Question about Mitsubishi Cars & Trucks
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Posted on Jan 02, 2017
Water dripping on the passenger side is usually accompanied by rushing water noise during sharp turns. This is extremely common on Endeavors, and is caused by a blockage in the drain of the AC system. It can be caused by leaves/debris or insulation foam that has come loose. There is a bulletin to remove the foam and any leaves/debris under warranty (5y/60k) and install a cabin filter to prevent recurrence.
Posted on Sep 09, 2009
low power, bmw ecu has some code that starts shutting down systems on low power. so poor charging from the alternator to the battery.
this could also be a wet ecu tracking false codes.
i don't have direct experience with a series 5 but also check your ecu condition.
the ecu compartment is under the windshield on the passenger side on E36
you gain acess to it under the hood....
this compartment gets wet, the ecu lays on a flat surface in that
the bottom side of the circuit board gets wet and starts corrosion.
remove the ecu, take the bottom plate off, clean the bottom of the circuit
board with alcohol and a soft tooth brush.
you should be able to see the signs of corrosion or conductive build up.
this gunk bridges solder points doing all sort s of wierd things to your
car, including false sensor readings from asc/abs controllers and other
all the way to engine failure and worst case burnt and shorted wiring
I'm on my 3rd ecu, took me and the repair boys a few years to figure this
BTW: i would get that ecu mounted above that flat surface, use some sort
of standoff to raise it so that it is not laying in the wet.
Posted on Feb 07, 2010
Any unsolve wrong and the ECU is advise to you. Or forgetted RESET the error codes stored in the ECU.
Unplugged the negative battery few minutes, this operation reset your ECU; if this dont work, visit any auzotone or dealer shope foe reset your OBD codes.
Posted on Apr 09, 2010
Tips for a great answer:
Jul 28, 2015 | 2004 Mitsubishi Endeavor
Mar 23, 2014 | 2007 Mitsubishi Endeavor
Mar 14, 2013 | 2004 Mitsubishi Endeavor
Jun 27, 2011 | 2004 Mitsubishi Endeavor
Jul 07, 2017 | 2010 Mitsubishi Endeavor
Jul 30, 2010 | 2004 Mitsubishi Endeavor
Sep 19, 2009 | 2006 Mitsubishi Endeavor
Sep 01, 2009 | 2006 Mitsubishi Endeavor
Aug 24, 2009 | 2004 Mitsubishi Endeavor
23 people viewed this question
Usually answered in minutes!