Question about Ford Cars & Trucks

Open Question

Ford falcon bf 2008,anti traction control light always on and when i forward car and then turn steering to right then too much vibration from front tyres, brake paddle and from steering Thanks

Posted by on

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 1 Answer

SOURCE: anti-lock, traction control, service soon,brake,

Anti-Lock and Trac Off lights are lit on my 1999 Alero, as well. They usually come on after about 5 minutes of driving, but are not always on when I start the car.

Posted on Jan 16, 2009

  • 15 Answers

SOURCE: Check Traction Control warning light

I can't give you an explanation for why the car is telling you to check trac. control but i can try to give some help on maybe fixing it. Try - turning on the car, turn the traction control off, turn the car off, turn the car on. Then turn the traction control back on and push the system check button. That should i guess "reset" the trac control system.

Now the noise from the front right of the car is MOST LIKELY the air compressor pumping air into the bags. (i own a 97 Continental but i've never had a problem witht the trac control)

Posted on Jan 22, 2009

  • 1 Answer

SOURCE: 2002 Chevy Impala Traction control /ABS problem

i have a 2002 chevrolet impala and the same thing happened to me. abs light came on as well as my traction controll light. when i would step on the gas or brakes my car sounded like the brake pads were skiping against my rotors. i had my hub sensor replaced 5 times. the machanic kept telling me it was the part that need to be replaced.they hooked it up to have a dianostic done and the computer keep telling them to replace the hub sensor. so finally we brought my car to an electric auto shop. they found it was a loose wire that was turning my brakes on and off.(haywire)they fix my car in 30mins.

Posted on May 27, 2009

csmock132
  • 4669 Answers

SOURCE: warning light on are trac off, anti-lock, brakes, service engine

You need to have the abs system scanned for codes. You likely have a bad wheel speed sensor on one of wheels.

Posted on Apr 21, 2010

  • 395 Answers

SOURCE: the anti lock brake light and the traction

sound's like you just need to replace the brake pad's when they get to low the sensor will come on.

Posted on May 09, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

I need a work shop manual for 2007 ford ute bf series lol xr8 where can I get one how much and postage


Where is the oil filter on a BF falcon? - www.fordmods.com

www.fordmods.com > Forums > Fordmods Tech > 6 Cylinder Workshop

Apr 16, 2012 - 15 posts - ‎9 authors
will i need to jack the front end up to get to it? ... Autobarn, Repco and Bursons should sell a BF workshop manual if you don't already have one

Mar 22, 2017 | Ford Cars & Trucks

1 Answer

Stabilizer traction control light is on, and lost cruise control


Cruise control will always disable itself when any CEL light is present, so that's normal. The Stabilitrak light problem is a known common problem with these. Your steering wheel position sensor needs to be replaced. Mine does it every morning IF my steering wheel wasn't put into a straight position when I parked it. Straighten the tires, turn the ignition off and restart. Light will go out.

Apr 02, 2016 | 2008 GMC Envoy

1 Answer

Oil light on dash of bf falcon wont go off


Need more info. Whats a bf falcon for starters?

Jan 16, 2013 | Ford Expedition Cars & Trucks

1 Answer

07 Escape vibration that goes away when turning wheel to the right. vibration starts between 20-30 mph and will only subside if the wheel is turned to the right or the car is stopped. new tires, thought...


after you have changed the control arms on the front suspension did you send it for steering geometry ( tracking )? If not,then the problem you have is your front steering alignment is out and that's why.

Sep 14, 2012 | 2007 Ford Escape

1 Answer

There a yellow triangle light on dash


This triangle might be the warning light that the traction control system is switched off. to switch traction control back on again, locate the button to the lower right hand side of the steering wheel, down beside the headlamp levelling switch. The button should read VSA OFF. With the engine running press this button and the lamp should go out. Note that in slippery conditions when the front wheels start to spin this triangle will flash as the traction control kicks in. Hope this helps. Stuartie.

Nov 09, 2010 | 2008 Honda Accord

1 Answer

When turning right car vibrates


If the traction light is on, it sure seems like a wheel bearing. Jack it up and double check.
If you're sure the bearings are OK and the wheel bolts are tight, it almost hase to be the axle shaft/CV joint.

Apr 13, 2010 | 2002 Chevrolet Impala

1 Answer

TRACTION CONTROL.


that is what it is desgined to do - reduce acceleration and apply the brakes intermittently when the wheels spin. You have a switch you cn push to disable it. You need to disable each time you start car. See owner manual.

06-10: Traction Control 1996 Contour, Mystique Workshop Manual
DESCRIPTION AND OPERATION Traction Control System The optional traction control system is designed to control wheel spin when accelerating on slippery or loose surfaces. Traction control system is available only with anti-lock brakes. The traction control system includes the following components:
  • Hydraulic control unit.
  • Throttle control actuator (9N825).
  • Traction control switch.
  • Traction control warning indicator.
  • Front brake anti-lock sensor (2C204).
  • Rear brake anti-lock sensor (2C190).
The traction control system operates as follows:
  • System functions by transferring torque from the spinning wheel to the wheel with the most traction.
  • This is achieved by applying the brake at the spinning wheel through the hydraulic control unit or reducing the throttle opening.
  • Traction control braking and throttle control occur at vehicle speeds up to 50 km/h (30 mph).
  • At vehicle speeds above 50 km/h (30 mph), only throttle limiting control is used.
  • If speed control is operating when traction control system engages the traction control system will disengage speed control through the use of a speed control relay. This action is the same as applying the brake pedal with speed control engaged.
1996 contour
Traction Control Switch The traction control switch is located on the instrument panel, left of the steering column.

Oct 22, 2008 | 1995 Ford Contour

3 Answers

Anti-lock, traction control, service soon,brake, and security lights on. anti-lock and traction control disabled. Replaces front hubs many times. coulkd it be body conroll module? 2001 olds alero


Anti-Lock and Trac Off lights are lit on my 1999 Alero, as well. They usually come on after about 5 minutes of driving, but are not always on when I start the car.

Aug 18, 2008 | 2003 Oldsmobile Alero

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

20 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ford Experts

yadayada
yadayada

Level 3 Expert

75077 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

fordexpert

Level 3 Expert

5471 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...