Question about Cars & Trucks

Open Question

Fix door switch - Cars & Trucks

Posted by on

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

I have a 2005 Chevy extended cab 1500 and the controls on my driver side door aren't working. The door is saying it ajar when it's closed. I can't roll the windows up or down. Is it the master switch?


How to fix the Chev power window door lock switch - YouTube

? 5:04
https://www.youtube.com/watch?v=XDKaDURD8Sc
Jul 13, 2013 - Uploaded by spelunkerd
How to fix the Chev power window door lock switch ..... Some time later my drivers side window stopped working in the down position. ... These intermittent electrical problems are frustrating,aren't they? .... How To Install Replace Door Locks Chevy GMC Truck Silverado Sierra Yukon Tahoe Suburban ...

Diagnose Power Door Locks Dont Work Properly - Auto ...

www.auto-repair-help.com/.../diagnose_power_door_locks_dont_work_...
An inoperative power door lock can be caused by the switch, solenoid, wiring problem or ... Hi, I have a 2005 Nissan Sentra and the power locks aren't working. .... Hi, mypassenger door locks/unlocks both doors but my driver side door works independently and .... I have a 1986 Chevy Silverado K10 with auto door locks.

SilveradoSierra.com • 2003 silverado no power in right door ...

www.silveradosierra.com/.../2003-silverado-no-power-in-right-door-t30...

Dec 26, 2015 | Cars & Trucks

1 Answer

Were the buzer locate


You do not need to fix the "buzzer". You need to fix the door switch or the circuit to the door switch.

May 17, 2012 | 1991 Mercury Capri

1 Answer

How to fix the interior lights? They stay on after the doors are closed. They also stay on after the car is started. After awhile they will go off but the problem comes back as soon as I get back into the...


  • It can very possibly be the door ajar switch. But it may not need to be replaced. Them switches get dirt and crud in them as well as rust. You can spray some WD-40 on the switch and open and close the door a few times. and see if this loosens it up some.
  • If you need to replace it then this is an easy task. The switch is just a few inches below the door latch on the inside of the door frame.
  1. Remove the neg battery terminal.
  2. Remove the screw from inside the armrest.
  3. Remove the screw under the door handle.
  4. Take a torx wrench and remove the three bolts (on the side of the door) holding that hold the door latch in place.
  5. Pull the latch out and you will see the door ajar switch.
  6. Unscrew the door ajar switch and screw a new on in it's place.
  7. Now reverse to finish the job.
Regards, Tony

Jun 01, 2011 | 2000 Ford Taurus

1 Answer

I have a 2004 Dodge Neon. The dome light will not come on when the driver door is opened, but will when any other door is opened. I suspect a switch failure, but when I tried to locate a pin switch or...


The switch is located in the door catch mechanism. Check the wiring connections first in the rubber boot in the door hinge area. If they are fine, it will be the catch assy... Hope this helped.

Mar 10, 2011 | 2004 Dodge Neon

2 Answers

Dome light stays on even with door shut how to fix?


adjust he pin in the door tothe right setting

Jun 15, 2010 | 1998 Ford Ranger SuperCab

2 Answers

Disconnect sliding door chime 2005 Saturne Relay


On my 05 Relay I scratched the oxidation off of the switch heads and the contact plates on the door pillar. Worked for me.
Another fix I've read about is to take out and put back the PSD fuse. Then open and close the doors twice (with power button) for the computer to relearn the positions.

Feb 12, 2010 | 2005 Saturn Relay

1 Answer

My cars inside lights doesnt work when i open the door? or turn it off


have you checked the all the doors? if the fault is only with 1 door look for the "push" switch in the frame of the door, tp fix remove switch and earth lead going to switch, that should fix it, if all doors the feed to light from doors is defective check for a bad contact in light switch on unit, there should be 3 positions
  • one position fully off
  • 2nd position turn on manualy ( this over rides the door functions)
  • 3rd position door activation mode

Jan 03, 2010 | 2002 Honda Accord

2 Answers

97 mercury sable, overhead dome light always stays on


THERE IS A SWITCH, IT IS THE DOME/DOOR AJAR SWITCH INSIDE THE DOOR ON THE LATCH. U MUST DE-TRIM THE DOOR AND REMOVE THE REAR GLASS RUN CHANNEL TO REPLACE IT, ALSO ANYONE OF THE 4 SWITCHES CAN BE THE PROBLEM, FORD CAN TEST IT WITH A NEW GENERATION STAR TESTER AND ID THE PARTICULAR DOOR THAT IS CAUSING THE PROBLEM. PART IS ABOUT $25.00 EACH
SEE PHOTO:
5547a0a.jpg

Apr 27, 2009 | 1997 Mercury Sable

3 Answers

2003 lincoln navigator running board stay out on passanger side unless your are moving (they retract) passenger mirror does not adjust backig up message continues saying door ajar


The door switches are built in the latches on each of the doors, they are pron to sticking, leaving the security module to beleive the door is open.
The simple fix is to spray a generous amount of WD40 on, in, and around the door latches, then opening and closing the door a few times. I would start with the passenger door as`this is likely the culprit. do the rest of the latches as a prevenitive measure.

Hope this is of some help.
Ed

Apr 20, 2009 | Lincoln Navigator Cars & Trucks

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

31 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts

yadayada
yadayada

Level 3 Expert

74945 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Randy Ohler

Level 3 Expert

14585 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...