Question about Ford Cars & Trucks

Open Question

Where is my PCM on a 2007 Ford Freestyle - Ford Cars & Trucks

Posted by on

Ad

2 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
  • 334 Answers

SOURCE: check engine light on, code

Hello tlcole306,

TSB 08-9-7 says to reprogram powertrain control module to latest calibration IDS release B54.8and higher or B55.1 or higher. This has been an issue for some time now.

Regards,
netvan

Posted on Feb 27, 2011

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

2007 ford taurus condensor fan not coming on with ac


Fan Control The PCM monitors certain parameters (such as engine coolant temperature, vehicle speed, A/C on/off status, A/C pressure) to determine engine cooling fan needs.
For variable speed electric fan(s):
The PCM controls the fan speed and operation using a duty cycle output on the fan control variable (FCV) circuit. The fan controller (located at or integral to the engine cooling fan assembly) receives the FCV command and operates the cooling fan at the speed requested (by varying the power applied to the fan motor).


EDGE/MKX, FIVE HUNDRED/FREESTYLE/MONTEGO, FUSION/MILAN/MKZ, CROWN VICTORIA/GRAND MARQUIS, TOWN CAR: FCV DUTY CYCLE OUTPUT FROM PCM (negative duty cycle) FCV Duty Cycle Command (NEGATIVE (-) duty cycle) Cooling Fan Response/Speed Greater than 0 but less than 5% Fan off, controller inactive Greater than 5% but less than 10% Fan off, controller is in active/ready state Edge/MKX, Crown Victoria/Grand Marquis, Town Car:
10% - 90% Edge/MKX, Crown Victoria/Grand Marquis, Town Car:
Linear speed increase from 30% to 100% Five Hundred/Freestyle/Montego, Fusion/Milan/MKZ:
30% - 90% Five Hundred/Freestyle/Montego, Fusion/Milan/MKZ:
Linear speed increase from 50% to 100% Greater than 90% but less than 95% 100% Greater than 95% but less than 100% Fan off
For relay controlled fans:
The PCM controls the fan operation through the fan control (FC) (single speed fan applications), low fan control (LFC), medium fan control (MFC), and/or high fan control (HFC) outputs. Some applications will have the xFC circuit wired to 2 separate relays.
For 3-speed fans, although the PCM output circuits are called low, medium, and high fan control (FC), cooling fan speed is controlled by a combination of these outputs. Refer to the following table.
If you don't understand these thing's listed above your best bet is to take your vehicle to a qualified repair shop . Have the vehicle checked for DTC'S - diagnostic trouble codes !
If

Jun 14, 2016 | Ford Cars & Trucks

1 Answer

My 2005 ford freestyle shuts off while driving....takes a few minutes to restart


This could be intermittent failure of the powertrain control module (PCM). Your vehicle should have a diagnostic check made to isolate the problem.

Sep 10, 2014 | 2005 Ford Freestyle

1 Answer

After an automatic transmission re-fix my Ford freestyle 2007 is showing a barometric pressure control error message. The vehicle acceleration is erratic in and out of gear. How do l solve this proble



Trouble Code: P1000

OBD II Monitor Testing Not Complete
Possible Causes:


Battery keep alive power (KAPWR) was removed to the PCM One or more OBD II Monitors did not complete during an official OBD II Drive Cycle PCM Reset step was performed with an OBD II Scan Tool

Aug 07, 2012 | 2006 Ford Freestyle

1 Answer

I have a 2005 ford freestyle the vehicle has power but will not turn over


Try TSB 06-20-07 LONG CRANKING TIME OR NO START ON INITIAL
START ATTEMPT. Have dealer reflash the PCM. Covered under regular vehicle warranty or Fed Emissions Warranty 8 years or 80,000 miles.

Dec 11, 2011 | 2005 Ford Freestyle

1 Answer

Location of ecu on a 2005 ford freestyle


Keep in mind the definitions:
* ECM = Electronic Control Module (prior 1995 computer, OBD1)
* PCM = Powertrain Control Module (1995 and newer, OBD2)


Ford Freestyle 2005 - Powertrain Control Module The PCM is located in the ine compartment, passenger side, mounted to the cowl. Removal & Installation procedure:
  1. Retrieve the module configuration.
  2. Remove the cowl panel grille.
  3. Disconnect the 3 PCM electrical connectors.
  4. Remove the bolt and the PCM.
To install:
  1. Installation is the reverse of removal.

4f23c78.gif

Hope helps (rememnber rated this).

Jul 14, 2010 | 2005 Ford Freestyle

1 Answer

I have a 2007 Freestyle. The driver's seat heated


I am having exactly the same problem (also with 2007 Freestyle). The light comes on for a short time, and then goes off.

Dec 28, 2009 | 2006 Ford Freestyle

1 Answer

Rear signal lights not working on ford freestyle 2007


Check the Bulbs the filiment might be burned out, Then also check the fuse for the turn signals. This might hellp you out

May 16, 2009 | 2007 Ford Freestyle Limited

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

20 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ford Experts

yadayada
yadayada

Level 3 Expert

76846 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22246 Answers

fordexpert

Level 3 Expert

5546 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...