Question about 1993 Chevrolet S-10 Blazer

3 Answers

No Fuel to motor

Truck was running fine and now not getting fuel to the motor! ive tried listening for the whirr of the electronic fuel pump but no sound! ive changed out the fuel pump relay and that hasnt worked! is my problem the Fuel pump itself or could it come down to the wiring inbetween point A and point B

Posted by on

  • 1 more comment 
  • Chris Jul 24, 2009

    How do i check that?

  • Chris Jul 24, 2009

    and ive check the ECMB fuse and the ECM 1 fuse all is good there

  • Chris Jul 24, 2009

    Id still have to drop the tank to test the power supply am i right?

×

Ad

3 Answers

  • Level 1:

    An expert who has achieved level 1.

    Hot-Shot:

    An expert who has answered 20 questions.

    Corporal:

    An expert that has over 10 points.

    Mayor:

    An expert whose answer got voted for 2 times.

  • Contributor
  • 21 Answers

If you changed the fuel pump you might wanna get a multimeter and check to see if there is 12v going to it, thats where i would start, check the fuse and make sure it didnt pop, if it did and you put a new one in and that one pops your looking at a shorted system

Posted on Jul 24, 2009

Ad
  • Level 2:

    An expert who has achieved level 2 by getting 100 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    Sergeant:

    An expert that has over 500 points.

  • Expert
  • 202 Answers

It also has a fuse. Have u checked for 12vdc supply at the fuel pump. U will only get this supply when the engine is cranked

Posted on Jul 24, 2009

Ad
  • Level 3:

    An expert who has achieved level 3 by getting 1000 points

    All-Star:

    An expert that got 10 achievements.

    MVP:

    An expert that got 5 achievements.

    President:

    An expert whose answer got voted for 500 times.

  • Master
  • 1,486 Answers

Nine out of ten its the pump that needs replacing.You can check the pump yourself by running wires from the batery to the pump.

Posted on Jul 24, 2009

1 Suggested Answer

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
New users get 2 Free calls (no credit card required) and instant help on almost anything you can think of (from cars to computers, appliances, handyman, and even pets).
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Ive got a 1995 toyota 4runner. PROBLEM: SPERATICALLY CUTS OFF WHILE DRIVING GIVING NO SIGN.Seems like ive got something getting hot nd killing the motor, after the truck sits for a little while whatever it...


replce temp sensors one by one and reset comp by disconnect battery and leave ignition in the on position for at least 30 mins the replace battery leads

Feb 28, 2014 | Toyota 4Runner Cars & Trucks

2 Answers

No fuel up to injecter pump truck just stalled


Did you check for fuel pressure on the line from the tank while you had the filter off? Do you hear your fuel pump prime when you turn the ignition on? First I would listen for the hum of the fuel pump when you turn the key to the run position (not starting the engine) May have to get a helper and listen at the gas filler neck with the cap off. If you dont hear your fuel pump, check your fuses and relays. If the relay clicks when your helper turns the key on ( put your finger on the relay and ear down close to feel/hear the relay actuate)., and fuse is good, yet you do not hear the pump prime, I would say your fuel pump is shot.

If it is a diesel,check for fuel pressure coming off the direct drive pump hose while cranking the motor.

Mike

Jun 14, 2011 | 1994 Dodge Ram 3500

1 Answer

I ram out of gas now my 1998 ford taurus wont start


It's quite possible you burned out the fuel pump. The fuel pump relies on a constant flow of gasoline to cool it. Unfortunately, you have to drop the tank to access the fuel pump, but is a fairly easy fix for an avid do-it-youselfer. Before you go to that length, though, try having someone stand by rear of the car and listen for the "whirr" of the fuel pump when you turn the key to the "RUN" position. (not "START", just "RUN") If they can hear the pump, try turning the key off and on about 5 times to re-pressurize the fuel system before attempting to start the engine. Hope this helps a little and your problem is not too severe. Best of luck!

May 24, 2011 | 1998 Ford Taurus

1 Answer

Hello My name is Peter Kwon I have 06 ford low cab forward 4.5l diesel truck that truck towed in( no start) customer complants: Engine run getting strange and got worse after the oil changed and...


SOUND LIKE FUEL PROBLEMS.CHECK TO SEE IF FUEL PUMP IN MODULE IS RUNNING.IF NOT CHECK FUEL PUMP FUSE OR RELAY.IFALL IS GOOD CHECK FUEL PUMP ELECTRICAL WIRES CONNECTIONS MAKE SURE THEY ARE TIGHT IF ALL IS GOOD.FUEL PUMP BAD.IF FUEL PUMP IS WORKING.PROBLEM COULD BE STOPPED UP FUEL FILTER. OR PROBLEM IN THE FUEL INJECTOR CONTROL MODULE OR MECHANICAL FAILURE IN THE HIGH PRESSURE OIL PUMP.

Jul 12, 2010 | Ford F Cars & Trucks

1 Answer

2000 1500 Sierra will not stay running step on gas act like its running out of gas. Popped top fuel line gas came poured outbut didn't pump out when i rolled the engine over. Got underneath the fuel cell...


Replace the fuel pump and fuel filter to correct the problem you are having. Without the proper fuel pressure the engine will not run at all. Hope this will help you. You might check the fuse/relay panel for a blown fuse or relay in it to make sure you are getting power to fuel pump before you go to the trouble of removing the pump and fuel filter. Hope this will help you.

May 20, 2010 | Cars & Trucks

3 Answers

1996 GMC Suburban - Quit Running While Driving, Will Not Start


Listen at the back by the fuel tank for a 1 to 2 second prime cycle whirr from the tank when turning the key to run position after it has been off for at least 10 seconds.
No noise means no running pump.
....and no noise means.....
Most likely it will need a new fuel pump....80%
Fuel pump relay 10%
Fuse or bad wiring 10%

The quick fix to get home is to crank the truck to create oil pressure to fire the pump......and while cranking WHACK the tank hard with a 2by4 or something like that....to jar the pump..... and it may start running long enough to get it somewhere to be repaired.
This works 60% of the time on a dead pump.

If you do hear a whirrr.....you most likely need a ignition module or crank or dist pickup.

Sep 27, 2009 | 1996 GMC Suburban

2 Answers

1992 dodge dakota run fine turned it off an went to start it an now it acts like it is not getting any fuel i put some fuel in the carb to prim it it started but then died i tried this 4 more times with...


Yep, sounds like your not getting fuel alright. Next time that you try to start it try and listen for the fuel pump running( you may need to get someone to listen out side the truck for you) If its not running take something like a rubber mallet, my prefered choice, and give the tank a few good whacks, this will some times get you going. If this does the trick, you will definatly need a new fuel pump. If this still doesn't get you going, it "could" be the fuel pump. The other areas to check would be the fuel pump relay and also the ignition module, can't rember though if this year still used module or just computer GL

Sep 03, 2009 | 1992 Dodge Dakota

2 Answers

1999 Suburban turns over but engine doesn't start...


First, make sure they put oil back in the crankcase. Your motor may be seized. Next, we need to know if the fuel filter has ever been changed. If not, it's probably clogged and it will burn up the fuel pump if you continue to try to force gas into the injectors.

Aug 01, 2009 | 1999 GMC Suburban

1 Answer

My trucks starts but keep quiting


I see you say that you have a new fuel filter but did you try replacing the fuel pump??? If not you can check the fuel pump simply by turning the key to the ACC position (thats as far as you can turn the key WITHOUT starting the truck) listen by where you pump the gas in and try to hear a low sounding whine if you cant hear it then it could be your fuel pump is dead and needs a new one....or it might be going dead.

Mar 29, 2009 | 1996 GMC Sierra

1 Answer

Ran out of gas..now wont start.


First i would listen to hear if the fuel pump is running!! It will sound like it is whinning back by the fuel hole in the side of the truck! Good possiblity that you burnt the fuel pump up in the truck!! I would try and go to the fuel filer if you dont see anything wrong with the pump! If the filter has been changed and still not crankin up then i would remove the fuel line ( may require special tool) and see if you are getting fuel to the motor!!

Oct 23, 2008 | 2004 GMC Sierra Denali

Not finding what you are looking for?
1993 Chevrolet S-10 Blazer Logo

Related Topics:

107 people viewed this question

Ask a Question

Usually answered in minutes!

Top Chevrolet Experts

yadayada
yadayada

Level 3 Expert

76649 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22219 Answers

Jeff Turcotte
Jeff Turcotte

Level 3 Expert

8518 Answers

Are you a Chevrolet Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...