Question about Cars & Trucks

1 Answer

I have no power to my ignition or my dash and can't find the fues to fix the problem because there no diagram for the fues box

Posted by on


1 Answer

  • Level 3:

    An expert who has achieved level 3 by getting 1000 points


    An expert that got 20 achievements.


    An expert that got 10 achievements.


    An expert that got 5 achievements.

  • Cars & Trucks Master
  • 4,723 Answers

Is this still 2000 mitsu eclipse? Check fusible link 8--30 amp. If not the same vehicle, I need year--make--model?
I have no power to my ignition or my dash and can' - fusible link 8-mjson0k3fklv4nrxwvfsyjec-3-0.jpg

Posted on Apr 22, 2017


1 Suggested Answer

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi there,
Save hours of searching online or wasting money on unnecessary repairs by talking to a 6YA Expert who can help you resolve this issue over the phone in a minute or two.

Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.

Here's a link to this great service

Good luck!

Posted on Jan 02, 2017


Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

Whitch fues is for tail lights

Should say on diagram in fuse box under hood or on side of dash

May 09, 2016 | 2009 Chevrolet HHR

1 Answer

Which fuse do I need to change for electric seats and door locks in my 2003 mercury mountaineer

i have bad news for you the seats and door looks do not chair a common fuse.

power door locks, 4 fues in this system

in the under hood fuse box fuse # 16 15amp, fuse # 2 30 amp, fuse # 22 20 amp
in side fuse box behing left side of the dash fuse # 20 5 amp.

power seats

in side fuse box behind left side of dash fuse #1 30 amp, fuse # 2 30 amp.

Jul 29, 2011 | Mercury Mountaineer Cars & Trucks

1 Answer

2002 grand am wont start service engin light flickered fuel gauge went to empty and the power locks wont lock all at once. replaced fuel pump

under hood has fues box black box passenger side under cover tells what fuses are .There are three fues panels on this car 1 driver side on side of dash,2 inside glove box and 3 is out under hood.I would check you fuel relay switch.if its not it then check ecm electronic control module .you can check this with an ohms meter or smell it see if it smells burnt .good luck

Jun 11, 2011 | Pontiac Grand Am Cars & Trucks

1 Answer

Mass air and volume air low imput circutbank a1. changed mass air sensor and air filter. And the 10amp fuse for engin that controls the tak keeps blowing. where is the short.

Hopefully it will be in the circuit itself, try this install the fues with the MAF disconnected does the scan tool say high input,(how did you know it was low input),dont start it it does the scan tool show 5vlt ? Either of this way you have a grounded wire from power distirbution that goes to the MAF this wire is from power the distribution box or (engine fuse box goes that goes to MAF and is grounded . This is why you Ignition fuse blows to option fix and find this short or have someone who know how and is qualified to subsituted for another wire from Ignition to MAF ignition circuit at the power juction box (engine fuse box)

May 03, 2011 | Oldsmobile Bravada Cars & Trucks

1 Answer

What is the fuse box layout for 1998 nissan pulsar need to change a fuse but layout is all in Japanese dont know which fuse to look for . both front park lights are not working so wanted to check the...

Hi,if you know where the fues box is your half way there.
just buy a electricle screwdriver that has a light inside it with a wire that has got a crockerdile clip on the end,
put the cockerdile clip on a earth the body of the car,
then look at the fues on the top of the fues there is two little bits of metal these are where you will put the screwdriver blade to,
if yoy put the ignition on then go back to the fuesestuch one side of the fues on the little bit of metal the screwdriver should light,This is the power side,now if you tuch the screwdriver on the other bit of metal the light should come on again,if it dose the fues is ok,
if not the fues is falty(replace fues)do this to all the fueses and you will find the fues that is falty.
all the best.

Mar 20, 2011 | Nissan Pulsar Cars & Trucks

2 Answers

Fues box info for a chevy astro 1999

There are 3 fuse boxes located on a 1996 Astro Conversion.

1) Under Dash 2) Under Hood 3) In Rear Side Panel [Drivers side] just behind Rear Captains Chair

4) Fourth exists on a Hi-Top Coversion inside upper doors next to Dvd/Vcr/Tv compartments

Hope this helps.

Jan 18, 2011 | 1999 Chevrolet Astro

2 Answers

2001 ford f350 fuse diagram

2001 ford f350, there are two fuse boxes, one ine cab under the dash and another one in the engine compartment, on driverside near firewall, heres the diagrams and fues locations for both hope this is helpful, also this is for gas motor not diesel.db6ccd1.gif2712f28.gif8a05453.giff2890bd.gif74d279a.gif

Sep 13, 2010 | Ford F-350 Super Duty Cars & Trucks

1 Answer

Car will not start it has a new battery and key is good . i was told the car thinks it is stolen and the ignition is shut down.

I have never heard that theory before. Do the dash lights or any power come on at all? Lets check the ignition fuse first. Under the dash to your left or right should be a fuse box. Look at the diagram on the box cover or under the cover. Find the one that says ignition. If you do not have the diagram then you will need to check every fuse one at a time being sure to replace them back to there own spot. If you run across a burnt fuse then don't stop there. replace that one with the same amp fuse that came out of it. Some fuse boxes came with extra fuses in it. Have a look and see if you get lucky. You will know the fuse is bad if the little wire inside is melted in two. After replacing that fuse then go to the next one. When one fuse goes there are times when the domino effect happens and two maybe 3 others go as well. Not always but lets be sure. After you have been through all of the fuses there with no luck then lets check under the hood. The fuses are usually located in a seal box towards the back and on top of the wheel well some where. Pop the lid up and check them out. They will be bigger fues and most of the time will have clear windows to look through. There may be a diagram on the cover on the outside top as well. You should also see one that says ignition.
Ok after you have done all of this annoying troublesome labor see if it starts. If not we are going to try one last thing. reset the computer. Please remember I am trying to help you and I am not positive on what has happened here. So bare with me. All of this is benificial mantenance anyways.
Let me know if we fixed it or not and I will continue with the last test of computer reset. Good Luck, Raz

Apr 17, 2010 | 1992 Cadillac DeVille

1 Answer

Dash not working

try fuse # 26 I'm sure you have already checked the dimmer settings.

Apr 25, 2009 | 1996 Lincoln Continental

1 Answer

Is there a fuse for the 12volt power supplies? If there is which one is it.

i have the same truck there is 2 fues boxes on it 1 open the driver door and its on the side of the dash 2 is under the hood on the driver side behond the battery both covers have a diagram but i believe its in the box on side of dash

Apr 22, 2009 | 2000 Dodge Durango

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

11 people viewed this question

Ask a Question

Usually answered in minutes!

Top Cars & Trucks Experts


Level 3 Expert

79851 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22326 Answers

john h

Level 3 Expert

14331 Answers

Are you a Car and Truck Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides