Question about Jeep Cars & Trucks
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Posted on Jan 02, 2017
put the back of car on jack stands and secure the front tires so it does not roll and then remove the bolts off the back of the caliper there is normally two one at top and one at bottom and spray it with some kind of oil for rust and make sure you have the right size socket before you try to loosen them and once caliper is off and the old pads removed take one of the old pads and squeeze the piston on the caliper back in by using a "C" clamp and also remove some of the brake fluid from the master cylinder before you do this put the new ones back on and check the brake fluid and make sure it is full and then pump the brakes to make sure you have a good pedal also put some "No Squeak" brake stop on the back of the pads so they don't squeak they will have that where you buy the pads from
Posted on Mar 01, 2009
brake pedal switch, get a wire, unplug plug, bridge circuit and check lights.
plug and switch is high up on the brake pedal not normally easy to get to.
Posted on Aug 15, 2009
there is no fuse for this I would lean toward the switch. If you want to be positive it is the switch just the switch circuit and check your ground. Switch is pretty cheep for that.
Posted on Aug 31, 2009
SOURCE: side mirrors don't work
Usually there is a switch issue. The switch that allows you to select right, left or nuetral can go bad or get dirty and not allow power distribution. If you feel comfortable doing so, remove the trim and gain access to the switch. Using a test light or the schematics, find out which wire is the voltage supply and ensure it has power with the key in the on position but the motor need not be running. If no, suspect a fuse issue, if yes then suspect a switch issue. You can use a jumper wire to apply power to the mirror feeds (again a schematic would be greatly reccomended) and if the mirrors move, viola! I hope this helps
Posted on Jul 15, 2010
you could try to locate your car fuse box,open it and inside you shoulb be able to identify what fuse to change if it is the fuse that is malfunctioning
Posted on Jan 04, 2011
Tips for a great answer:
Aug 02, 2012 | 2008 Jeep Liberty
Jul 31, 2010 | 2005 Jeep Liberty
Jul 15, 2010 | 2002 Jeep Liberty
Nov 13, 2009 | 2005 Jeep Grand Cherokee
Aug 31, 2009 | 2002 Jeep Liberty
Aug 26, 2009 | 2006 Jeep Liberty
Jan 25, 2009 | 1999 Jeep Grand Cherokee
23 people viewed this question
Usually answered in minutes!