Question about Cars & Trucks

Open Question

Hi it started 2 weeks ago i had allergy conjunctivitis was on fml it didnt work. Went to eye specialist they told me chronic eye infection from allergy they told me to take prednefrin forte drops

Posted by on

Ad

3 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Ad
matney68
  • 426 Answers

SOURCE: Fan motor speeds stop, #1&2 went out 3 months

blower control module also known as blower resistor.
Replace it . You will be good to go

Posted on Nov 05, 2009

Ad
localwonder
  • 6784 Answers

SOURCE: i was trying to start

HI. This could be as simple as a faulty wire or a bad ignition switch assembly. Use the procedure below to isolate the culprit.

1.Check for 12 volts on the large wire attached to the top terminal on the starter relay. It should have battery voltage. If not, the battery, terminals or wire is bad.



2.Check the small wire on the solenoid for power when the key is in the start position. Remove the small wire on the solenoid and have a helper hold the key in the start position. Check the wire for battery voltage. If there is voltage, the starter is bad. If there is no voltage, replace the wire.



3.Check the fuse in the fuse box under the hood on the left fender well. If it is good, check the relay by pulling it out and checking for power at one terminal with the key off. If there is no power, the problem is in the fuse box between the fuse and the relay. If there is power, have the helper hold the key in the start position once again and check for power at another terminal from the ignition key. If there is power, the relay is bad. If there is no power, the starter circuit is suspect.



4.Check to see if there is power to the neutral safety switch if there is no power at the relay. Use the voltmeter to check for power with the key in start. If there is power going in, check for power going out. If there is no power going in, the security system or ignition switch is suspect. If there is power going in and none coming out, the switch is bad. If there is power coming out, the problem is between the neutral switch and the relay.



5 Remove the cover on the bottom of the steering column. Check the solid yellow wire for power when the key is in the start position. If there is no power, the ignition switch is bad.

Posted on Aug 28, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

HOw do I replace a gem module


You are not suppost to be able to. I send mine out to a specialist who removes them and installs a aftermarket one that can be used with a relay. Got told this about 2 weeks ago. Hope it helps.

Feb 27, 2015 | 1997 Ford Expedition

1 Answer

The malfunction indicator light came on about a month ago in my Suzuki Alto (2005) and I took it to the garage and was told there was a misfire in cylinder 2. I was told it was fine so they reset the light...


If the code has been a misfire in the same cylinder every time, the problem is very likely the ignition coil for that cylinder. When the ignition coil first starts to go, the malfunctions will be sporadic and therefore difficult to troubleshoot. The ignition coil can be tested for resistance on both primary and secondary windings in the coil to prove it is failing.

Oct 30, 2013 | Suzuki Alto Cars & Trucks

1 Answer

My 2001 dodge stratus does not start and I need a new motor


i dont know exactly what was to begin the main problem with your car the car didnt firev at all or it was just a quite nocking sound where? engine transmission or some where else as far as i know if the engine doesnt turn on , you could have a crank or ign. module disconnected . i would suggest ask em if they pulled out some codes, also i would start checking for ecm fuses and ignition to see if they are not blown.and about if that was their fault ask what kind of testing they performed and why the rods and shifters came loose.

May 26, 2009 | 2001 Dodge Stratus

1 Answer

Fan won't shut off-service ride & service engine soon on


Buy a scanner or go to Autozone and have them pull the codes out. get back to me with the codes and I'll figure it out for you.
But the fan could be the relay or the coolant temperature sensor and ECU that controls the circuit. Have the coolant , hoses and thermostat been changed lately. Start with those things.
Get the shop manual and test the coolant temperature sensor,relay and ECU. These are simple checks usually a visual inspectionor a little probing with a Digital Voltmeter will solve the problem.

Mar 21, 2009 | 1992 Chevrolet Corvette

2 Answers

2003 Honda Element Battery, Starter, Solenoid or Altenator


im having the same problem. I went to one place and they said I needed a new starter. So I took it to another and they said the wires to the starter were not good and needed to be replaced, they put in a new battery also. Then 2 days later it wouldnt start again. So I took it back they diagnosed it and could not find a issue with it. So the guy told me it is something electrical most probably a relay of a sort. A coworker told me to go to a electrical specialist.

Jan 26, 2009 | 2003 Honda Element

1 Answer

I got a 1997 Ford E350 7.3 run fine a week ago now its missing


hey man, check out this site. it may help.http://powerstrokenation.com/forums/showthread.php?t=19630

Dec 20, 2008 | 1997 Ford F350 Crew Cab

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

13 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts

yadayada
yadayada

Level 3 Expert

75842 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Randy Ohler

Level 3 Expert

14585 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...