Question about Vauxhall Cars & Trucks

Open Question

How do i remove the door pannel drivers door on a 58 plate vauxhall vectra 1.9 CDTI

I have removed three screws at the bottom of the door I cannot see any other screws, I have a problem where by I cannot open the door from the inside

Posted by on

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
goodluck!

Posted on Jan 02, 2017

frcs68
  • 1605 Answers

SOURCE: How do I remove driverside inside door panel ?

door panel is holding by dozen plastic push pins.
strat from the button. use a screw driver or putty knife. pull the panel towards you. be careful not to damage the push pins. go around the panel toward the door hinger then the otheer direction toward the lock.once you have panel seperated from the door. push up the panel to clear the glass. (it is easier if the window is all the way down). pull back the plastic (don't destory it). you need to put that back later. now can get access to the galss and what ever else you are looking for.

Posted on Apr 02, 2009

mechanicm639
  • 253 Answers

SOURCE: driver door panel removal and re-connect door pull

You most likley have a damaged inside door handle. To remove the door panel, you must first remove the handle bezel. The trim piece around the handle. It is held in place by 4 retainer tabs, take a small flat screw driver, insert it between the bezel and handle. Gently pry away from the handle. If you look in the crack around the handle you will see the tabs. When you get that off, remove the switch assembly by prying up on it gently, unplug the wiring. There are 2 screws in the door panel where you pull the door shut, remove those also. Start at the bottom front of the door panel, pull outward firmly, but not violent. The retainers will come out, you will most likley break some, this is common. The inside handle is about $45 from your dealer. If it is the handle it is held in with 1 rivit, drill it out with a 3/16 drill. Replace the handle, reassemble. Good Luck.

Posted on May 05, 2009

  • 318 Answers

SOURCE: 2002 Toyota Rav4 remove door panel

There are some hidden screws around the door handle but you get under the panel and yank hard to pop the fasteners. Also remove the black piece behind the mirror. Alot of times it is seperate. 3 screws behind that and the connector and you are done.

Posted on Jul 22, 2009

  • 753 Answers

SOURCE: Removing the door panel from a 97 Chevy S-10 pu truck

The center section does come out it has little tabs front and rear you have to bend it very carfully.GOOD LUCK

Posted on Sep 16, 2009

Testimonial: "Guru thanks, that worked. Panel off but can't access the back side of the exterior door handle to replace the screws that hold it on? Any ideas? "

  • 1 Answer

SOURCE: removing inside door handle

i have a hyundai accent 2001 and i need to find fm stations manually.

Posted on Mar 06, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Fuse pannel diagram vectra 1.9cdtistorage space fuse box layout


this is in the operators guide, lost that< in glove box?>
if yes get one.
if not find one, get the FSM, the FSM covers it all.
no year, stated, so impossible to help.

Jul 14, 2014 | Vauxhall Vectra Cars & Trucks

2 Answers

How to reattach driver side side mirror to car


there is no limit to damage
is it dmaged?
if not, the side card must come off.
remove knobs, remove side cards on door, and see mounts.

you tube has like 1000 of vids showing card romoval, most
cars are same ,
my suz, you pull from bottom up, pop, pop, goes the friction rivets.
then the rag trick for the knob (manual windows) clip
if electric, see screws, some are hidden.
my 04 has hidden screws behind the door lever plate.
and in door arm rest.
you could just RTM.

http://www.scantool.net/software/alldata-diy-1-month-subscription.html

Aug 04, 2013 | 1996 Geo Prizm

1 Answer

Vauxhall vectra 2006 looses power


have you had the fuel regulator checked a leaking vacuum hose that controls this can make it do this or it is faling.

Jan 26, 2013 | Vauxhall Cars & Trucks

1 Answer

Fault code c1523 on a vauxhall vectra 1.9 cdti


what does this code mean on my vectra c c1523

Sep 01, 2012 | Vauxhall Cars & Trucks

1 Answer

2006 Vauxhall Vectra 1.9 cdti 150, The internal heater fan is stuck on. anybody know were the relays are for this.


check the temperature sensor in the head ,i would imagine the relay is in the power distribution box under the bonnet but which one ? cant say i have done one as yet to know

Apr 28, 2012 | Vauxhall Vectra Cars & Trucks

1 Answer

Diesel filter location vectra v6 cdti


It is an internal / insert paper filter, follow the fuel lines to the housing.

Special tools required to remove & refit, the new filter will damage if touched by fingers!!

Feb 20, 2012 | 2003 Vauxhall Vectra

1 Answer

How do i remove the wing mirror (power adjust & power fold) on the ford f250 super duty?


Roll the window down first, you will need 2 hands. Pull the small cover off that is at the top front of the door pannel. You will then disconnect the wire connector and remove the three 11mm nuts that are holding the mirror in place. Pull mirror out and replace.

If you dont have just that little pannel you will have to remove the door pannel. If you dont have power windows pull the cover out on the window crank and move it to the side, there will be a screw holding the crank in place. Remove it. If you do have power windows remove the window control switch plate (it will just pop up using a small screwdriver) and disconnect the wires. If equipped, remove the front door trim panel reflector or the courtesy lamp lens. Then remove the screws. DO NOT pull directly outward on the door pannel, something will brake. Remove the front door trim panel by pulling it straight upward.Lift and remove the front door trim panel. Then the nuts holding the mirror will be visible, remove and replace the mirror.

Dec 07, 2010 | 2000 Ford F250 Super Duty Crew Cabs

1 Answer

Front passenger door power window came down after door slam.


Thier is a Metal panel behind the door panel.
Both need to be removed

Yes. If your window has fallen down and will not roll up.
99% Chance you car is suffering the Infamous VW plastic clip.

The door panel comes off With a T-10 torx or a Hex (Allen) wrench
that will fit and A large Philips Screw Driver..

Remove the Plastic cover on the inside Door handle.
And the Screw or Screw along the Bottom of the door panel.
Then remove the screws that hold the handle the the door.
They are located behind the Plastic plate you removed with a tiny screw driver earlier... Be careful not the mark up the cover whaytprying it up. It is best to pry from underneath. Where marks if made can not be seen

After the screws are out 4 I believe. The Use of a CLip tool ir best.
For getting behind the panel to pop it off. A screw driver will work.

After all the clips are released. Pull the light at the bottom of the panel down and out. Disconnect it ur push it back thought the hole it came from..

Now you need a 10mm socket, or wrench to remove the 12 bolts that hold the metal plate to the Door. Remove all the 10mm bolts, If the widow has not already fallen in the door. It should be released. By removing the Black 2" plugs. THe loosen the bolts that clamp the window the the arms. DO NOT LOOSEN THEM ALL the way, .
Disconect the all the wiring.. THe Door lock cable,can be a pain.
I think it pulls down,.
Next remove the Metal plate. that is the regulator.


reverse to install

SKETCHLAB.com

Jan 11, 2009 | 1999 Volkswagen Passat

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

21 people viewed this question

Ask a Question

Usually answered in minutes!

Top Vauxhall Experts

Colin Stickland
Colin Stickland

Level 3 Expert

22095 Answers

yadayada
yadayada

Level 3 Expert

75005 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

14195 Answers

Are you a Vauxhall Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...