Question about Cars & Trucks

1 Answer

It won't turn over or make any noises but I have power and all the fuses are good

Posted by on


1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points


    An expert that got 20 achievements.


    An expert that got 10 achievements.


    An expert that got 5 achievements.

  • Cars & Trucks Master
  • 13,762 Answers

What make , model an year an engine size

Posted on Apr 23, 2017


1 Suggested Answer

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

A 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
The service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Good luck!

Posted on Jan 02, 2017


Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

1990 Ford f250 brake lights and turn signals won't work - checked all fuses, flasher and bulbs and all are good, what could problem be??

Well the brake light and turn signal circuits are on two different fuses, but they both go thru the turn signal switch.
So I would start by checking for power in and out of the turn signal switch for each circuit.

Apr 07, 2013 | 1990 Ford F250

2 Answers

Car turns over but won't start fuel injector fuse and ignition fuses are good but no power is getting to them. also the stereo and wipers only work when ignition is on accessory. when its on r

Sounds like it could be a bad ignition switch-the electrical part, not the lock cylinder. When key is in the on position (run), those fuses should be powered. Are all the maxi-fuses good? They distribute power throughout the car's electrical circuits-like the fuse panel, for instance, so check the maxi-fuses. If good, probably the ignition switch is bad.

Apr 03, 2013 | 1997 Pontiac Grand Am

1 Answer

Focus 1.8 tdci 2009 won't start dash lights go crazy noise from fuse box

check your battery cables for corrosion clean them and start the engine

Mar 25, 2013 | Cars & Trucks

1 Answer

Clicking noise coming from the fuse box "under the dash" when I turn on the heat, now car won't start.

that item is called a relay switch. it toggles on and off depending on which electrical component it is connecting. if it's blown, they are cheap and easy to replace like a fuse, but you'll need to look at the fuse box chart (usually on the underside of the lid) to determine which one and where it's located. You can't look inside the relay to determine if blown, but you can replace them one at a time to test...
Also, if you're experienced in electrical, a paper clip can be used when the relay is out, to connect the circuit that you need. use tools and or gloves when attempting this method.

Jan 17, 2018 | 2003 Ford Taurus

1 Answer

My asb light comes on when starting and stays on. Lights won't come on , power locks won't work, power windows won't work, radio won't work. All fuses are good and car runs fine.

Those are all really common symptoms of the alternator going bad on those cars. I would have it checked to make sure it's charging properly.

Dec 15, 2012 | 1996 Oldsmobile Cutlass Ciera

2 Answers

Daughters Car Won't Start

did u disconnect he ground on the battery,berfore changing th swicth, ther are two fuses / relay . one under dash and one under hood. if ther good ther is a back up fuse to comp. 7.5 read cover to be sure . take out for 10 min. replace and see if it helpes if not u may hav melted wires somewere. solenoid to to starter. good luk claymister

Dec 01, 2011 | 1990 Ford Thunderbird

1 Answer

My car will not start my lights, radio work its not the battery. I recently replaced the starter, the altenator, battery, fuel pump catalyic converter. when i turn the key there is no noise it won't...

Sounds to me like the starter or starter relay, OR did you check all the fuses? When the starter doesn't click or turn over the engine it is likely a problem with it or the power supply to it. Start with the easy thing. check the fuses, then the relay.
The P0300 is usually caused by something other than the spark plugs or coils. A fuel/oxygen sensor can cause this code. I would say that doesn't have anything to do with not starting.
Good luck.

Thanks for using FixYa.


Jul 22, 2011 | Ford Expedition Cars & Trucks

1 Answer

Starter shorts when turning key from "on" to

Check all ground wires and make sure they are tight. Start at the battery, starter, solenoid switch.

Dec 15, 2017 | 2005 Scion xA

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

16 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts


Level 3 Expert

77947 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22306 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

14405 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides