Question about 2001 Dodge Durango

2 Answers

My ac and heater only works in the high position, what is the problem?

Posted by on

Ad

2 Answers

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    Superstar:

    An expert that got 20 achievements.

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

  • Dodge Master
  • 2,019 Answers

Since high works, fan not likely.
Could be switch or resistors used at lower speeds. Check for power at the fan with a test light, and follow wires back.

Posted on Jul 24, 2009

Ad
  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    MVP:

    An expert that got 5 achievements.

    Governor:

    An expert whose answer got voted for 20 times.

    Hot-Shot:

    An expert who has answered 20 questions.

  • Expert
  • 39 Answers

SOUNDS LIKE A BAD BLOWER RESISTOR

Posted on Jul 24, 2009

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

  • 3 Answers

SOURCE: The heater/defroster/ac switch

Sounds like a card located under dash behind your blower motor, on passenger side.When card starts going bad you will only have off and high (for awhile), then none. change the card, this thing controls your speeds on the motor at your control on dash. I have a 2002 Dakota had same problem... but keep in mind not all Dakotas have this card.

Posted on Dec 06, 2008

motor1258
  • 6674 Answers

SOURCE: Heater/AC switch only working on high

Change blower resistor.

Posted on Jun 04, 2009

  • 11 Answers

SOURCE: Heater blower switch only works in postions 3 and 4

Heat limiting capacitor is blown on low side. Limits excessive heat to components. Three capacitors on one board. One is constant. One runs two lower speeds and other runs two higher speeds. Need to replace. Follow wire from blower motor back towards center of vehicle. The capacitor is approx. 1.5" X 2.5" and is mounted with two screws. Simply remove plug and two screws, pull out capacitor. Replace with new in reverse order. Did last year. Part was relatively cheap and easy to replace. You do have to be somewhat limber to fingers and tools under there.
Good luck.

Posted on Oct 02, 2009

  • 73 Answers

SOURCE: Heater/AC blower works on high only

Blower housing resistor fried up.You will have to replace whole blower assembly.

Posted on Jan 04, 2010

  • 1 Answer

SOURCE: heater fan only works on the high position?

There is a plug up under the glove box that loosens and you need to snug it up.

Posted on Feb 04, 2010

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

2004 Chrysler pacifica AC/HEATER continuously blows with power button in off position


sounds like a blower motor resistor or bad relay. Blower motor resistor is so you don't burn up the blower motor.

Aug 05, 2016 | Cars & Trucks

1 Answer

2000 ford taurus heater not working. What can be wrong?


It sounds very much like the heater control door (inside the heater box) is sticking in one position or the other. It's intended to direct air through either the AC's evaporator or the heater core, depending upon whether you want heat or cooling.

Assuming (highly likely) that the control door is vacuum-operated, you may have a vacuum leak anywhere from the engine to the heater box inside the passenger compartment, via the heater control unit.

Nov 18, 2014 | 2000 Ford Taurus

1 Answer

AC Fan Ford Taurus 1997.


there is a resistor on the heater motor needs replace

Apr 21, 2010 | 1997 Ford Taurus

1 Answer

Heater/AC blower works on high only


Blower housing resistor fried up.You will have to replace whole blower assembly.

Jan 04, 2010 | 2002 Chevrolet Impala

3 Answers

1996 nissan sentra ac/heater switch works only on high. need help


I had the same prblem. There is a relay next to the heater blower that needs to be replaced.

Apr 09, 2009 | 1996 Nissan Sentra

2 Answers

The heater/defroster/ac control switch only works in the high position.


You probably have a bad blower resistor. it's located next to the blower motor under the dash.

Nov 26, 2008 | 2004 Dodge Dakota

Not finding what you are looking for?
2001 Dodge Durango Logo

254 people viewed this question

Ask a Question

Usually answered in minutes!

Top Dodge Experts

yadayada
yadayada

Level 3 Expert

76846 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22246 Answers

Ronny Bennett Sr.
Ronny Bennett Sr.

Level 3 Expert

6924 Answers

Are you a Dodge Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...