Question about Jeep Wrangler

Open Question

2010 Wrangler {stick shift rolls with handbrake applied. How do I adjust the handbrake?

Posted by on

Ad

4 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

Ad
  • 1 Answer

SOURCE: How to adjust the handbrake on a 2002 Daewoo Nubira

i think you'll have to look at the piece of felt under the casette holder lid , lift the felt up using a very fine flat ended screw driver and there should be a couple of bolts under there ! if yes , then take the lid off also , another two philips head screws . if its the same as the centre console of the 1998 model !! now , having removed the bolts , gently lift the rear end of the centre console , with a torch you should be able to see the adjuster . Make sure the hand brake is down , so put bricks under one or both of the front wheels and leave it in gear , also , do this on a flat surface !!!!
Adfter you've done the adjustment , before putting everything back together , put the console into normal position and try putting handbrake on and off , it should feel firm to lock the back brake  ! then if all is okay , put the screws back in reverse order good luck 

Posted on May 04, 2009

Ad
redbeard00
  • 957 Answers

SOURCE: i just got my handbrake adjusted in my hyundai

If the hill is steep or is covered with dirt or sand then you may not have a problem. Did you park there before and it held? Do you use the hand-brake all the time? Have there been times that you forgot to release the parking brake? When the shoes were adjusted were the shoes inspected before the adjustment? The tech. should have looked for problems.

Posted on Nov 11, 2009

  • 10865 Answers

SOURCE: After driving through a lot of wet weather in the

Hello Bill.....Begin with the WD 40. In fact you may have to treat it a couple of times over a couple of days. Joe

Thanks for choosing Fixya!

Posted on Jan 08, 2011

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Ssangyong Kyron 2010 handbrake will hold forward motion but not backward roll???


It's not expected to hold a backward roll. No hand brake will . That's why they tell you to turn the wheels into the curb to prevent a roll.Adjust the brake shoes and the cable length adjustment.

Jan 21, 2017 | SsangYong Kyron Cars & Trucks

1 Answer

1997 jeep wrangler stays in gear


97 wrangler

what does that mean, it has no clear meaning at all.
first is car a auto or stick (mines a stick)
stays in gear can mean many things,,,
1: A/t shift lever stuck in drive, you never said what gear,?
2: M/t sticks shift car, , the car moves in gear, with clutch held to floor.

i cant shift to neutral?
I cant shift to park.
I cant what? be clear. please

Jul 01, 2016 | Jeep Cars & Trucks

1 Answer

1.9vauxhall vectra C fitted new pads and hand brake cable now handbrake has too much travel same as before items were fitted


it looks like a common flaw in design
it can fail an mot if handbrake wont hold
with both wheel of the ground and hand brake fully applied do the wheels spin

handbrake cable system on a
1.9vauxhall vectra C says self adjusting

but this picture implys there is an adjustment point
source
Thread Handbrake adjust


you tube vectra handbrake system in action

Opel vectra handbreak



26219124-ygof5331xb1wvnadk5rotqyb-1-1.jpg

Jun 15, 2016 | Cars & Trucks

2 Answers

Red Handbrake warning saying Apply handbrake and not starting


I familiar with this setup, but the car should start with the parking brake on. I could see it warning you if you try to move it with brake set, or maybe even shutting off engine then, but I would never think it would prevent engine from starting. Is this a stick shift or automatic. Make sure transmission is in neutral or park, clutch depressed.

Mar 21, 2015 | 2005 Renault Laguna 1.9

2 Answers

How do i adjust my handbrake on my freelander please


Here you go,,,follow what second post down says..yours is an F1 Freelander so it applies.
Land Rover Owner View topic Handbrake adjustment

Feb 25, 2015 | 2002 Land Rover Freelander

1 Answer

How do I adj a hand break on my 2010 cleo disk breaks


Hi Jackie, 2010/2011 has drum brakes on the rear?
First up, check the rear brake shoes don't kneed adjusting, if you just adjust the handbrake, you end up with a handbrake thats not very good at holding you on a hill

Nov 22, 2014 | Renault Clio Cars & Trucks

2 Answers

Why does my jaguar xk8 stiil roll when in park


If you're trying to hold it on the auto transmission alone, then the transmission brake bands need adjusting or even replacing. If it's rolling when the handbrake (parking brake) is applied, then the handbrake needs adjusting or needs new pads.

The car should never be parked and held on the transmission alone; the handbrake should always be the primary means of holding the car from moving.

Both of these jobs are routine maintenance tasks but are not ones for an inexperienced mechanic.

Sep 21, 2010 | 1998 Jaguar XK8

2 Answers

I can't get my Gear Shift our of Park. The engine


Common problem.

In future, when on put it in park only AFTER the handbrake is applied. Ideally, foot brake, shift to N, apply handbrake, release foot brake, shift to park.

If the incline isn't steep have someone push car uphill while you gently move gearshift shift out of park. If its a steep hill, call a tow truck and move to a level surface. The parking pawl in the transmission becomes groved over time (and sticks) unless you use the handbreak as described.

Jan 29, 2010 | 2002 Jaguar S-Type

1 Answer

How to adjust handbrake cable


HANDBRAKE CABLE ADJUSTMENT

1. Raise the vehicle and release the handbrake.
2. De-adjust the handbrake cable.
  • Remove the locking pin.
  • Slacken the adjuster locknut.
  • Slacken the adjuster until the levers on the callipers have returned to their stops.
3. Paint alignment lines on the lever and caliper
4. Tighten the adjuster until the caliper levers move from the alignment lines.
5. Apply the handbrake to equalise the cable.
6. Tighten the adjuster locknut to a minimum of three clicks and a maximum of six clicks.
7. Fit a new adjuster locking pin.
8. Lower the vehicle.

Jun 04, 2009 | 2002 Toyota MR2 Spyder

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

21 people viewed this question

Ask a Question

Usually answered in minutes!

Top Jeep Experts

yadayada
yadayada

Level 3 Expert

76070 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22156 Answers

Kevin Daniels

Level 3 Expert

1455 Answers

Are you a Jeep Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...