Question about 2002 GMC Yukon XL

2 Answers

Hydralulic pump for ABS keeps running after vehicle turned off.

2000 Ford 4.6L Expedition. Today, the ABS light came on and remained, so I know it is an ABS related problem. The Hydraulic pump keeps running after turning the vehicle off; so I unplugged the connection (2 wire) from the unit to stop it. It is easy to simply say "take it to a garage", but is there something I can check to possiblly find the problem before I Have to take it in.

Posted by on

2 Answers

  • Level 2:

    An expert who has achieved level 2 by getting 100 points


    An expert that got 5 achievements.


    An expert whose answer got voted for 20 times.


    An expert who has answered 20 questions.

  • Expert
  • 103 Answers

The ABS Control Module is out. Common problem on GMC

Posted on Jul 25, 2009

  • Level 2:

    An expert who has achieved level 2 by getting 100 points


    An expert that got 5 achievements.

    Vice President:

    An expert whose answer got voted for 100 times.


    An expert that has over 500 points.

  • Expert
  • 148 Answers

Unless you have a scanner and testing equipment and know exactly what wires to test good luck, it could be just about anything that could cause that pump to run.Best bet go to a shop.Even with all my experience I don't diag ABS problems on the side.

Posted on Jul 25, 2009

1 Suggested Answer

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

1998 expedition yesturday was low on fuel got gas drove with headlights on got 4 miles down road vehicle died thought was bad gas 3hrs later vehicle would run but abs light and brake light would flash

There is a problem in the electrics of the vehicle. First place to start is to check the alternator drive belt for condition and tension. Next place is the battery terminals and condition and tension . Third place is to have a load test done on the battery as it may have an internal short and drawing all the current from the alternator. In effect when you add power requirements ( park lights then brake lights then headlights) you are actually using more current than the alternator can supply to keep the engine system running.

Nov 22, 2014 | 1998 Ford Expedition

1 Answer

How do you turn off the abs

Safety feature on this vehicle, only way to disable it is to either pull the abs relay out from the fuse block under neith the hood or even pull out the abs fuse, however the abs light will stay illuminated because of this..

Jun 10, 2012 | 2000 Ford Expedition

1 Answer

My 2000 Ford Expedition XLT's check engine light

I'm probably not going to be able to give you a proper diagnosis without knowing which codes are setting the check engine light. There are about 300 problems that can set the light. Most common thing for your vehicle with not running bad is what they call the DPFE (differential pressure feedback) sensor. It's basically a vacuum/pressure monitor for the EGR system and they get stopped up or corrode as they have exhaust gases running through them and are made from aluminum or plastic. If you post code numbers (go to advance or autozone and they will read them for free) and I can give you a better idea of what the problem is.

Jun 19, 2011 | 2000 Ford Expedition

3 Answers

Where is it located ABS Module 2000 Expidition

Where do u unplug abs module on 2000 ford expedition

Dec 15, 2010 | 2000 Ford Expedition

1 Answer

Everytime i press gas my abs light and my battery light turns on and then when i release the gas it turns back off and all my gauges at times they go crazy up and down but the car still runs great

Sounds like a battery, charging system, serpentine belt slipping problem. Just drive the vehicle to a Auto Zone and have them check the battery and charging system. Please let me know if this helps.

Nov 01, 2010 | 2000 Ford Expedition

1 Answer


The noise is a clicking noise which means the abs is engaged due to a bad sensor, which runs the battery down after it runs for a while. A shop can read abs codes with a scanner.

Mar 13, 2010 | 2000 Ford Expedition

1 Answer

Abs warning light comes on when i start to drive and the air suspension pump kicks on and truck starts to level out

abs warning light is on and is also making a continuous sound in the engine and remains on making sound even when car is off. what is this

Mar 07, 2010 | 2000 Ford Expedition

2 Answers

How to replace a rear turn light on a 2000 ford expedition?

how do i change a front turn signal on a 2000 expedition?

Dec 22, 2009 | 2000 Ford Expedition

1 Answer

Hi my abs light keeps coming on in my 2000 ford expedition. I would like to check the fluid level but I cant find the pump. Would you be able to explain where it is located?

The brake fluid is on top of the master cylinder in a reservoir. Yes the level being low cause light to come on but so could many other reasons.

Jul 11, 2009 | 2000 Ford Expedition

Not finding what you are looking for?
2002 GMC Yukon XL Logo

1,117 people viewed this question

Ask a Question

Usually answered in minutes!

Top GMC Experts


Level 3 Expert

75117 Answers


Level 3 Expert

1311 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Are you a GMC Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides