Question about Mitsubishi Cars & Trucks

Open Question


Posted by on


6 Suggested Answers

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

A 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
The service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Good luck!

Posted on Jan 02, 2017

  • 1970 Answers

SOURCE: location of low side port to install freon on 2000 Grand vitra

mcdevito75 here, The low side port of your A/C is located on one of the shiny metal lines comeing out of the firewall, they are attached to the evaporator under the dash, from the firewall carefully follow these silver lines till you reach the charge port. The port may be covered with a brass looking cap, un srew the capp and the port looks like the valve on the tire.

Posted on Jun 19, 2010

  • 836 Answers

SOURCE: low tire light is blinking on a 2005 mitsubishi

You have low air pressure in a tire, check them all including the spare which may have a sensor installed.

Posted on Jan 14, 2011

  • 977 Answers

SOURCE: mitsubishi 2004 endeavor. Transmission appears to

if the fluid level is low it can cause problems with gear shifting, top up the fluid level & see if that makes a difference.......hope this helps......cheers.

Posted on Aug 01, 2011

SOURCE: freon leaking out of low side port

You can try to tighten the valve, if you have the tool.
I don't know if a tire shrader valve tool will fit an R134a
low side port. I'm looking into that currently & getting
my tools up to speed
If you lost too much refrigerant (not Freon) that is a Dupont
name from decades ago, then you may have to have a vacuum
pulled, leak checked & recharged.
You can buy those caps with no problem almost anywhere

Posted on Jul 22, 2013

  • 3289 Answers

SOURCE: I have 2010 mitsubishi endeavor milage is only

Poor fuel economy can be an indicator for the need of a tune up, a clogged air filter, bad emission control computer or sensors, leaking fuel tank or fuel lines when under pressure (engine running), etc.

Posted on May 21, 2014

Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer


With the car running and the ac on high. Put the can fitting on to the low side of the ac line and open the can the Freon will be pulled into the sys and charge the unit. Most do it yourself kits will only fit on the low side of the ac. Hope this helps.

Apr 24, 2017 | Mitsubishi Cars & Trucks

1 Answer

Where do i put the freon on a 2010 dodge charger

The low pressure charging port is right below the High Pressure port near the Driver side Strut Tower

Jun 17, 2016 | 2010 Dodge Charger 3.5L

1 Answer

Where is the ac port located to add freon

On a 2002 Mitsubishi Montero LTD, the a/c charging port is between the battery and the windshield. It is the port that has a cap labeled with an "L" (Low Side).

When the a/c is on, "L" (Low Side) gets cold while the "H" (High Side) gets hot.

Make sure you use the Low Side (cold) for adding Freon.

(note: over the counter freon kits should not fit the High Side port anyways) 6d9ed8b1-112d-471e-93a4-44bee9a08459.jpg


May 30, 2014 | 2002 Mitsubishi Montero

1 Answer

My endeavor 2005 is turning the air conditioner off by itself

a low freon charge will cause the system to cycle a lot

Jun 05, 2012 | 2005 Mitsubishi Endeavor

1 Answer

Mitsubishi 2004 endeavor. Transmission appears to be jumping. The fluid level is low?

if the fluid level is low it can cause problems with gear shifting, top up the fluid level & see if that makes a difference.......hope this helps......cheers.

Aug 01, 2011 | 2004 Mitsubishi Endeavor

1 Answer

I bout freon for my endeavor but i dont know where to put it i need to know where it is located and how to put it in thanks!!1

not sure exactly were the service port is but, it is the port with the smallest cap that is the suction line just add the refrigerant with the car running.I would reccomend having a vacum pulled on the system before charging it.Your local shop can do this for you.

May 13, 2011 | 2005 Mitsubishi Endeavor

1 Answer

I just noticed a water retention problem with my 2010 Mitsubishi Endeavor. When it rains, especially a hard downpour, water quickly collects somewhere inside what appears to be the driver's side panels. ...

Replace the window seals on the doors friend. Get them from the dealership for that vehicle, roll the windows down, pull the old seals, minding not to lose the clips, put the clips on the new wipers and place them in the slots.

Jul 07, 2017 | 2010 Mitsubishi Endeavor

1 Answer

Low tire light is blinking on a 2005 mitsubishi endeavor

You have low air pressure in a tire, check them all including the spare which may have a sensor installed.

Jan 14, 2011 | 2005 Mitsubishi Endeavor

1 Answer

How do I recharge my 2004 mitsubishi endevours air conditioning?

have to be sure that if you need freon 134th you connect a pressure gauge in the thicker tube and read what makes you put the air conditioning running and see that the needle decendera and you have to check where the freon leak before all

Jun 24, 2010 | 2004 Mitsubishi Endeavor

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

28 people viewed this question

Ask a Question

Usually answered in minutes!

Top Mitsubishi Experts


Level 3 Expert

78267 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22326 Answers

Jeffrey Turcotte
Jeffrey Turcotte

Level 3 Expert

8836 Answers

Are you a Mitsubishi Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides