 Dodge Ram 1500

3 Answers

I have a 2007 Dodge Ram 1500 with the 5.7 HEMI/MDS engine.If I shut the engine down when hot and then restart within a short time the idle goes up and down by about 100 RPM.It settles itself out after...


YOU COULD BE HAVING ENGINE MISFIRE.DUE TO BAD SPARK PLUGS AND WIRES.ALSO DIRTY FUEL INJECTORS WILL CAUSE ENGINE TO ROUGH IDLE OR IDLE UP AND DOWN.PUT A BOTTLE OF FUEL INJECTOR CLEAN IN A FULL TANK OF GAS.ALSO CHANGE PLUGS AND WIRES.IF TRUCK HAS 30000 TO 60000 MILES ON IT.THATS THE SCHEDULE MAINTENCE INTERVALS IF SPARK PLUGS HAS NOT BEEN CHANGED.

Feb 14, 2010 | 2005 Dodge Ram 1500

1 Answer

Hemi trouble


have you tried reversing the headlight job,and see if it will start,it sounds like a wire was disconnected or cut,or was spliced into by mistake

Dec 11, 2009 | 1986 Dodge Ram 50

4 Answers

5.7 hemi jeep misfires irregularly engine light flickers


changed out all the oxyegen sensors and then Jeep replaced the catalytic converter for free because of an emissions thing with the state. All is good now.

Aug 31, 2009 | 2005 Jeep Grand Cherokee

1 Answer

Lost Over-drive????


time to consider a visit to the junk yard and fit a manual

Feb 16, 2009 | 2001 Daewoo Lanos

1 Answer

Lost Over-drive????


I read your problem, and I think Reliable-Store has the solution of your problem, Just visit the link I attached here, I'm sure you will get the solution of your problem forsure. Best Manuals

Mar 16, 2017 | 1998 Oldsmobile Intrigue

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

11 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts

yadayada
yadayada

Level 3 Expert

76846 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22246 Answers

Randy Ohler

Level 3 Expert

14585 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...