Question about Ford Cars & Trucks

1 Answer

Which fuse controls the rear defrost on my 2011 ford fusion

Posted by on


1 Answer

  • Level 2:

    An expert who has achieved level 2 by getting 100 points


    An expert that got 10 achievements.


    An expert that got 5 achievements.


    An expert that has over 500 points.

  • Expert
  • 244 Answers

Look for the Owner's Manual in the glove box or online. The Fuse block will be shown, and that fuse will probably be identified. Likely 20a, 25a or 30a.

Posted on Apr 22, 2017


1 Suggested Answer

  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.

Posted on Jan 02, 2017


Add Your Answer

Uploading: 0%


Complete. Click "Add" to insert your video. Add



Related Questions:

1 Answer

I have a 2011 for fusion sel.I would turn the heat on and nothing let it on and it would come on by it self or if I hit a bumb. But now I turn the heat on and nothing

Click on the link.
Your saying the blower motor won't work? I can help with testing, but, you have to do the testing.
I looked at info for automatic hvac, see those two fuses, not only check the fuse, use a test light and check fuse circuit for voltage. As you can see, one fuse is hot all the time, the other fuse goes hot with the key on. See the relay, if you use a jumper wire on load side of relay, terminal 30 and 87, you can bypass the control side of relay.
Any hvac trouble codes? Could be loose wire, loose wiring connector or faulty blower motor brushes. There is a speed control module, also.

Apr 12, 2017 | 2011 Ford Fusion SEL

1 Answer

Where is the fuse located on a 2011 ford fusion for the windshield wipers

They are usually under dash drivers side or under the hood drivers side. There should also be a relay as well. That to should be under hood drivers side. If your wipers are not working, check both. To check a relay without a meter, change the wiper relay with another one with same number and see if wipers work.

Mar 24, 2016 | 2011 Ford Fusion

3 Answers

2009 fusion SEL has data compass error after being rear ended and a shop did repair.

Feb 21, 2013 - WHAT IS A COMPASS ERROR FOR A 2009 FORD FUSION A MESSAGE COMES UP ON MY DASH SAYS COMPASS NO ... SOURCE: I HAVE A2009 FORD FUSION AND IT'S NOT GOING OVER 20 MPH ... Compass data error -- how do i determine my zone-- ... Jan 28, 2010 ' 2007 Ford Edge SEL Plus.

Compass - Ford Fusion Sport - Ford Fusion Forum
Jan 23, 2013 - Compass - posted in Ford Fusion Sport: 2011 Fusion SEL without navigation screen. Following windshield ... I have recalibrated and reset the compassaccording to the manual instructions (several times) but cannot correct the error. Can anyone help? ... picture of where it is: 2009-08-30_051718_2.gif.

Nov 08, 2015 | 2009 Ford Fusion

2 Answers

Which fuse number is it for the power auxiliary plug ( aka lighter ) in a 2011 ford fusion

The fuses for the power points (as they are labeled in the manual) are located in the power distribution box under the hood, fuses 22 and 29 (20A each). See the attached pic (I highlighted the fuse locations).

Jan 03, 2015 | 2011 Ford Fusion

1 Answer

My heat doesn't work not blowing or anything defrost comes out slowly

being a 2011, most likely a blower resistor. Could be a blower also. It has to be checked for electricity and ground.

Nov 13, 2014 | 2011 Ford Fusion

1 Answer

Why doesnt my fuel gauge work on my 2011 ford

check for blown fuse and if fuse is good you will have to replace the sensor whick is in the unit with the fuel pump (it is all one unit and will have to replaced as such

Sep 01, 2014 | 2011 Ford Fusion

1 Answer

Ford fusion radio code

I had the same problem. jumped the battery and then the radio didn't work, just said "ford fusion" on the display. you need to locate the fuse box down by the brake pedal to the left, very difficult to get at. once you find it remove the plastic cover and then remove the radio fuse (look in your owners manual for the fuse number and location). using a needle nose pliers works the best. once you remove the radio fuse look at it, the small metal wire inside should be broken. replace it with an identical fuse. my fuse box had spare fuse slots with same color and number on them so I just used one of those.

May 03, 2014 | 2011 Ford Fusion

1 Answer

Which fuse is the trunk light fuse on a 2010 Ford Fusion?

look in owners manual for fuseblock diagram

Feb 27, 2011 | 2011 Ford Fusion

Not finding what you are looking for?
Cars & Trucks Logo

Related Topics:

76 people viewed this question

Ask a Question

Usually answered in minutes!

Top Ford Experts


Level 3 Expert

76846 Answers

Colin Stickland
Colin Stickland

Level 3 Expert

22246 Answers


Level 3 Expert

5546 Answers

Are you a Ford Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides