Question about Cars & Trucks

1 Answer

1995 rodeo 2.6 #1 ,2 ,3 cylinders are soaked with gas,, the head was redone and put back on,,, ,now it won't even run at all, cause it is flooding so much,, any help would be greatly appreciated, ,,

Posted by on

Ad

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that got 5 achievements.

    Scholar:

    An expert who has written 20 answers of more than 400 characters.

    Night Owl:

    An expert who has answered 10 or more questions between 12 midnight and 6am on the same day.

  • Expert
  • 146 Answers

Have you checked your fuel injectors? They should be pulsing, not streaming. They could be stuck open or full of dirt. Also your fuel pressure regulator could be providing too much pressure. Is the wiring to each injector correct?

Posted on Apr 28, 2017

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
warlock61
  • 659 Answers

SOURCE: 1995 Ford F350 5spd. distributor cap wiring diagram/layout!!!

1) #1-4 pass side front to rear #5-8 drivers side front to rear
2) 1-3-7-2-6-5-4-8
3)#1 is usually marked on cap wires go ccw
4) TDC #1 cyl you must remove the shorting plug before timing
it is located by the dist plug or the ignition module small gray plug

Posted on Dec 13, 2008

  • 1114 Answers

SOURCE: 1993 f150 4x4 has a 5.0 efi its flooding out without giving any

sounds like a fault in pick up module or coil??? you should test them before replacement.

Posted on Dec 27, 2008

  • 1 Answer

SOURCE: 2001 Rodeo giving false fuel gauge readings

my 2000 rodeo had same problem . i finally found a bad electrical connection in plug inside the lower left kick panel. the plug connection was not staying fully inserted into the other half of the connector the wire and crimped connector would completley come out of the molded plastic plug that had multiple wires inserted in it . i had to route around to the mating wire on the other half of the connector and connected with a sta-kon connector . there are many connections in this circuit you may have to check all of them. the fuel pump / sending unit did not fix my problem so i went checking connections .this was a fault from who ever made the wiring harness
GOOD LUCK AND MAY GOD BLESS YOU !!!!

Posted on Jul 16, 2009

  • 17 Answers

SOURCE: Nissan Largo 1995

do the thermostat and water pump, just did my cd20 and there was nothing left of the water pump

Posted on Aug 12, 2010

  • 86 Answers

SOURCE: 1995 lexus ls 400 multi

Is the check engine light on? If so it may be on because of a bad o2 sensor, bad o2 sensors send signals to the ecu which adjust fuel mix to the injectors. If its not a o2 sensor you may need a new computer they can malfuntion also. There's many sensors and models that control fuel delivery. The ones i've mentioned could be the likely source.

Posted on Mar 20, 2011

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Getting too much gas so why will it only go 25 mph?


which engine,we cant help much lacking that.
get it serviced?
while it still moves?
what made you think its too much gas?
evidence.?

it's old car.
get compression tested while full tuneup is done.
do that first.;
get it scanned, or at least the isuzu flash codes
is cel lamp glowing key on,then then does not turn off running(check engine lamp)

check fuel pressure?
check injector balances tests, and leak down tests>

the flash codes will show any sensors that fell off
or are 100% dead.

insert the diagnostic jumper wire

http://www.troublecodes.net/isuzu/

Jan 10, 2016 | 1995 Isuzu Rodeo

1 Answer

93 seville sts runs great and then after driving wont star fot 30 min to an hr. any easy solutions?


If/when you do get it started, do you have to hold the petal to the floor or give it a lot of gas to 'clear' it up again? Does it smoke when you first start it up? If so, you might have a leaking injector (s), the o-rings allow pressure to push gas into cylinders when you shut down, flooding the cylinder-will cause hard starting. If this is not the case, consider a heat-sink kind of situation with the crank sensor-it gets hot with normal driving, and gets even hotter with heat-soak when shut down and changes electrical properties (specifically resistance) until it cools down again. change the crank sensor.

Mar 14, 2011 | 1993 Cadillac Seville

1 Answer

Car will turn over but will not start the car sat for a month it did start at first then it stoped i toke all the distpitor wires off one at a time and replaced them and it would start but now it wont...


The engine is probably flooded (Way too much fuel) If the fans are running all the time, it is usually caused by a bad Engine Coolant Temperature Sensor. This will also cause the injectors to open all the way and flood the engine. Replace the Coolant Temp Sensor, then hold the throttle all the way to the floor while you crank the engine. This puts the computer in "Clear Flood Mode" and will shut the fuel off so the excess gas can get out of the cylinders. This should make it start.

Jan 31, 2011 | 1995 Mercury Sable

1 Answer

Ignition turns over but car will not start...


sorry to hear your vehicle is down. check the fuel filter if so equipped, or could be fuel pump.
hope this helps. have a good day

Jan 29, 2010 | 1992 Isuzu Rodeo

1 Answer

Car flooding out making it run rough.


It can be a couple of things.One could be a damaged injector, dumping fuel into the one cylinder, or you could have a faulty plug, not firing, or faulty plug wire or coil pack.I'd start by switching plugs and wires from a good cylinder and running it and seeing if that cured the problem.Hope I could help.

Dec 22, 2009 | 1993 Saturn SL2

2 Answers

What causes a water leak in the back of the engine in a 95 isuzu rodeo


could be a "core plug" on the hack of the cylinder head,,, witch would be a head off job,,,or a head gasket,, also a head off job,,,
try rad weld,, or stop leak,,, i find its quit good for this,,,,and is a lot cheeper than the repair shop price

Oct 26, 2009 | 1995 Isuzu Rodeo

1 Answer

Car wouldn't start one morning, acted like it was flooded. After investicating i found the cylinders loaded with gas. so i removed the fuel pump fuse and relay. then turned car over to clear cylinders. The...


you have one our two problems the coolant temp sensor has failed our the fuel pressuer regulator has failed. the regulator is controlled by vacuumn and is in the fuel rail remove the vacuumn line if any fuel runs out it has failed with the line removed try cranking the mtr over and see if it floods good luck kdc744

Feb 08, 2009 | 1995 Oldsmobile Aurora

1 Answer

Valves noise


The have puck looking followers that take up the excessive back lash.

Jun 30, 2008 | 1996 Isuzu Rodeo

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

29 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts

yadayada
yadayada

Level 3 Expert

76848 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22246 Answers

Randy Ohler

Level 3 Expert

14585 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...