Question about Saab 9 3

Open Question

2008 Saab 9-3 Aero 6 speed auto what is the total capacity of fluid with torque converter drained and transmission totally drained?

Posted by on

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

  • 321 Answers

SOURCE: 727 torqueflite transmission fluid capacity

About 3 quarts,then check with engine running and in Neutral.

Posted on Aug 10, 2008

  • 1 Answer

SOURCE: key replacement cost 2008 Saab 7x aero

Is it just a "physical" fit problem?
Because if it is merely this and not your electronics you could always buy another key on ebay like this
http://cgi.ebay.com/ebaymotors/ws/eBayISAPI.dll?ViewItem&item=310130782609

.......then all you would have to do is pop open the casing like you were going to remove the battery, instead pulling the little circuit board also and replacing it with your own one in your damaged fob!!

Posted on Mar 30, 2009

  • 93 Answers

SOURCE: green hydralic liquid coming from convertible top saab 2004 9-3

You are probably leaking hydraulic (ATF) fluid.
Check the lines and cylinders for leaks. Replace any leaking lines or cylinders. Always replace them in pairs.
When the leak is fixed...
Behind the rear seat is the motor/pump/reservoir.
With the top down, fill the reservoir with ATF.
Cycle the system a few times.
Repeat till the reservoir will accept no more fluid.
You can change it to a manual top by removing the bolt at the top of the cylinders and lowering the both shafts down into the cylinders.

Karl at topgunwon.com

Posted on Jan 25, 2010

  • 429 Answers

SOURCE: Fluid capacity of a 4 speed auto in 1998 cavalier?

9.5 quarts
The check hole is located near the oil drain plug.

Posted on Jan 26, 2010

popsgifts
  • 160 Answers

SOURCE: Where is the cabin air filter on a Saab 9-3 Aero

Open the hood and you see the wide, black, flat plastic cover that goes all the way across just under where the windshield wiper blades are?

On the passenger side, remove the piece of rubber weatherstripping by gently pulling it out partly. Remove the black plastic screw at the passenger edge of the big black piece.
Gently pry the black foam up but hold the connecting side down with your other hand so you don't rip it off.

Lift up the big black plastic tray like piece. See the filter?

Remove the filter by lifting up the 2 clips at the top. Don't break it off. They are hinged at the top and swing up (just the opposite of the post office blue mail boxes which have the hinge below and swing open). Then take off the filter.

Wipe the area with a damp cloth to do general cleaning and then put a new filter in. Look at the arrow to fit the filter in the correct direction (it draws air forward and pulls it to the passenger compartment)

Posted on Apr 05, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

How quarts of Trans Fluid will fill the transmission???


Chevvy Malibu

CAPACITIES: Engine, with filter..........5 quarts [1]
Cooling System, Initial Fill..........7.5 quarts
Passenger Car & Light Truck Antifreeze & Coolant
AMSOIL Antifreeze and Engine Coolant
Automatic Transmission, 6T40 Initial Fill..........6.3 quarts
Automatic Transmission, 6T70 Initial Fill..........6.3 quarts
Automatic Transmission, Total Fill
6 speed 6T40..........9 quarts
6 speed 6T70..........9.5 quarts
[1] After refill check oil level.

May 04, 2016 | Cars & Trucks

1 Answer

How many quarts of transmission fluid does a 99 Chevy Cavalier 2.0 4 cylinder transmission require?


Automatic Transmission Fluid Capacities Automatic Transmission 3-Speed Pan Removal and Replacement 4.0 quarts After Complete Overhaul 6.9 quarts When draining or replacing torque converter, more fluid may be needed. Manual Transmission Fluid Capacities Manual Transmission 4-Speed Automatic Transmission Not Owner Serviceable Complete Drain and Refill 2.0 quarts

Jun 07, 2014 | Cars & Trucks

1 Answer

How many qts of oil do i need


Depends on your engine.

1980 JEEP CJ-7 2.5L 4-cyl Engine Code [B]
CAPACITIES
Engine, GM without filter..........2.4 quarts[1]
Wix Filter ........ 51040
Cooling System, Initial Fill..........8.0 quarts
Automatic Transmission, A904, 30RH Initial Fill..........4.0 quarts[2]
Automatic Transmission, A999, 32RH Initial Fill..........4.0 quarts[2]
Automatic Transmission, Total Fill
3 speed A999, 32RH..........8.4 quarts
3 speed A904, 30RH..........7.0 quarts
Manual Transmission, 4-SPD, SR-4..........3.0 pints
Manual Transmission, 4-SPD, T176..........3.6 pints
Differential, Front..........2.5 pints[3]
Differential, Rear..........4.9 pints
Transfer Case,..........4.0 pints

1. Add extra oil when replacing filter. After refill check oil level.
2. With engine automatic transmission operating temperature, shift through all gears.
Check fluid level in NEUTRAL and add fluid as needed.
3. 1984-1992 Models with command-Track, add 5 oz of 75W-90 GL-5 to shift motor housing opening.

TORQUES
Oil Drain Plug.....25 ft-lbs
Manual Transmission T176
Fill Plug.....15 ft-lbs
Drain Plug.....15 ft-lbs
Manual Transmission SR4
Fill Plug.....20 ft-lbs

1980 JEEP CJ-7 4.2L 6-cyl Engine Code [C]
CAPACITIES
Engine, without filter..........5.0 quarts[1]
Wix Filter..... 51522
Cooling System, Initial Fill..........11.0 quarts
Automatic Transmission, A904, 30RH Initial Fill..........4.0 quarts[2]
Automatic Transmission, A999, 32RH Initial Fill..........4.0 quarts[2]
Automatic Transmission, Total Fill
3 speed A999, 32RH..........8.4 quarts
3 speed A904, 30RH..........7.0 quarts
Manual Transmission, 4-SPD, SR-4..........3.0 pints
Manual Transmission, 4-SPD, T176..........3.6 pints
Differential, Front..........2.5 pints[3]
Differential, Rear..........4.9 pints
Transfer Case,..........4.0 pints

1. Add extra oil when replacing filter. After refill check oil level.
2. With engine automatic transmission operating temperature, shift through all gears.
Check fluid level in NEUTRAL and add fluid as needed.
3. 1984-1992 Models with command-Track, add 5 oz of 75W-90 GL-5 to shift motor housing opening.

TORQUES
Oil Drain Plug.....30 ft-lbs
Manual Transmission T176
Fill Plug.....15 ft-lbs
Drain Plug.....15 ft-lbs
Manual Transmission SR4
Fill Plug.....20 ft-lbs

1980 JEEP CJ-7 5.0L 8-cyl Engine Code [H]
CAPACITIES

Engine, without filter..........4.0 quarts[1]
Wix Filter..... 51258
Cooling System, Initial Fill..........13.0 quarts
Automatic Transmission, A999, 32RH Initial Fill..........4.0 quarts[2]
Automatic Transmission, A904, 30RH Initial Fill..........4.0 quarts[2]
Automatic Transmission, Total Fill
3 speed A904, 30RH..........7.0 quarts
3 speed A999, 32RH..........8.4 quarts
Manual Transmission, 4-SPD, SR-4..........3.0 pints
Manual Transmission, 4-SPD, T176..........3.6 pints
Differential, Front..........2.5 pints[3]
Differential, Rear..........4.9 pints
Transfer Case,..........4.0 pints

1. Add extra oil when replacing filter. After refill check oil level.
2. With engine automatic transmission operating temperature, shift through all gears.
Check fluid level in NEUTRAL and add fluid as needed.
3. 1984-1992 Models with command-Track, add 5 oz of 75W-90 GL-5 to shift motor housing opening.

TORQUES
Manual Transmission T176
Fill Plug.....15 ft-lbs
Drain Plug.....15 ft-lbs
Manual Transmission SR4
Fill Plug.....20 ft-lbs

Oilman

Feb 02, 2013 | 1984 Jeep CJ7

2 Answers

How much fluid do i need for my 2001 potiac grand am se 4 cylinder


It has a capacity of 5 quarts of SAE 5W30 oil with filter change. The cooling system capacity is 2 3/4 gallon of a 50/50 mix of antifreeze and distilled water. The 40T40E transmission/torque converter holds a total capacity of 12.9 quarts or 6.9 quarts to just drain the pan and replace the fluid.

Jun 11, 2011 | 2001 Pontiac Grand Am SE

3 Answers

How much transmission fluid is in a 1999 jeep wrangler. want drain and flush trans completely and replace all fluid


Unless you have a flushing machine you will not be able to empty the torque converter.If you have a 3 speed auto you are looking at 9 quarts total.If you have a 4 speed transmission you are looking at 10 half total.Be sure you check the fluid in neutral and not park.

Feb 14, 2011 | 1999 Jeep Wrangler

1 Answer

What is the fluid capacity of the gear oil in a 1997 nissan 5 speed 2 wd truck


CAPACITIES
Engine, 2WDwithout filter..........3.5 quarts[1]
Engine, 4WDwithout filter..........4.0 quarts[1]
Cooling System, Initial Fill..........8.5 quarts
AMSOIL Antifreeze and Engine Coolant
Automatic Transmission, Total Fill..........7.4 quarts
Manual Transmission, 2WD..........4.2 pints
Manual Transmission, 4WD..........8.4 pints
Differential, 2WD Rear..........3.2 pints
Differential, 4WD Rear..........2.7 pints
Differential, Front..........2.7 pints
Transfer Case,..........4.6 pints

1. Add extra oil when replacing filter.
refill check oil level.

TORQUES
Oil Drain Plug.....22-29 ft-lbs
Transfer case
Fill Plug.....18-25 ft-lbs
Drain Plug.....18-25 ft-lbs
Manual Transmission
Fill Plug.....18-25 ft-lbs
Drain Plug.....18-25 ft-lbs

Oct 17, 2010 | 1997 Nissan Pickup

1 Answer

Changing trans fluid & filter wanting to know how much fluid to buy


2.5L engine - 8.4 qts, 3.0L & 3.8L engines – 12.8 qts.

The capacity specifications are if the transmission is totally empty, and here's the clincher for us average types: including the torque converter and radiator tank.

For us average types, even when doing a transmission fluid / filter change, it does not end up with an empty torque converter.

When you pull the transmission pan for the fluid/filter change, you end up with 4-6 quarts on average. The rest is still up inside the torque converter.

Measure what you drained and start with refilling that amount to put back in to return levels back to normal.

Simply use the dipstick to check level and add as is necessary.

NOTE: This is one of the points of distinction to having the transmission "flushed" - where a professional shop is going to hookup specialized equipment to achieve a full fluid exchange, or you do the flush yourself

Jan 07, 2010 | 1993 Ford Taurus

3 Answers

What is the full capacity for transmission fluid fora 5.7L 2005 chrysler 300


TRANSMISSION FILL
To avoid overfilling transmission after a fluid change or overhaul, perform the following procedure:
  1. Verify that the vehicle is parked on a level surface.
  2. Remove the dipstick tube cap.
  3. Add following initial quantity of Mopar ATF +4, Automatic Transmission Fluid, to the transmission:
    1. If only fluid and filter were changed, add 5.0 L (10.6 pts.) of transmission fluid to transmission.
    2. If the transmission was completely overhauled or the torque converter was replaced or drained, add 7.7 L (16.3 pts.) of transmission fluid to transmission.
  1. Check the transmission fluid and adjust as required

Dec 06, 2009 | 2005 Chrysler 300

2 Answers

How many quarts of transmission fluid does it hold


You didn't state what size engine you have.
The 2.2 engine----- 6.9 qts.
The 2.3 engine-----7.4 qts.
The 2.4 is 7.4 qts.
The 3.1 is 7.4 qts.
The 3.4 is 6.9 qts.
These are the capacities for refilling after being drained.

Nov 17, 2009 | 2001 Pontiac Grand Am SE

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

16 people viewed this question

Ask a Question

Usually answered in minutes!

Top Saab Experts

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

yadayada
yadayada

Level 3 Expert

75066 Answers

rgbypoet

Level 2 Expert

166 Answers

Are you a Saab Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...