Question about Cars & Trucks

1 Answer

My cub cadet 2146 pto won't turn on, also the key will not shut off the motor. I recently took the motor off to replace a sheared fly wheel key way.

If you get off the seat, it keeps running.

Posted by on


1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points


    An expert that got 10 achievements.


    An expert that got 5 achievements.


    An expert that has over 500 points.

  • Cars & Trucks Expert
  • 326 Answers

Sounds like you didnt replace the immobiliser chip or reprogram the new one.
Get a diagnostic test to verify

Posted on Apr 24, 2017


6 Suggested Answers

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017

michigan man
  • 3533 Answers

SOURCE: Van keeps running after turning off ignition and removing key

need to check the engine timing and to make sure you have the right octune of fuel in your car.

Posted on Apr 09, 2009

  • 1 Answer

SOURCE: Small motor keeps running even with key off and removed

Turns out it was the ABS motor!

Posted on May 19, 2009

  • 69 Answers

SOURCE: ignition key won t turn. steering wheel locked

the key may be worn badly or the ignition needs to be replaced.

Posted on Jul 31, 2009

  • 79 Answers

SOURCE: both motor fans keep running after car is shut off

Faulty fan relay, little square box, costs an arm and a leg. Try the local automotive parts recycler, you can't get BWM parts at the junkyard :)
The little box is located, with teutonic efficiency, next to a bunch of little boxes just like it. Check your owner's manual or a shop manual for which one it is.

Posted on Sep 04, 2009

  • 1028 Answers

SOURCE: 2000 ford excursion What is making my blower

Blower motor short to ground.

Posted on Mar 01, 2011

Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

I have a cub cadet rzt zero turn mower with a 23 hp Honda engine in it that will start up fine but seems to bog out and cut off when pto is engaged but will immediately start back up

First of all, you want to make sure the fuel filter is installed correctly. Then the filter may be restricting the flow. To solve the problem, you half choke the carb. That should take care of it.

Nov 11, 2017 | Honda Cars & Trucks

1 Answer

Hello, I have a Cub Cadet 2146, and the fuses behind the dash keep blowing.

unplug the lights at the ignition switch or solenoid.... get up earlier and stop mowing in the dark. run a new wire and put some heat shrink on it where it passes next to rub zones... hunting down a worn wire is a pain.

Oct 21, 2017 | Cars & Trucks

1 Answer

1988 chevy pick up 5.7 some times when I turn the key it wont start I have to turn the fly wheel a inch or so for it to start any I dear what it might be

There are teeth on the fly wheel and you may have broken one or more teeth. You may have to replace the fly wheel. When you turn the fly wheel by hand you make the good teeth so the starter will work.

Jun 14, 2017 | Cars & Trucks

2 Answers

What is the push button on the dash of a Cub Cadet 582 riding mower

I think it engages the PTO clutch for the mower deck

May 29, 2017 | Cars & Trucks

1 Answer

2008 cub cadet rzt 50 run for 20 min than dies while mowing put new pump on, new fuel filter, new air cleaner, new plugs. has a 22hp kawasaki engine. fuel lines clear

When it stalls out did you check the spark? I suspect the engine is losing spark due to an ignition system failure.

May 17, 2017 | Cars & Trucks

1 Answer

Cub cadet zero turn 44"

You can get that from Cub Cadet's website

Dec 06, 2016 | Cars & Trucks

1 Answer

My mariner 60hp 2 stroke motor is playing up. When I turn the key over it makes a horrible high pitch grinding noise and won't start. The starter motor is engaging with the fly wheel but slipping on...

not sure what holds the gear to the shaft i would start with looking for a spring pin or pin the held the gear to shaft it may have been sheared off if so try and line it back up and use a punch and hammer to knock it out but please dont go crazy on it and bend the shaft

Oct 13, 2014 | Cars & Trucks

1 Answer

2000 olds alero cranks then makes a metal grinding sound and won't start

You need to have your flywheel: replaced.Your starter motor engages against the fly wheel at the back of the motor. Every time your motor stops it tends to be in the same few positions (just the way things work) so there is more stress on some parts of your fly wheel than others. Because of this the teeth wear out on the fly wheel which means the starter can correctly engage on the fly wheel which is the grinding noise.

Jan 18, 2013 | 2000 Oldsmobile Alero

1 Answer

Sierra 1500 wont turn over 350. locked up???

Have the battery tested for a dead cell. It may test at 12 volts but that doesn't mean there isn't a dead cell. Also, if the motor has good compression you probably shouldn't be able to turn it over by hand at the fly wheel. Maybe an old school motor with V belt, but not a newer motor with all those accessories attached to the front.

Mar 14, 2010 | GMC Sierra 1500 Cars & Trucks

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

47 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts


Level 3 Expert

80531 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22326 Answers

john h

Level 3 Expert

15360 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides