Question about Ford Cars & Trucks

Open Question

2010 Ford F 150 Fx4. All warning lights show one by one several times, instruments shut down while this happening.will not start until done.

Happens while driving as well usually no codes. Today code U0073.

Posted by on


6 Suggested Answers

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

A 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
The service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Good luck!

Posted on Jan 02, 2017

  • 2 Answers

SOURCE: Ford 2003 Expedition starts then shuts down

The only idea I hbave is for you to buy a OBD II sensor code reader. Know half the time the codes are generic, BUT also if you go buy a Advance auto they will read the code for you for free. And that code is the correct answer to your problem. Just make sure if your truck loses the code when you cut it off, that you don't cut it off when you get to advance auto.

Posted on Jan 28, 2009

  • 9 Answers

SOURCE: engine shut down while driving

This will need a good repair shop , not necessarily a dealer. Find one recommended by friends that can do computer/electrical work. The "no bus" means the cars computer network is losing comminication between itself. This is not a code , but you might have code(s) stored in the computer system.A repair shop can scan for any stored codes to start the diagnosis.The problem could be in the PCM (engine computer) or even the Theft deterent system. Sounds more like theft deterent because of the no crank situation. If you have the spare ignition key try it & see if anything changes.

Posted on Feb 18, 2009

  • 77939 Answers

SOURCE: vehicle shuts down while driving

have u had the crankshaft position sensor replaced?, this is the most common cause of this issue.

Posted on Feb 19, 2009

  • 93 Answers

SOURCE: 2004 fx4 4x4 f 150 trans fault code hi temp

hi there. ...i can advise you that i have replaceed several transmission fluid temperature sensors (tft) for faulty is inside transmission and can be accessed by removing pan...hope this helps!...good luck

Posted on Jun 06, 2009

  • 143 Answers

SOURCE: Error Code PO 456

vacuum leak in the evaporative emission system hard one to solve without the vehicle but could be as easy as a loose or faulty fuel cap just think the fuel tank breaths as well

Posted on Jun 08, 2010

Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

2000 Ford f-150 4.6L v8 2wd Not Starting, Theft Light Blinking

Mine did this on a 2002 F150 I ended up having to replace the instrument cluster. I ordered a used one online then had the ford dealer program it.

I would also try a spare key if you have one could be the chip inside your key too.

Good luck

Oct 06, 2017 | 2001 Ford F150 Styleside SuperCrew

1 Answer

2004 ford f150 with 5.4 eng shut off when driving and will not turn over

If it does nothing I'm thinking is a power problem... start by checking the cables make sure they sre conected good Because of the snow I'd start down at the starter if it shorted fron the snow there is prob a burnt wire down there

Jan 10, 2014 | Ford F-150 Cars & Trucks

1 Answer

My 2009 Ford Escape remote starter....i click and it beeps once..then beeps three times. Will not start or turn over engine. What does this mean or is there quick fix?.....been working good for 3 yrs.

By some strange reason it happens also if the instrument panel dim light is all way up and you have to keep your dome light switch off or it will light even if all doors are shut. I put the dim light switch into normal position and my remote starter resumed its function! Thanks to F150 forum, I found this remedy there: 2010 REMOTE START

Jan 07, 2013 | Ford Escape Cars & Trucks

1 Answer

2004 Ford F-150 extended cab FX4. 4WD problem

Your front hubs are automatic locking hubs, and the gears are hard nylon. These hubs break very easily, therefore causing you to lose your front wheel drive in 4 high, or 4 low. If you replace the hubs with "WARN (name brand) " manual locking hubs, you will never have the issue again. Of course, you will have to get out of the truck and manually lock the hubs, but they are metal gears, and much more durable. I've personally seen the issue several times, and changing the hubs has resolved the issue every time.

May 01, 2009 | 2005 Ford F-150

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

21 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ford Experts


Level 3 Expert

77939 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22306 Answers


Level 3 Expert

5651 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides