Question about Toyota Cars & Trucks

Open Question

Hi, my father inlaw has an 08 Toyota Kruger. We had the left side front kick pannel off and the side scuff plates both front and back to run a cable along the side. Now getting a SRS fault.

We also had the glove box and back pannel for the glove box out as we were fitting a UHF into the vehicle and needed to run a wire into the cab through the fire wall.

Posted by on

Ad

6 Suggested Answers

6ya6ya
  • 2 Answers

SOURCE: I have freestanding Series 8 dishwasher. Lately during the filling cycle water hammer is occurring. How can this be resolved

Hi,
a 6ya expert can help you resolve that issue over the phone in a minute or two.
Best thing about this new service is that you are never placed on hold and get to talk to real repairmen in the US.
the service is completely free and covers almost anything you can think of.(from cars to computers, handyman, and even drones)
click here to download the app (for users in the US for now) and get all the help you need.
Goodluck!

Posted on Jan 02, 2017

Ad
  • 158 Answers

SOURCE: 04 lancer no start,no spark or injector pulse.

it sound to me like the modual has fried it self in the distributor if it has you will have no spark or fuel pulse . have you checked the ignition fuses

Posted on Mar 24, 2009

Ad
cadman000
  • 607 Answers

SOURCE: 1992 Cadillac Coupe Deville blower fan runs all the time

The BLOWER MODULE is located on the A/C EVAPORATOR housing located UNDER THE HOOD passenger side firewall. Has 2 electrical connectors. Mounted with 4 screw bolts.Hope this helps

Posted on May 21, 2009

  • 3 Answers

SOURCE: Wet floor on driver side only; Prevelant after heavy rain

I had a similar problem, water running off windshield down drain hole only came in when parked with front lower than rear. A hole used to route a wire to engine compartment from driver side through rear of fender allowed water to come in. Remove rear fender liner fastners from left front fender pull liner away without fully removing it and look for hole leading into cabin. Plug it with deaft sealer.
My 2001 had a wire for an alarm system routed through hole, but dealer who sold me car as used felt he could not leave an non factory alrm system in place DUH!
Ken

Posted on Jul 11, 2009

ZJLimited
  • 17970 Answers

SOURCE: i need a diagram of the fuse box under the hood,

You tell us Jeep Cherokee (Laredo), in a Grand Cherokee subforum? I confussed.

If this is a Cherokee, review the Repair Manual XJ Cherokee

If this is Grand Cherokee, review ths Repair Manual ZJ-Secc-8W-Wiring-Diagrams (page 7, 9 and 10 for location, details and description). The diagramas can find it in the next pages.

I hope help yuo with this (remember rated this help). Good luck.

Posted on Oct 16, 2009

SOURCE: How do I remove the glove box? I have removed 2

After removing the three screws, the glove box is held with two clips - one on each side. The clips will come undone when you pull on the glove box with a little force. You will then need to unplug the switch/lamp connector.

Posted on Nov 27, 2009

Add Your Answer

Uploading: 0%

my-video-file.mp4

Complete. Click "Add" to insert your video. Add

×

Loading...
Loading...

Related Questions:

1 Answer

Wireing diagram oricom uhf 088


Oricom UHF088 Questions & Answers - ProductReview.com ...

www.productreview.com.au > ... > Oricom > Oricom UHF088
Ask a question about Oricom UHF088 in UHF Radios. ... need a DC regulated power supply, you can pick one up from stores like from Supercheap Auto, Dick Smith or JayCar. ... I am after the wiring diagram for the uhf088 hand piece please?Missing: trucks

UHF088 UHF 5 Watt 2- Way CB Radio (in vehicle) - Oricom

www.oricom.com.au/uhf088-uhf-5watt-cb-radio-in-vehicle.html

Dec 29, 2015 | Cars & Trucks

1 Answer

How do I fix a turn signal that is not working?


if it works sometimes,then probably it's a ground problem ,check both left and right kick panels ,the main grounds are located there ,remove scuff plates and kick panels on both front next to seats.Make sure the green 8 mm bolt is tight.

Oct 05, 2014 | 1999 Ford Expedition

2 Answers

Toyota avalon xls 99


if you have checked all your fuses try tracing the wiring back to fuse box last time i had this problem it was in the wiring just out of the fuse box

Jul 24, 2012 | 1999 Toyota Avalon

1 Answer

Rear panel for a mitsibishi montero speacker removel


1Lift the rear seat all the way up and towards the front of the vehicle.
  • 2Remove the five Phillips screws holding the scuff plate at the rear opening of the vehicle. Remove the scuff plate.
  • 3Use a panel tool to pry off two screw covers on the edge of the headliner in the cargo area. Remove the Phillips screws located behind each of the covers.
  • 4Pull the carpet away from the edges of the rear-side panel. Remove four Phillips screws located below the carpet at the bottom of the rear-side panel. Remove the two Phillips screws holding the cargo cover hooks located on the rear-side panel.
  • 5Pry around the bottom and back edges of the rear-side panel and pull the panel out far enough to access the speaker.
  • 6Remove four Phillips screws from the edge of the speaker with a Phillips screwdriver. Pull the speaker out of the door and unplug the wiring harness connected to the back.
  • Nov 12, 2011 | 1995 Mitsubishi Montero

    1 Answer

    Where is the fuse box in the 1993 oldsmobile cutlass ciera s?


    one should be on the driver side under the dash near the steering colum/drivers kick pannel. there also be a second one near the glove box or right under the glove box near the passanger side kick pannel . you may have to remove some bolts on both side and drop the lower pannes to see the fuse box

    Mar 06, 2011 | Oldsmobile Cutlass Ciera Cars & Trucks

    1 Answer

    Need to know where ths cab air filter box is, so that I can clean out the box so that I can stop the rain water from getting into the glove box.


    if the vehicle is equipped for a cabin air filter ,,it is located inside under the right side of the dash you may have to remove the trim panel to gain access to it ... I have a 2002 f 250 and it was not equipped with a cabin air filter .but the dealer does offer a kit to install one .
    hope this helps

    Aug 27, 2010 | 2002 Ford F350 Super Duty DRW Reg. Cab

    1 Answer

    On a 1998 expedition, where is the pcm and the ecm--5.4 litre


    1998 Ford Truck Expedition 4WD 5.4L EFI 8cyl

    PCM Ford's Location:
    * Ranger - behind instrument panel (cowl), center to both driver and passenger sides.
    * Explorer/Mountaineer - behind instrument panel (cowl), (access from engine compartment dash panel) on passenger side to center of vehicle.
    * All other F-Series, Expedition/Navigator - lower dash panel on passenger side.
    * Excursion - lower dash panel on driver side.

    The PCM is behind the glove box and has a big harness connector in the firewall that you access from the engine compartment.

    REMOVAL & INSTALLATION

    a927c58.jpg

    Fig. 1 The calibration number will be needed to order such parts as a replacement PCM, various sensors, and almost any emission control component. Typically this number is attached to a label found on the driver's door or the door pillar


    1997-00 F-150, F-250, Expedition and Navigator

    00a02b5.jpg

    Fig. 2 Loosen the connector retaining bolt and remove the PCM connector

    2cda058.jpg

    Fig. 3 Remove the passenger side front door scuff plate

    1fe310f.jpg

    Fig. 4 Remove the passenger side kick panel

    234c3f5.jpg

    Fig. 5 Remove the PCM bracket clip and remove the PCM
    1. Remove the battery and the battery tray.
    2. Loosen the connector retaining bolt and remove the PCM connector.
    3. Remove the passenger side front door scuff plate.
    4. Remove the passenger side kick panel.
    5. Remove the PCM bracket clip.
    6. Remove the PCM.
    To install:
    1. Installation is the reverse of removal.
    2. Tighten the PCM connector retaining bolt to 36-44 inch lbs. (4-5 Nm).

    Hope helps.

    Jul 13, 2010 | Ford Expedition Cars & Trucks

    3 Answers

    Is there 3 fuse boxes on my 1990 toyota camry? and if so, where? i can only find two.


    pass kick pannel under hood and under dash are the only 3 places toy hides fuses

    Jan 22, 2010 | 1991 Toyota Camry

    1 Answer

    Location of fuse for electric windows


    behind the left hand side kick pannel thats the small piece by the brake pedal left side of pedal.

    Oct 26, 2009 | 1991 Toyota 4Runner

    Not finding what you are looking for?
    Cars & Trucks Logo

    Related Topics:

    17 people viewed this question

    Ask a Question

    Usually answered in minutes!

    Top Toyota Experts

    yadayada
    yadayada

    Level 3 Expert

    76846 Answers

    Colin Stickland
    Colin Stickland

    Level 3 Expert

    22246 Answers

    Jeffrey Turcotte
    Jeffrey Turcotte

    Level 3 Expert

    8572 Answers

    Are you a Toyota Expert? Answer questions, earn points and help others

    Answer questions

    Manuals & User Guides

    Loading...