Question about Cars & Trucks

Open Question

Will not drive

Trans problem

Posted by on

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

I damaged my trans and i replaced with mitsubushi outlander trans but i got P0845 code, no reviving while driving only driving slow with low power


Trans controller must match the trans, and sometimes the ECU as well. Are you sure this swap will work?

Mar 28, 2016 | Cars & Trucks

1 Answer

2001 Isuzu Rodeo Sport Trans


you may have a broken band or a bad solenoid. most parts stores can tell you what the code is did you change trans filter

Apr 19, 2014 | 2001 Isuzu Rodeo

2 Answers

Isuzu 95 trooper4 x 4 auto trans, not up or down shifting. It will drive by shifting from L to 2nd to 3rd to drive. Four wheel drive also works by doing this shifting by hand. Check trans light...


Shift module internal to trans is not functioning properly. Take it to a good independent trans repair shop. Usually, for any internal, the labor is so high, esp for a 4wd, that you replace it with an entire reman trans. with a warranty.

Oct 15, 2013 | Cars & Trucks

1 Answer

How do you remove a transmission out of a 1995 Lincoln town car. The engines a 4.6


1 jack car up far enough to work under car use jack stands to support care during work for safety
2 Disconnect all fluid lines and electrical wires.
3 Disconnect trans from engine leave one bolt loosen on right and left side
4 place floor jack trans for support
5 disconnect drive shaft from transmission (there are two point in this process disconnect from rear axle housing an slide the drive line out from trans if this does not work disconnect drive line ujoint closes to trans also
6 Disconnect any trans linkage and supports remove bolts from
trans engine connection while supporting the trans with floor jack. while removing trans pull backward and be aware that the toque converter is in the front housing of trans and will fall out if front of trans is facing to far downward.
I recommend you use an auto manual to read up on this process before taking it on.

Oct 04, 2010 | 1995 Lincoln Town Car

2 Answers

Trans slips only on left turns. Will a new trans


Sounds less like a transmission slip as a rear end issue. What exactly happens on the turn?

May 01, 2010 | 2002 Jeep Grand Cherokee

1 Answer

2002 chevrolet suburban won't drive in reverse


It could be the linkage. Jiggle the shifter to see if that helps. When it goes in reverse the trans opens other valves to put trans fluid (under pressure) to the reverse unit. If the trans has not had a trans service every 30k or so the fluid could get dirty ans gummey. There are trans additives can claim the desolve the gum. I have donethat before and it has helped my trans. They claim no damage to the trans. - I tried it

Oct 15, 2009 | 2002 Chevrolet Suburban

1 Answer

Trans in park computor read out on dash reads it is in drive


You most likley have a bent/damaged shifter cable. Unhook it at the trans, and move the linkage, with the park brake set. Push it all the way forward, that is park. The display should change and it should start. If so you will need the cable. Good Luck

Jun 05, 2009 | 2004 GMC Envoy

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

13 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts

yadayada
yadayada

Level 3 Expert

78289 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22326 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

14405 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...