Question about 1995 Jeep Cherokee

1 Answer

Oil pressure gauge on 1995 cherokee not working

Where is the oil pressure sending unit located on the jeep cherokee engine?

Posted by on

Ad

1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that gotĀ 5 achievements.

    Governor:

    An expert whose answer gotĀ voted for 20 times.

    Hot-Shot:

    An expert who has answered 20 questions.

  • Expert
  • 39 Answers

Right next to the oil filter

Posted on Jul 25, 2009

Ad

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya Mechanic can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repair professionals here in the US.
click here to Talk to a Mechanic (only for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

2005 jeep grand cherrokee location of oil pressure sending unit switch 4.7 l engine


its next to filter. the sender fits to the main oil gallery
like the filter too.
why not just look at the dealer parts page, find it and see.
the fsm covers this too.
page 4804 (posted many times now)


25586465-cuky5fb52wfczksibethvkr1-3-0.jpg

Mar 17, 2015 | 2005 Jeep Grand Cherokee

1 Answer

1995 jeep cherokee sport 4.0L. Oil gauge keeps sending false message ie. jumps from almost center past the highest point on the gauge. How do I fix this problem? where is the gauge sender located?


OIL PRESSURE SWITCH-I'm not sure if this is the gauge sender, though. 1995 Jeep Grand Cherokee 4WD 4.0L MFI 6cyl The Oil Pressure Switch is located: Under hood, passenger side, lower engine area, above oil pan, mounted in engine block.

Nov 01, 2010 | 1995 Jeep Cherokee

2 Answers

1999 Jeep Cherokee Sport 4.0L engine. Oil


I'm assuming the engine is still running and no engine noise has occured due to loss of oil pressure, and it is just the gauge that is not reading? If so, the oil pressure switch that is located on the camshaft sensor, could have a bad connection or the oil sensor will need to be replaced. The oil sensor is located on the left side of the engine and is mounting horizontally on the camshaft sensor housing.

Apr 08, 2010 | 1999 Jeep Cherokee

2 Answers

Where is the oil pressure sending unit on a 1993 jeep grand


on the 4.0 motor Under hood, passenger side, lower engine area, rear of distributor, mounted in engine block.
on the v8 Under hood, center, rear engine area, passenger side of distributor, mounted in block.

Feb 09, 2010 | 1994 Jeep Grand Cherokee

1 Answer

Where is the oil pressure sending unit located on a 2000 jeep grand cherokee 4.0 liter


Removal & Installation
  1. Disconnect the negative cable from the battery.
  2. Raise vehicle on hoist.
  3. Remove front splash shield.
  4. Disconnect oil pressure sender connector (4).
  5. Remove the pressure sender (2).
6eaedba.gif
Oil pressure sending unit


To install:
  1. Install oil pressure sender.
  2. Connect oil pressure sender wire.
  3. Install front splash shield.
  4. Lower vehicle.
  5. Connect the negative battery cable.

Jan 12, 2010 | 2000 Jeep Grand Cherokee

2 Answers

What causes the oil pressure gauge to fluctuate on my 2004 Jeep Grand Cherokee Laredo?


If the oil pressure is good and there is no engine noises then the oil pressure sending unit is the problem.Just replace it and you should be good.Hope this helps.Good luck.

Jan 07, 2010 | 2004 Jeep Grand Cherokee

2 Answers

Oil pressure loss


the 1st thing u do is have the oil pressure tested with a test mechanical gauge by a shop, most times it is just the oil pressure sending unit is defective, but never assume that is the problem, low oil pressure will distroy a $5000.00 engine very quickly, u can just try a new sending unit, but highly recommend a pressure test with a mechanical gauge before you run the engine anymore.

Dec 05, 2009 | 2000 Jeep Cherokee

1 Answer

No oil pressure


Sounds like sending unit, should be located by where the oil filter is.

Feb 26, 2009 | 1996 Jeep Grand Cherokee

3 Answers

OIL PRESSURE SENDING UNIT ON MY JEEP CHEROKEE 1993 WHERE IS IT LOCATED AND IS THERE A DIAGRAM OR PICTURE LOCATION FOR IT


OIL PRESSURE SENDING UNIT ON MY JEEP GRAND CHEROKEE LAREDO 1999
WHERE IS IT LOCATED AND IS THERE A DIAGRAM OR PICTURE LOCATION FOR IT

ANY SPECIAL KNOWLEDGE TO PUT IN?

Jul 30, 2008 | 1999 Jeep Cherokee

Not finding what you are looking for?
1995 Jeep Cherokee Logo

150 people viewed this question

Ask a Question

Usually answered in minutes!

Top Jeep Experts

yadayada
yadayada

Level 3 Expert

77499 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22306 Answers

Kevin Daniels

Level 3 Expert

1455 Answers

Are you a Jeep Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...