Question about Cars & Trucks

Open Question

122-465R515 carbureter connection how - Cars & Trucks

Posted by on

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

I have a 1986 travel air with a 460 if it sit more then a day I have to pump an pump it but once it starts I can shut it off and it will start write up again


Sounds like a fuel problem. If it is throttle body injection, check fuel pressure-should be around 15-20psi, I think, but you might check the specs for that.
If it is carbureted, pull off the line at the carb and check flow and volume. It should spurt out and reach about a pint in a minute. The pressure on carbureted engines is low, about 5-7psi. The mechanical pump on carbureted engines is on the engine block. Maybe the arm for the pump is worn, or diaphragm has a small hole?

May 26, 2017 | Cars & Trucks

1 Answer

Car keeps flooding


is your car fuel injected or carburetted? if you say flooding i assume you have a carburetor, my only problem is your car is '05 which is usually fuel injected. but let's say it is carburetted, open carburetor and clean, check float valve for debris which prevent it from closing when reservoir is full, flooding occur when this happen. diy or have a mechanic do it for you.

Dec 11, 2013 | 2005 Mazda RX-8

1 Answer

Mercury cougar stalls after 25 miles


It is most likely Carbureter Iceing. Most likely the "heat riser" has been disconnected from either end (where it attaches to the Air Cleaner, or where it connects to the Exhaust Manifold.

Jun 04, 2012 | 1999 Mercury Cougar

1 Answer

Vacuum hose diagram for 89 honda prelude


Hi there:
I suggest check this links, according with the fuel system:
- Fig. 62: Vacuum hose routing-1989 carbureted Prelude (except California)
- Fig. 63: Vacuum hose routing-1989 carbureted Prelude (California)
- Fig. 64: Emission component schematic-1989 carbureted Prelude
- Fig. 65: Vacuum hose routing-1989 fuel injected Prelude


Hope this helps; also keep in mind that your feedback is important and I will appreciate your time and consideration if you leave some testimonial comment about this answer.

Thank you for using FixYa, have a nice day.

Dec 21, 2011 | 1989 Honda Prelude

1 Answer

Need vacuum hoses diagrams 1989 toyota corolla


Hi, please pick the right diagram for your engine:

Carbureted engine, not California

jturcotte_2062.gif

jturcotte_2063.gif


Carbureted engine, California:

jturcotte_2064.gif

jturcotte_2065.gif



Fuel injected engine:

jturcotte_2066.gif

jturcotte_2067.gif

Aug 11, 2011 | Toyota Corolla Cars & Trucks

1 Answer

There is no vacuum diagram under the hood on my 1986 honda civic hatchback 1.3 engine. Can anyone supply one for me?




Fig. Fig. 8: 1986-87 Civic/CRX-all carbureted models

429f29b.jpg


Fig. Fig. 9: 1986-87 Civic/CRX-all 1.3L carbureted models

0bea7ed.jpg
Hope this helped (remember comment and rated this).

Apr 28, 2010 | 1986 Honda Civic

1 Answer

Puting vac hoses back on and carberater on a 1984


The engine and emission control system covered by this information operate on a combination of vacuum and electrical signals; they are extremely prone to malfunctions due to improper vacuum connections. If a component does not receive vacuum at the correct time, it cannot function when needed. When working under the hood, pay close attention to the routing and placement of every hose.

7cdf20d.jpg

Fig. 1: The vacuum hoses are usually numbered for easy identification

8afbc6f.jpg

Fig. 2: Vacuum hose routing-1984-85 carbureted Prelude


958e655.jpg


Fig. 47: Emission component schematic-1984-85 carbureted Prelude




Hope this helped; TY for using Fixya (remember comment and rated this).



Apr 01, 2010 | 1984 Honda Prelude

1 Answer

What is the 1987 pontiac fiero gt v6 check engine light code list?


CODE 12- NO DISTRIBUTOR REFERENCE PULSES ECM. CODE 13- OXYGEN CIRCUIT. CODE 14- COOLANT SENSOR HIGH TEMP CODE 15- COOLANT SENSOR LOW TEMP. CODE 21 - THROTTLE POSITION SENSOR VOLTAGE HIGH.CODE 22 - THROTTLE POSITION SENSOR VOLTAGE LOW.CODE - 23 MIXTURE CONTROL SOLENOID.FOR CARBURETOR ENGINE. CODE 24 -VECHICLE SPEED SENSOR. CODE 32 - BARO CIRCUIT LOW.CODE 32 - FUEL INJECTED EGR VALVE VACUUM SWITCH SHORTED TO GROUND.OR EGR VALVE SOLENOID CIRCUIT OPEN. CODE 33 - MAP SENSOR.CODE 34 - VACUUM SENSOR OR MAP SENSOR.CODE 35 - IDLE SPEED CONTROL. CODE 41 - EST CIRCUIT. CODE 42 - ELECTRONIC SPARK TIMING.CODE 43 - ELECTRONIC SPARK CONTROL UNIT. CODE 44 - LEAN EXHAUST.CODE 45 - RICH EXHAUST. CODE 51 - PROM OR MEM CAL.CODE 52 - CALPAK. CODE 53 -EGR VALVE CARBURETED ENGINE THE EGR VALVE VACUUM SENSOR HAS RECEIVED IMPROPER EGR VACUUM. CODE 54 - M C SOLENOID CARBURETED ENGINE MIXTURE CONTROL SOLENOID SHORTED OR FAULTY ECM.CODE 54- FUEL INJECTED ENGINE FUEL PUMP VOLTAGE IS LOW.CODE 55 - ECM MAKE SURE PCM GROUND CONNECTIONS ARE TIGHT.IF OKAY.REPLACE THE ECM.

Mar 27, 2010 | 1987 Pontiac Fiero

1 Answer

Where is the MAF sensor located on a 1988 Chevy GMC truck


are you sure this vehicle isnt carbureted? carbureted engines dont have maf sensors. if it has a maf sensor, it will be in the intake ducting somewhere between the throttle body and the air filter.

Mar 23, 2010 | 1989 GMC Sierra

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

24 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts

yadayada
yadayada

Level 3 Expert

75051 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

Randy Ohler

Level 3 Expert

14585 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...