Question about Cars & Trucks

1 Answer

?97 Grand Cherokee no fire to coil fuel pump windows ignition all new parts and still won't start have power to pdc

Posted by on

1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Top Expert:

    An expert who has finished #1 on the weekly Top 10 Fixya Experts Leaderboard.

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

  • Cars & Trucks Master
  • 75,822 Answers

You make no mention of having run a engine control module fault code test, do that and see what faults are present.

Posted on Apr 26, 2017

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

2003 jeep grand cherokee will not turn over


Constant 12-volt power is applied through 40 A FUSE 8 in the power distribution center (PDC) to the engine starter motor relay and through 40A fuse 14 to the ignition switch. If the park/neutral position switch is connected to ground, turning the ignition switch to START causes 12 volts to pass through 10A fuse 31 in the junction block and the engine starter motor relay coil to close the relay and apply 12 volts to the starter. Any of the parts mentioned could be open or defective.

Apr 01, 2014 | Cars & Trucks

1 Answer

My 97 grand cherokee cranks but wont start any ideas


Check fuel pressure. If ok then go to ignition. If low fuel pressure, then its either:
  • Fuel filter
  • Fuel pump relay
  • Fuel pump
Ignition:

  1. Coil
  2. Ignition module
  3. dist. cap and rotor button if equipped. (give a good tuneup)
90% sure its fuel related

Dec 09, 2013 | 1997 Jeep Grand Cherokee

1 Answer

97 Tracker 4 door auto trans.


you must RUN the scanner/computer for easy diagnostic and fix it .
Remember the electronic from vehicle NOW is very complicated.
You can have PCM or BCM faulty, or ignition COIL, or spark plug or sensor, faulty. etc
see the diagram attached.
God bless you4b9a931c-e982-4301-88e2-cf13f140aff6.jpg

Jul 18, 2013 | Geo Tracker Cars & Trucks

2 Answers

I have a 97 dodge stratus. It won't start. Tried


Make sure it's getting fuel. Try using some ether or starting fluid. If it rumbles to life but doesn't stay running then there's a problem with the fuel delivery system. i.e.... Fuel pump, clogged filter, pressure regulator.... If the ether doesn't change the results you are getting now then it's a fire or sensor problem. Ignition coil, relays, sensors not signaling, PCM... I wish you luck. Let us know how it turns out

Nov 05, 2012 | Cars & Trucks

1 Answer

My 1987 jeep cherokee pioneer will start but then you drive to the store come back out and it will not start until it sets for 5 or 6 hours..


You may have a faulty ignition coil. Check to see if system is firing when it won't start. If you have fire it is probably fuel pump.

Aug 08, 2011 | 1987 Jeep Cherokee

1 Answer

1993 jeep grand cherokee put new sencor on, new fuel pump, new relay, coil pack and still is'nt getting any fire from coil. it just keeps cranking.


Crank position sensor mosly likey. Seems like you wasted a lot of money on unnessary parts. Crank sensor should cost about $40

Feb 24, 2010 | 1993 Jeep Grand Cherokee

1 Answer

I have a 1998 jeep grand cherokee laredo. It will turn over fine but will not start.. its not getting fire and the coil is fine.. Its also not getting fuel but i ran a wire to the fuel pump and it is also...


if your not getting spark or fuel to the engine and the ignition coil and fuel pump are good i would suspect it to be an anti-theft, or security issue. are you using a key you had just got cut??

Sep 01, 2009 | 1998 Jeep Grand Cherokee

3 Answers

1998 jeep grand cherokee will not start


Try resetting the asd "auto shut down fuse had a similar problem the jeep would crank but did not get spark or gas also check your fuel pump? and the asd relay may be bad it will prevent the jeep from getting no spark and will not fire some jeeps have security problems

Jun 25, 2009 | 1998 Jeep Grand Cherokee

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

18 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts

yadayada
yadayada

Level 3 Expert

75822 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Randy Ohler

Level 3 Expert

14585 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...