Question about Peugeot Cars & Trucks

Open Question

2004 Peugeot 2.0l hdi smoke coming from underneath bonnet near side after a long run or hard drive, can't see where it's coming from when I lift up bonnet. Any ideas

Posted by on

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 4 Answers

SOURCE: peugeot 307 2003 hdi... cant open my bonnet

The bonnet release is on the passenger side under the glovebox and pushes towards the footwell.

Posted on Mar 16, 2009

  • 1 Answer

SOURCE: peugeot expert 20 hdi

Hi, I have a 2.0HDI Expert which was doing the exact same thing as yours, blowing thick black smoke, sluggish and loss of power on gradients, a hissing sound and surging. I replaced the air flow meter but that didn't help. I was told to replace the turbo but a turbo expoert told me not to as it would blow white smoke if it was faulty. I was then told to replace the injectors but a diagnostic test showed them to be functioning fine. I was then told to look at the intercooler which had thick sludge at the lower left pipe. I replaced it today - Sunday 12th July and it is now driving like a new van. It now pulls me up gradients with ease in 4th and 5th instead of having to drop gear to get to the top. I got a replacement from Euro Car Parts for £147 inc VAT. To tell if this is your problem, look through the gaps in the lower section of the bumper at what looks like the radiator and look for sludge over the inside of the bumper and all over the pipe where it joins the back of the radiator (intercooler). Also open the bonnet and look down behind the grille for the same sludge. Hope this sorts it for you. Barry, Newtownards, Northern Ireland.

Posted on Jul 12, 2009

alicantecoli
  • 22156 Answers

SOURCE: Peugeot 406 Estate diesel HDI 90. The heater

switch has broke inside itself

Posted on Oct 30, 2009

  • 1 Answer

SOURCE: peugeot 407 2.0 hdi lots of black smoke when you

The reason for the black smoke is that it is not getting enough air to burn the fuel completely.It could be a blocked air filter,obstruction in the air intake system,blown turbo,hole in tube between intake manifold and turbo,or a fault with the fuel system and injectors.

Posted on Jan 24, 2010

  • 1 Answer

SOURCE: peugeot 406 hdi wipers problem

i have the same problem.Have u had any luck with urs yet???

Posted on Feb 04, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

PEUGEOT 206 2.0 HDi Coil light fault...


Hi , there is a relay timer for the glow plugs,keeps the heater plugs on in start mode for about 10 seconds. it should be in a box on the right side when you lift the bonnet, needs replacing, good luck.

Feb 24, 2010 | 2005 Peugeot 405

1 Answer

Dont know how to open the bonnet on Peugeot 104


The lever to open the bonnet is not on driver side but on passenger side (depends on the model). From passernger side open the door and then look on the side-wall (where the door ends and foot-wall starts) underneath the dashboard/glove-box for a lever to open the bonnet.

Jan 09, 2010 | 1991 Peugeot 405

1 Answer

Peugeot partner van 2001 hdi broke down with em light..called aa.fault code read fuel pump at tank as was not pumping.pump replaced and em light came on straight away after driving.cleared code again still...


there is a valve on the back of the mechanical fuel pump under the bonnet
when the lift pump in the tank fails some tiny bits of the pump are sucked down the fuel line and clog up a tiny filter on the end of the valve that may be causing the light to come on amd possibly the engine to stall
i have found that the bosch kts670 will read just about anything you plug it in to

Nov 24, 2009 | 2005 Peugeot 405

2 Answers

Peugeot 406 estate 2l hdi, anti polution light on


it would never be 1000 euros!!!!!!!!!!!! it will be part of the exhaust system it cuts out because its causing pollution

Sep 15, 2009 | 2005 Peugeot 405

1 Answer

2005 peugeot expert 2.0 hdi turns off?


Sounds like a flakey connector - try hunting down all the connectors you can find under the bonnet. Separate them, spray with WD40 and reconnect. Start at the engine management computer (silver block with fins on and lots of wires coming out). Take great care not to bend pins.

Jun 08, 2009 | 2006 Peugeot 505

1 Answer

I can't found fuel filter on my peugeot 206 1.4 lx 2002


if its diesel 2000 hdi .........its under the hdi cover under the bonnet

if its a 1400 hdi.........
its to the right of the air filter at the back of the engine

May 27, 2009 | 2006 Peugeot 405

5 Answers

Peugeot 306 problem


Thes have a weak point with the pump in the tank. It is under a cap under the rear seat, get someone to turn the ignition on and listen if no noise give it a tap and see if it whirrs, slacken a pipe on the filter and see if there is pressure, if not the pumps are available from factors or on line.

May 04, 2009 | 1987 Peugeot Liberte

1 Answer

Peugeot 307 2003 hdi... cant open my bonnet


The bonnet release is on the passenger side under the glovebox and pushes towards the footwell.

Mar 16, 2009 | 1991 Peugeot 405

6 Answers

Peugeot expert 20 hdi


Hi, I have a 2.0HDI Expert which was doing the exact same thing as yours, blowing thick black smoke, sluggish and loss of power on gradients, a hissing sound and surging. I replaced the air flow meter but that didn't help. I was told to replace the turbo but a turbo expoert told me not to as it would blow white smoke if it was faulty. I was then told to replace the injectors but a diagnostic test showed them to be functioning fine. I was then told to look at the intercooler which had thick sludge at the lower left pipe. I replaced it today - Sunday 12th July and it is now driving like a new van. It now pulls me up gradients with ease in 4th and 5th instead of having to drop gear to get to the top. I got a replacement from Euro Car Parts for £147 inc VAT. To tell if this is your problem, look through the gaps in the lower section of the bumper at what looks like the radiator and look for sludge over the inside of the bumper and all over the pipe where it joins the back of the radiator (intercooler). Also open the bonnet and look down behind the grille for the same sludge. Hope this sorts it for you. Barry, Newtownards, Northern Ireland.

Jul 11, 2008 | 2006 Peugeot 604

2 Answers

Injectors


Injectors from the same ccm engine are most probably sounds same but to be on the safe side check not only the shape but code on the top of injector too. Because they are piezo effect injectors and set by the manufacture for a specific pressure for specific engine codes.

May 22, 2008 | 1990 Peugeot 405

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

17 people viewed this question

Ask a Question

Usually answered in minutes!

Top Peugeot Experts

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Wahs Team

Level 2 Expert

205 Answers

yadayada
yadayada

Level 3 Expert

75817 Answers

Are you a Peugeot Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...