Question about 2006 Mitsubishi Endeavor

Open Question

Where is the neutral safety switch located on 2006 mitsubishi endeaver?

Posted by on

Ad

5 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
  • 1810 Answers

SOURCE: neutral safety switch

it might be the switch but is likely not
rarely does a switch go usually it is a plug try shifting the car into newtrall and starting it
the switch is located in the trans though

if car is standard the switch is on the cluch pedal under the dash

Posted on Feb 11, 2010

Ad
dncholas
  • 222 Answers

SOURCE: neutral safety switch '97 eclipse

Under dash driver side look behind the upper arm of clutch pedal and you should see a green and black wire coming from the button (switch) assembly on the firewall. The wires go up above the clutch pedal. About in the middle of under dash on the left side you should see a white connector these wires run to. Disconnect. I just had the problem and not only starts now but not stalling like it was but it's only been one day but tested it pretty good.

Posted on Aug 16, 2010

  • 322 Answers

SOURCE: How do you remove and

I presume you mean the clutch interlock switch on the pedal assembly. There is no neutral safety switch for a manual transmission. The interlock switch requires the clutch to be pressed when starting.

The switch has two 12mm (or 14mm?) nuts to adjust the position of the switch. There's a wiring harness connector so the switch and short cable can be removed.

SD

Posted on Jun 13, 2011

  • 842 Answers

SOURCE: Where is the safety neutral switch on a 2009 mitsubishi galant located?

If the vehicle is a front wheel drive, the switch can be seen on top of the transmission, under the shift rod. It will have a multi electrical connector attached to it. If the vehicle is a rear wheel drive, the switch will be on the driver's side on the transmission under the shift lever. It is easy to see and quite obvious. Good-Day!

Posted on Jul 31, 2014

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

How to change trans fluid in 2006 endeaver


Some of the new vehicles You can't change the fluid the old way
You have to take them to a certified Mechanic to have the system
evacuated and new fluid pumped in. not a cheap thing.
Good Luck.

Oct 13, 2016 | 2006 Mitsubishi Endeavor

1 Answer

03 Mitsubishi Diamante reverse lights don't work.I changed bulbs/ and that's not it.I would like to know where can I find the reverse light switch. Exact location PLEASE


The reverse lights are operated/controlled by the neutral safety switch located on the transmission close to the tranny dipstick. This switch is adjustable and may correct your problem with a slight adjustment. Here is a picture that may help.

03-mitsubishi-diamante-reverse-lights-3qwhtnnac40lbettoybmikvd-5-0.gif

Oct 11, 2015 | Mitsubishi Cars & Trucks

1 Answer

Where is the safety neutral switch located on a 2009 mitsubishi galant?


It's on the transmission. The shift switch is the neutral safety switch.

Jul 31, 2014 | 2009 Mitsubishi Galant

1 Answer

Location neutral switch


neutral safety switch is generally located where the shift linkage enters the body of the transmission.

Jul 01, 2014 | 1998 Mitsubishi Galant

1 Answer

Neutral safety switch


could be just bad conection if works hevery time you wiggle the wire the switch is ok just check the conection

Oct 18, 2013 | Ford Escape Cars & Trucks

1 Answer

Where is the Neutral Safety Switch located on a 2002 Chrysler Town & Country Van?


is the neutral safety switch locatedn on the same place as on a 2006,vs 2002

Oct 29, 2010 | 1992 Chrysler Town & Country

1 Answer

Neutral safety switch


it might be the switch but is likely not
rarely does a switch go usually it is a plug try shifting the car into newtrall and starting it
the switch is located in the trans though

if car is standard the switch is on the cluch pedal under the dash

Feb 11, 2010 | Mitsubishi Eclipse Spyder Cars & Trucks

2 Answers

Neutral safety switch '97 eclipse


Under dash driver side look behind the upper arm of clutch pedal and you should see a green and black wire coming from the button (switch) assembly on the firewall. The wires go up above the clutch pedal. About in the middle of under dash on the left side you should see a white connector these wires run to. Disconnect. I just had the problem and not only starts now but not stalling like it was but it's only been one day but tested it pretty good.

Nov 16, 2008 | Mitsubishi Eclipse Spyder Cars & Trucks

Not finding what you are looking for?
2006 Mitsubishi Endeavor Logo

Related Topics:

38 people viewed this question

Ask a Question

Usually answered in minutes!

Top Mitsubishi Experts

yadayada
yadayada

Level 3 Expert

76846 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22246 Answers

Jeffrey Turcotte
Jeffrey Turcotte

Level 3 Expert

8572 Answers

Are you a Mitsubishi Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...