Question about 1993 Dodge Stealth

1 Answer

93 Stealth ES won't start. Changed the fuel pump, Cam and Crank Position sensors, now the computer. Codes are 20 and 21. No spark or fuel.

Posted by on


1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points


    An expert that got 20 achievements.


    An expert that got 10 achievements.


    An expert that got 5 achievements.

  • Dodge Master
  • 5,728 Answers

Fuel filter needs to be changed.

Posted on May 08, 2017


1 Suggested Answer

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

A 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
The service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Good luck!

Posted on Jan 02, 2017


Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

2 Answers

2000 kia sportage,replaced f/pump/filter,ecm,relays,coils,plugs,wires,still won't start

Since fuel supply side have been changed, try looking into the ignition side. It will be much simpler if you scan your car for error codes. Less guesswork and lower repair cost. Without codes, next to check would be Crankshaft Position Sensor and Camshaft position Sensor. If both OK and all relays are OK, you should have spark.

Apr 17, 2014 | Kia Sportage Cars & Trucks

2 Answers

I have a 1998 Jeep cherokee sport. Was driving today and it died. Now there is no spark and no power to fuel pump. Changed fuel pump today and it won't run. Recently replaced oxygen sensors too

U need to check the crankshaft position sensor. The fuel pump will only have power for 2 seconds I till it sees a crank signal. It' controls the asd relay which turns on your spark and fuel

Apr 19, 2013 | 1998 Jeep Cherokee

2 Answers

My 2002 nissan sentra will crank but won't start. i've replace the ecm/ecu, the cam/crank sensor or position, checked the fuel pump/pressure, and it still is doing the same thing. sometimes it

I assume you checked the fuel pressure and it is normal.
Are the spark plugs getting spark when it fails to start ?
Are you getting injector pulse from the computer ?
Any trouble codes stored in the computer ?

Mar 06, 2013 | 2002 Nissan Sentra

1 Answer

4x4 v8 1998 dodge truck won't start

well if ur not getting spark and u changed all of the ignition components lets think about the computer in order for the ignition to work you have crankshaft position sensor that fires the fuel injectors and the spark change that and if still nothing then change the camshaft postion sensor that sensor tells the computer that the 1 piston has came all the way up and it tells the crankshaft sensor to do its thing

Feb 21, 2013 | 1998 Dodge Ram 1500 4WD

1 Answer

My 94 fors Taurus cuts out while driving and sometimes will not start. It cranks but won't start. We changed the fuel pump, spark plugs and distributor cap, but it is still cutting out while driving...

are there any codes? have you checked the pressure in the fuel line. you may have a bad fuel pressure regulator. or a bad crank position sensor. spray starter in the throttle body and see if it starts

Dec 14, 2012 | Cars & Trucks

1 Answer

1991 Dodge Dakota

check and make sure you have 12 volts to fuel pump with key in on position, if not trace back wires to relay if good, turn key on, off , on, off
then leave on and check codes may be crank sensor, or cam sensor

Jul 15, 2012 | Cars & Trucks

2 Answers

95 dodge intepid es 3.5 no spark changed coil crank and cam sesors. still no spark. help

are you able to have the engine code read? for free at any autozone or advance auto parts store? sounds exactly like you have a bad computer,located on the passenger side at the kick panel where your right foot would be if you're setting in the passenger side seat.!1st i would check your ecm fuse located under the hood in the main fuse box on the driverside fenderwell,all good? then move towards the computer. thank you for choosing!

May 02, 2011 | 1995 Dodge Intrepid

2 Answers

No spark no FI pulse NO START

Check the ignition switch please. Had that on a 93 Ford that it was bad and the coil wasnt getting any electricity while the switch was in "start" position.

Aug 17, 2009 | 1994 Ford Escort

1 Answer

2000 dodge stratus turns but wont start, checked timing belt, fuel pump distributer and fuses. Any other suggestions?

You need to check to see if it's a fuel problem or an electrical problem. Is there adequate spark at the plugs? If so, check for fuel problems. Clogged filter, bad fuel pump, bad gas.. Get car scanned for codes at most parts stores for free. Could be a CPS crank position sensor or cam position sensor. If crank sensor is bad, will not start. Get codes checked first.

Jun 19, 2009 | 2000 Dodge Stratus

1 Answer

My s10 will turn over, but wont squirt gas through injecter

Does it crank? Do you have any codes? Check engine light? Do you have spark? No spark check coil, and connections, also it would be nice to know what year it is. Get codes read. No crank check battery and starter. No codes or lights check crank position sensor, make sure your pcm is good after replacing your ignition mod you could have blown it if you did do it right. (engine computer) Check cam sensor if applies. Crank and cam could prevent it from starting and I know one I think cam controls pcm's fuel delivery on gm's

Dec 30, 2008 | 1986 Chevrolet S-10 Blazer

Not finding what you are looking for?
1993 Dodge Stealth Logo

Related Topics:

23 people viewed this question

Ask a Question

Usually answered in minutes!

Top Dodge Experts


Level 3 Expert

77939 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22306 Answers

Ronny Bennett Sr.
Ronny Bennett Sr.

Level 3 Expert

6927 Answers

Are you a Dodge Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides