Question about Hyundai Cars & Trucks

Open Question

Where can i get a manuel for hyundai galleper 2000 engine ^ transmission

Posted by on

Ad

2 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

Ad
  • 1348 Answers

SOURCE: 2000 hyundai sonata auto transmission removal?

Disconnect the battery.remove the front tires.disconnect the lower control arms from the hubs.Remove the axle nuts.Swing away the hub until it clears the end of the drive axle spline.Keep it to the side.Remove the drive axles. remove the starter.remove the torque converter bolts on the flywheel.disconnect the gear linkage and all electrical connectors.disconnect the transmission cooler lines. undo the transmission mounts. use a transmission jack to lower the transmission.Installation is the reverse of the above.Be sure to torque all bolts and nuts to spec,pre load the mounts and replace the cotter pins with new ones.it should take about 5 hours to re and re the transmission.

Posted on Apr 13, 2010

Ad

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Does the Hyundai accent 2000 have a front cradle?


if it is a unibody then it will have an engine cradle or sub-frame that supports the engine and transmission. If you plan on replacing the subframe you will need to support the engine and transmission from the top side with an engine support fixture.



26303677-npphzl2gzuh4obgjeqzdintl-4-0.gif


Subframe/cradle



26303677-npphzl2gzuh4obgjeqzdintl-4-1.png

Oct 07, 2016 | 2000 Hyundai Accent

1 Answer

I have a 2000 hyundai accent 146,000 miles transmission is about two years old and there is aft sitting on top of the tranny creating a small pool on top and drips if in a slanted parking lot car still...


there is usually a transmission cooler in the front of the car. transmission fluid flows through rubber or steel lines to the trans cooler and back. those lines are commonly known to rust and leak.

Feb 18, 2018 | 2000 Hyundai Accent

2 Answers

How do I check transmission fluid levels on a tuscon


if its an automatic .there will be a dip stick near the front of the engine i think its got an orange ring pull if its a Manuel there is a hex bolt on the side of the gear box \[big enough to add fluid through a tube if you open it and clean fluid run out .then its enough .but if you open it and dirty fluid runs out then it requires changing .dont over fill .this will do more harm than good .its best to let a garage do it { a quick fit type place will do it for about 30 pounds }

Apr 02, 2011 | 2005 Hyundai Tucson

1 Answer

I have about 103,000 mi. on my 2002 Hyundai Accent and wanted to change the manuel transmission/differential gear oil. Manuel asks for 75w/90, GL-4 and can only find that weight with GL-5, that isn't...


1st GL5 has replaced the GL4, so u are stuck there, the advantages of GL5 are worth the money, as far as the coolant goes get a back flush kit and flush the block that way, Prestone makes then and they are very easy to use, they help get sludge out of the system much better than just draining.

May 18, 2010 | 2002 Hyundai Accent

1 Answer

Changing manuel transmission/differential oil


the last time I changed the oil in a manual tranny that is all I had to do, the level in mine was determined by putting an 1/8 bend in a piece of wire, add oil then check to see if you can touch the oil with the wire, when it does it is full enough.

Feb 21, 2018 | 2002 Hyundai Accent

2 Answers

DTC code-P1618 = fault in lead between aw 50-52 and motronic 4.3. what does this mean and were is it on the car . its a vovlo s 40 year 2000, made 09/99 motor is 1.9 gas auto trans


aw50-52 is the transmission. motronic is the fuel system. it means the two modules are not communicating with each other.you will need a pinout diagram for these modules and go from there.its difficult to remove computers on late volvos without the speciall tool.furthermore getting an acurate diagram other than a volvo service manuel [paper service manuels were discontinued in 2000].will be near impossible. in this case it makes sense to bring to the dealer.

Apr 18, 2010 | 2000 Volvo S40

1 Answer

2000 Hyundai elantra transmission delay, reverse going


Did you check the transmission fluid level? If necessary, add fluid. However you probably have a more serious problem. Take the car to a qualified transmission mechanic.

Dec 09, 2009 | 2000 Hyundai Elantra

2 Answers

Engine light ON


HI
IS THERE ANY PROBLEM IN ENGINE OR TRANSMISSION WORKING ??? IF YES WHAT IS THE PROBLEM ???
IF NOT CHECK IT AS SOON AS YOU HAVE A TIME BY DIAGNOSES SCAN TOOL !!!!!!

WITH MY BEST WISHES

Jul 15, 2008 | 2000 Hyundai Accent

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

28 people viewed this question

Ask a Question

Usually answered in minutes!

Top Hyundai Experts

yadayada
yadayada

Level 3 Expert

79865 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22326 Answers

Jeffrey Turcotte
Jeffrey Turcotte

Level 3 Expert

8836 Answers

Are you a Hyundai Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...