Question about Cars & Trucks
Problems are as follows, battery being draid,wont stay running, back fires,tacgauge tacs out 800 -900.
A 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
The service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Posted on Jan 02, 2017
There should be an AIS automatic idle speed motor mounted on the side of your throttle body across from or near your throttle linkage, or in that area. Usually held on with 2 torx screws. That regulates your idle up & down as needed depending on load situations on the engine, so that it doesn't stall out. Quite often they get gummed up or become defective and cause stalling. Before spending money on parts etc, (by the way, I'm told autozone will scan it free of charge for codes) I would get a spray can of throttle body cleaner, remove the AIS motor & clean the plunger & tip real good, and also spray some cleaner into the port that you removed it from, rub a little vaseline on the "O" ring at the seal of AIS motor before you re-install, and put it back in, tighten up the screws & give it a try. If it cures it great, but if it acts same shortly after running good for a while, buy new & replace. A lot of the time, this thing does not show a fault code in the computer, so it gets overlooked. Keep us posted
Posted on Jan 04, 2009
Check the alternator out put.Also the alternator could have a bad voltage regulator,or diode gone out,would cause this problem.Out put should read 13.75 to14.25 .
Posted on Aug 07, 2009
If I understand correctly the car will idle but will not drive unless you pump the gas. If that's the case then you need to have it overhauled. There are blocked lines inside that are preventing it from working properly. Hope this helps.
Posted on Nov 24, 2009
You need to check if the Idle control jets are set properly, these are the 2 screws near the base plate on this type of carburettor.
Screw them fully in, then on the primary side screw it out 2.5 turns.
On the secondary side screw this out 1.75 turns. This should get your idle up.
If this dosn't work then you have got problems with the idle jet system which means you need to pull the emulsion tubes out and jets out to clean them.
Also check that your Idle screw is screwed in enough to allow the throttle to be open enough to idle.
Hope this helps
Posted on Jul 15, 2010
Tips for a great answer:
May 06, 2016 | Cars & Trucks
Jan 23, 2016 | 1998 Ford Windstar
Oct 16, 2015 | Cars & Trucks
Dec 03, 2013 | Cars & Trucks
Jul 07, 2012 | 1985 Ford Ranger
May 29, 2012 | 1989 Dodge Spirit
Feb 26, 2012 | Cars & Trucks
Mar 21, 2009 | 1997 Jeep Grand Cherokee
Oct 07, 2008 | 1996 Dodge Ram 1500 Club Cab
13 people viewed this question
Usually answered in minutes!
Step 2: Please assign your manual to a product: