Question about Cars & Trucks
a 6ya expert can help you resolve that issue over the phone in a minute or two.
best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of (from cars to computers, handyman, and even drones).
click here to download the app (for users in the US for now) and get all the help you need.
Posted on Jan 02, 2017
SOURCE: alarm wont let me start the car
you need the remote control of the alarm to turn the alarm off.
you may need to change the battery of the remote in case it would no longer control the alarm or if you have a valet switch to turn off the alarm, then use it.
the immobilizer is working that is why you can not start the car.
tnx 4 using fixya,
Posted on Sep 13, 2008
The Chrysler factory VTSS vehicle theft security system will do just that. Try unlocking the vehicle with the remote or one of the three VTSS switches, both front doors or the rear hatch. Sometimes the door switches get damaged front "Slim Jimming" the lock. The rear hatch switch is usually intact. The VTSS should "Arm" after a battery disconnect or dead battery. The VTSS cannot be bypassed once it is activated. If you put a previously installed ECM that was on a vehicle with VTSS, on a vehicle without VTSS the vehicle will not run.
Posted on Apr 01, 2009
System arms 5 seconds after switching ignition OFF. Switch ignition ON. Ensure clock LED illuminates for 3-5 seconds. If LED flashes rapidly at regular intervals for approximately 1 minute, then flashes at irregular intervals: Key code not recognised. Remove key and try again.
System malfunction: LED illuminates for 1 minute, then flashes at irregular intervals. Key(s) added or replaced.
NOTE: Replacement keys MUST have blue mark. Keys with red mark are NOT compatible with this system.
NOTE: Programming method using vehicle keys can be deactivated using diagnostic equipment.
Obtain 2 programmed keys (A and B). Insert key A into ignition switch. Turn ignition switch to position II. Wait 1 second. Switch ignition OFF. Remove key A. Insert key B into ignition switch within 5 seconds. Turn ignition switch to position II. Wait 1 second. Switch ignition OFF. Remove key B. Within 10 seconds: Insert key to be programmed into ignition switch. Turn ignition switch to position II. Wait 4 seconds. Switch ignition OFF. Wait 5 seconds. Start engine. If engine does not start and clock LED flashes: Switch ignition ON. Wait at least 20 seconds. Switch ignition OFF. Repeat programming procedure. Repeat above procedure to program remaining keys. Keys can also be programmed using diagnostic equipment
Posted on Mar 08, 2010
Tips for a great answer:
Mar 29, 2015 | 2002 Dodge Grand Caravan
Jan 04, 2015 | 2004 Buick Park Avenue
May 25, 2014 | Ford Five Hundred Cars & Trucks
Apr 18, 2013 | 1998 Nissan Maxima
Jul 02, 2012 | 1993 Pontiac Bonneville
Feb 25, 2010 | 1998 Ford Windstar
Feb 04, 2010 | 1996 Jeep Grand Cherokee
Aug 24, 2009 | 1996 Volkswagen Jetta
Mar 27, 2009 | 1995 Jeep Grand Cherokee
22 people viewed this question
Usually answered in minutes!